Weak ferromagnetism and spin reorientation in antiferroelectric BiCrO3

BiCrO3 is an antiferroelectric perovskite known to exhibit an unconventional spin reorientation transition between antiferromagnetic structures, accompanied by a large jump in weak ferromagnetism. Using a combination of neutron powder diffraction, magnetometry, and symmetry analysis, we confirm the dominant G-type antiferromagnetic order below TN = 111 K and identify the magnetic phase transition with a spontaneous rotation of Cr3+ moments from the b axis to a particular direction in the ac plane. We demonstrate the role of antiferroelectric displacements produced by the Bi3+ lone-pair electrons and octahedral rotations in establishing spin canting via the antisymmetric Dzyaloshinskii-Moriya interaction. This mechanism results in weak ferromagnetism above and below the spin-reorientation and explains the dramatic increase in net magnetization on cooling

CHARM facility remotely controlled platform at CERN: A new fault-tolerant redundant architecture

Many power electronics applications require high tolerance to faults such as short circuit or open circuit of the control signals. One such application is the CERN High energy AcceleRator Mixed-field (CHARM) facility, where maintenance may be precluded for long periods of time due to radiation and, therefore, high reliability is necessary. A redundant interconnection architecture for the control signals is proposed, where each signal is individually processed by different CPUs and transmitted through separate interconnection lines. During normal operation, the CPUs are synchronized and produce the same signals. The purpose of the proposed hardware and firmware strategy is to allow the actuator to continue operating even in case of fault; regardless of the fault type (open circuit, short circuit to ground or to positive supply), a fault on one of the parallel lines would not inhibit the correct operation of the remaining line. This solution can be used to control the movements of a target system using a remote joystick in a safe environment. The architecture features reliable transmission of PWM signals driving a half-bridge power converter. Moreover, it is possible to extend it to any type of converter such as three-phase bridges, three-level NPC, or buck-boost converters. Simulations and experimental results show a good agreement, proving the effectiveness of the proposed fault tolerant circuitry

Impact of phonons on dephasing of individual excitons in deterministic quantum dot microlenses

Optimized light-matter coupling in semiconductor nanostructures is a key to understand their optical properties and can be enabled by advanced fabrication techniques. Using in-situ electron beam lithography combined with a low-temperature cathodoluminescence imaging, we deterministically fabricate microlenses above selected InAs quantum dots (QDs) achieving their efficient coupling to the external light field. This enables to perform four-wave mixing micro-spectroscopy of single QD excitons, revealing the exciton population and coherence dynamics. We infer the temperature dependence of the dephasing in order to address the impact of phonons on the decoherence of confined excitons. The loss of the coherence over the first picoseconds is associated with the emission of a phonon wave packet, also governing the phonon background in photoluminescence (PL) spectra. Using theory based on the independent boson model, we consistently explain the initial coherence decay, the zero-phonon line fraction, and the lineshape of the phonon-assisted PL using realistic quantum dot geometries

Robust snubberless soft-switching power converter using SiC power MOSFETs and bespoke thermal design

A number of harsh-environment high-reliability applications are undergoing substantial electrification. The converters operating in such systems need to be designed to meet both stringent performance and reliability requirements. Semiconductor devices are central elements of power converters and key enablers of performance and reliability. This paper focuses on a DC–DC converter for novel avionic applications and considers both new semiconductor technologies and the application of design techniques to ensure, at the same time, that robustness is maximized and stress levels minimized. In this respect close attention is paid to the thermal management and an approach for the heatsink design aided by finite element modelling is shown

Correlation between OCVD carrier lifetime vs temperature measurements and reverse recovery behavior of the body diode of SiC power MOSFETs

The reverse recovery (RR) behavior of SiC MOSFET body diode is of great importance in power application, where these devices are used in a wide range of operating temperatures. The carrier lifetime in the drift region varies with temperature, and it heavily affects the tailoring of the RR current, opening reliability issues related to the RR voltage amplitude and to possible anomalous voltage oscillations during the recovery. From the users' point of view, it would be useful to have a simple technique able to give predictive information about the body diode RR behavior of commercial devices over the whole range of working temperatures. An experimental-simulation approach is presented in this paper to correlate the carrier lifetime measured by simple OCVD measurements versus temperature with the RR behavior of the body diode, that can be useful at the design stage of power converters. Simulations of the body diode reverse-recovery are performed for a wide range of carrier lifetimes. This allows to estimate the effect of changes of carrier lifetime with temperature on the body diode switching transients. Preliminary results obtained with a 1700 V/5A commercial MOSFET are shown

Synthesis and crystal structure of C2/c Ca(Co, Mg)Si2O6 pyroxenes : effect of the cationic substitution on the cell volume

A series of clinopyroxenes along the CaMgSi2O6-CaCoSi2O6 join was synthesized by quenching from melt at 1500\ub0C and subsequent annealing at 1250\ub0C (at 0.0001 GPa). This protocol proved to be the most effective to obtain homogenous, impurity free and stoichiometric pyroxenes as run products. Electron microprobe analyses in energy-dispersive mode were conducted and single-crystal X-ray diffraction data were collected on the Ca(CoxMg1-x)Si2O6 pyroxenes, with x = 0.2, 0.4, 0.5, 0.6; anisotropic structure refinements were performed. The effects of the cation substitution at the M1 site are described at the atomic level. The experimental findings of this study allowed us to extend the comparative analysis of the structural features of pyroxenes with divalent cations at the M1 and M2 sites

Dynamics of excitons in individual InAs quantum dots revealed in four-wave mixing spectroscopy

We acknowledge the support by the ERC Starting Grant PICSEN, contract no. 306387. D.E.R. is grateful for financial support from the DAAD within the P.R.I.M.E. program.A detailed understanding of the population and coherence dynamics in optically driven individual emitters in solids and their signatures in ultrafast nonlinear-optical signals is of prime importance for their applications in future quantum and optical technologies. In a combined experimental and theoretical study on exciton complexes in single semiconductor quantum dots we reveal a detailed picture of the dynamics employing three-beam polarization-resolved four-wave mixing (FWM) micro-spectroscopy. The oscillatory dynamics of the FWM signals in the exciton-biexciton system is governed by the fine-structure splitting and the biexciton binding energy in an excellent quantitative agreement between measurement and analytical description. The analysis of the excitation conditions exhibits a dependence of the dynamics on the specific choice of polarization configuration, pulse areas and temporal ordering of driving fields. The interplay between the transitions in the four-level exciton system leads to rich evolution of coherence and population. Using two-dimensional FWM spectroscopy we elucidate the exciton-biexciton coupling and identify neutral and charged exciton complexes in a single quantum dot. Our investigations thus clearly reveal that FWM spectroscopy is a powerful tool to characterize spectral and dynamical properties of single quantum structures.PostprintPostprintPeer reviewe

Prosodic tools for language learning

In this paper we will be concerned with the role played by prosody in language learning and by the speech technology already available as commercial product or as prototype, capable to cope with the task of helping language learner in improving their knowledge of a second language from the prosodic point of view. The paper has been divided into two separate sections: Section One, dealing with Rhythm and all related topics; Section Two dealing with Intonation. In the Introduction we will argue that the use of ASR (Automatic Speech Recognition) as Teaching Aid should be under-utilized and should be targeted to narrowly focussed spoken exercises, disallowing open-ended dialogues, in order to ensure consistency of evaluation. Eventually, we will support the conjoined use of ASR technology and prosodic tools to produce GOP useable for linguistically consistent and adequate feedback to the student. This will be illustrated by presenting State of the Art for both sections, with systems well documented in the scientific literature of the respective field. In order to discuss the scientific foundations of prosodic analysis we will present data related to English and Italian and make comparisons to clarify the issues at hand. In this context, we will also present the Prosodic Module of a courseware for computer-assisted foreign language learning called SLIM—an acronym for Multimedia Interactive Linguistic Software, developed at the University of Venice (Delmonte et al. in Convegno GFS-AIA, pp. 47–58, 1996a; Ed-Media 96, AACE, pp. 326–333, 1996b). The Prosodic Module has been created in order to deal with the problem of improving a student’s performance both in the perception and production of prosodic aspects of spoken language activities. It is composed of two different sets of Learning Activities, the first one dealing with phonetic and prosodic problems at word level and at syllable level; the second one dealing with prosodic aspects at phonological phrase and utterance suprasegmental level. The main goal of Prosodic Activities is to ensure consistent and pedagogically sound feedback to the student intending to improve his/her pronunciation in a foreign language