The relationships of trehalose and its metabolism to conidiation in Neurospora

Relationship of trehalose to conidiatio

Implications of an Elastic Analysis of In Situ Stress Measurements Near the San Andreas Fault

Twenty-nine measurements of in situ stress obtained with the hydraulic fracturing technique near Palmdale, California, are the basis of an elastic analysis of the state of stress in the Mojave Desert adjacent to the San Andreas fault. The measurements were made at depths extending from 80 to 849 m and at distances from the fault between 2 and 34 km. The elastic solution indicates a state of deviatoric stress typical for continents in that the inferred depth gradient of the maximum shear stress is about 7.9 MPa/km. Extrapolation yields an average shear stress in the upper 14 km of the crust of about 56 MPa, a result that is higher than estimates of the average shear stress on the San Andreas fault based on the analysis of heat flow data. This finding is consistent, however, with estimates offault strength based on laboratory determinations of the coefficient of friction for samples of San Andreas fault gouge if the regional state of deviatoric stress is limited by the strength of the fault zone. If so, then the coefficient of friction of the San Andreas fault zone inferred from the stress field results is about 0.45. The state of stress does not appear to vary systematically with distance from the San Andreas fault although considerable localized variation is observed. The observations suggest an upper bound of about 0.1 MPa/km for the horizontal gradient of the maximum shear stress in the direction perpendicular to the San Andreas fault, a result that implies a corresponding limit of about 1.4 MPa on the shear traction applied to the base of the seismogenic layer. Finally, we demonstrate the potential application of in situ stress data to the direct assessment of accumulated slip, which could be released in a large earthquake. We show that on the basis of a model involving a locked fault, extending to about 22 km, the total fault slip below the locked portion is less than 13 m. A more comprehensive set of stress data could permit the estimation of an even lower bound

Integrated Application of Active Controls (IAAC) technology to an advanced subsonic transport project: Current and advanced act control system definition study. Volume 2: Appendices

The current status of the Active Controls Technology (ACT) for the advanced subsonic transport project is investigated through analysis of the systems technical data. Control systems technologies under examination include computerized reliability analysis, pitch axis fly by wire actuator, flaperon actuation system design trade study, control law synthesis and analysis, flutter mode control and gust load alleviation analysis, and implementation of alternative ACT systems. Extensive analysis of the computer techniques involved in each system is included

Use of soil moisture information in yield models

There are no author-identified significant results in this report

Integrated Application of Active Controls (IAAC) technology to an advanced subsonic transpot project-demonstration act system definition

The 1985 ACT airplane is the Final Active Controls Technology (ACT) Airplane with the addition of three-axis fly by wire. Thus it retains all the efficiency features of the full ACT system plus the weight and cost savings accruing from deletion of the mechanical control system. The control system implements the full IAAC spectrum of active controls except flutter-mode control, judged essentially nonbeneficial, and incorporates new control surfaces called flaperons to make the most of wing-load alleviation. This redundant electronic system is conservatively designed to preserve the extreme reliability required of crucial short-period pitch augmentation, which provides more than half of the fuel savings

Hilltop Curvature Increases With the Square Root of Erosion Rate

This is the pre-peer reviewed version of the following article: Gabet, E. J., Mudd, S. M., Wood, R. W., Grieve, S. W. D., Binnie, S. A., & Dunai, T. J. (2021). Hilltop curvature increases with the square root of erosion rate. Journal of Geophysical Research: Earth Surface, 126, e2020JF005858. https://doi.org/10.1029/2020JF005858, which has been published in final form at https://doi.org/10.1029/2020JF005858. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Use of Self-Archived Versions

Distributed-Pair Programming can work well and is not just Distributed Pair-Programming

Background: Distributed Pair Programming can be performed via screensharing or via a distributed IDE. The latter offers the freedom of concurrent editing (which may be helpful or damaging) and has even more awareness deficits than screen sharing. Objective: Characterize how competent distributed pair programmers may handle this additional freedom and these additional awareness deficits and characterize the impacts on the pair programming process. Method: A revelatory case study, based on direct observation of a single, highly competent distributed pair of industrial software developers during a 3-day collaboration. We use recordings of these sessions and conceptualize the phenomena seen. Results: 1. Skilled pairs may bridge the awareness deficits without visible obstruction of the overall process. 2. Skilled pairs may use the additional editing freedom in a useful limited fashion, resulting in potentially better fluency of the process than local pair programming. Conclusion: When applied skillfully in an appropriate context, distributed-pair programming can (not will!) work at least as well as local pair programming

The Family Name as Socio-Cultural Feature and Genetic Metaphor: From Concepts to Methods

A recent workshop entitled The Family Name as Socio-Cultural Feature and Genetic Metaphor: From Concepts to Methods was held in Paris in December 2010, sponsored by the French National Centre for Scientific Research (CNRS) and by the journal Human Biology. This workshop was intended to foster a debate on questions related to the family names and to compare different multidisciplinary approaches involving geneticists, historians, geographers, sociologists and social anthropologists. This collective paper presents a collection of selected communications

What explains the uneven take-up of ISO 14001 at the global level?: a panel-data analysis

Since its release in the mid-1990s, close to 37 000 facilities have been certified to ISO 14001, the international voluntary standard for environmental management systems. Yet, despite claims that the standard can be readily adapted to very different corporate and geographic settings, its take-up has been highly geographically variable. This paper contributes to a growing body of work concerned with explaining the uneven diffusion of ISO 14001 at the global level. Drawing from the existing theoretical and empirical literature we develop a series of hypotheses about how various economic, market, and regulatory factors influence the national count of ISO 14001 certifications. These hypotheses are then tested using econometric estimation techniques with data for a panel of 142 developed and developing countries. We find that per capita ISO 14001 counts are positively correlated with income per capita, stock of foreign direct investment, exports of goods and services to Europe and Japan, and pressure from civil society. Conversely, productivity and levels of state intervention are negatively correlated. The paper finishes by offering a number of recommendations to policymakers concerned with accelerating the diffusion of voluntary environmental standards