120 research outputs found

    Room temperature magneto-optic effect in silicon light-emitting diodes

    Get PDF
    In weakly spin-orbit coupled materials, the spin-selective nature of recombination can give rise to large magnetic-field effects, for example on electro-luminescence from molecular semiconductors. While silicon has weak spin-orbit coupling, observing spin-dependent recombination through magneto-electroluminescence is challenging due to the inefficiency of emission due to silicon's indirect band-gap, and to the difficulty in separating spin-dependent phenomena from classical magneto-resistance effects. Here we overcome these challenges to measure magneto-electroluminescence in silicon light-emitting diodes fabricated via gas immersion laser doping. These devices allow us to achieve efficient emission while retaining a well-defined geometry thus suppressing classical magnetoresistance effects to a few percent. We find that electroluminescence can be enhanced by up to 300\% near room temperature in a seven Tesla magnetic field showing that the control of the spin degree of freedom can have a strong impact on the efficiency of silicon LEDs

    STEM analysis of deformation and B distribution in nanosecond laser ultra-doped Si1x_{1-x} Bx_x

    Full text link
    We report on the structural properties of highly B-doped silicon (> 2 at. %) realised by nanosecond laser doping. We investigate the crystalline quality, deformation and B distribution profile of the doped layer by STEM analysis followed by HAADF contrast studies and GPA, and compare the results to SIMS analyses and Hall measurements. When increasing the active B concentration above 4.3 at.%, the fully strained, perfectly crystalline, Si:B layer starts showing dislocations and stacking faults. These only disappear around 8 at.% when the Si:B layer is well accommodated to the substrate. When increasing B incorporation, we increasingly observe small precipitates, filaments with higher active B concentration and stacking faults. At the highest concentrations studied, large precipitates form, related to the decrease of active B concentration. The structural deformation, defect type and concentration, and active B distribution are connected to the initial increase and subsequent gradual loss of superconductivity

    Silicon Superconducting Quantum Interference Device

    Full text link
    We have studied a Superconducting Quantum Interference SQUID device made from a single layer thin film of superconducting silicon. The superconducting layer is obtained by heavily doping a silicon wafer with boron atoms using the Gas Immersion Laser Doping (GILD) technique. The SQUID device is composed of two nano-bridges (Dayem bridges) in a loop and shows magnetic flux modulation at low temperature and low magnetic field. The overall behavior shows very good agreement with numerical simulations based on the Ginzburg-Landau equations.Comment: Published in Applied Physics Letters (August 2015

    Subkelvin tunneling spectroscopy showing Bardeen-Cooper-Schrieffer superconductivity in heavily boron-doped silicon epilayers

    Full text link
    Scanning tunneling spectroscopies in the subKelvin temperature range were performed on superconducting Silicon epilayers doped with Boron in the atomic percent range. The resulting local differential conductance behaved as expected for a homogeneous superconductor, with an energy gap dispersion below +/- 10%. The spectral shape, the amplitude and temperature dependence of the superconductivity gap follow the BCS model, bringing further support to the hypothesis of a hole pairing mechanism mediated by phonons in the weak coupling limit.Comment: 4 pages, 3 figure

    Low temperature transition to a superconducting phase in boron-doped silicon films grown on (001)-oriented silicon wafers

    Full text link
    We report on a detailed analysis of the superconducting properties of boron-doped silicon films grown along the 001 direction by Gas Immersion Laser Doping. The doping concentration cB has been varied up to approx. 10 at.% by increasing the number of laser shots to 500. No superconductivity could be observed down to 40mK for doping level below 2.5 at.%. The critical temperature Tc then increased steeply to reach 0.6K for cB = 8 at%. No hysteresis was found for the transitions in magnetic field, which is characteristic of a type II superconductor. The corresponding upper critical field Hc2(0) was on the order of 1000 G, much smaller than the value previously reported by Bustarret et al. in Nature (London) 444, 465 (2006).Comment: 4 pages including 4 figures, submitted to PRB-Rapid Communicatio

    An integrated assay to probe endothelial glycocalyx-blood cell interactions under flow in mechanically and biochemically well-defined environments

    Get PDF
    Cell-cell and cell-glycocalyx interactions under flow are important for the behaviour of circulating cells in blood and lymphatic vessels. However, such interactions are not well understood due in part to a lack of tools to study them in defined environments. Here, we develop a versatile in vitro platform for the study of cell-glycocalyx interactions in well-defined physical and chemical settings under flow. Our approach is demonstrated with the interaction between hyaluronan (HA, a key component of the endothelial glycocalyx) and its cell receptor CD44. We generate HA brushes in situ within a microfluidic device, and demonstrate the tuning of their physical (thickness and softness) and chemical (density of CD44 binding sites) properties using characterisation with reflection interference contrast microscopy (RICM) and application of polymer theory. We highlight the interactions of HA brushes with CD44-displaying beads and cells under flow. Observations of CD44+ beads on a HA brush with RICM enabled the 3-dimensional trajectories to be generated, and revealed interactions in the form of stop and go phases with reduced rolling velocity and reduced distance between the bead and the HA brush, compared to uncoated beads. Combined RICM and bright-field microscopy of CD44+ AKR1 T-lymphocytes revealed complementary information about the dynamics of cell rolling and cell morphology, and highlighted the formation of tethers and slings, as they interacted with a HA brush under flow. This platform can readily incorporate more complex models of the glycocalyx, and should permit the study of how mechanical and biochemical factors are orchestrated to enable highly selective blood cell-vessel wall interactions under flow

    Ligand-Induced Anisotropy of the Two-Photon Luminescence of Spherical Gold Particles in Solution Unraveled at the Single Particle Level

    Get PDF
    Here we report on the visible luminescence properties of individual spherical gold particles in solution, obtained by two-photon excited fluorescence correlation spectroscopy and by an original dual Rayleigh-fluorescence method, correlating the Rayleigh scattering and the luminescence fluctuations of the same particle. The results demonstrate that the power needed to observe the two-photon excited visible luminescence depends on the illuminated particle and that the corresponding emission is anisotropic at low power. These observations combined with the evolution of the dynamics of the luminescence with respect to excitation power are interpreted by the presence of unique emissive surface states that are randomly switched off and on by the heat-induced movement of the molecular coating. These characteristics, which remain hidden in macroscopic experiments, have important implications with respect to the potential use of the particles as labels in two-photon imaging in aqueous samples

    Fluorescence correlation spectroscopy reveals strong fluorescence quenching of FITC adducts on PEGylated gold nanoparticles in water and the presence of fluorescent aggregates of desorbed thiolate ligands

    Get PDF
    Colloidal gold particles functionalised with oligoethylene-glycolated disulfide ligands and fluorescent moieties derived from fluorescein isothiocyanate (FITC) have been prepared and studied in aqueous suspension using fluorescence correlation spectroscopy (FCS). FCS probes the dynamics of the particles at the single object level, and reveals the desorption of fluorescent ligands which subsequently aggregate into larger (slower diffusing) objects. Cross-correlation spectroscopy of the FITC fluorescence and the Rayleigh-Mie scattering (RM-FCCS) of the gold cores shows that the only detectable fluorescent objects are free ligands and aggregates not associated with a gold particle. The fluorescence of bound fluorophores is quenched making their fluorescence too weak to be detected. FCS and RM-FCCS are useful tools for characterising functionalised noble metal particles in solution, under conditions similar to those used in optical bio-imaging. Desorption of thiolates from gold nanoparticles needs to be taken into account when working with these materials at low concentration

    The Superconducting Transition in Boron Doped Silicon Films

    Get PDF
    International audienceWe report on a detailed analysis of the superconducting properties of boron-doped silicon films grown along the 001 direction by gas immersion laser doping. This technique is proved to be a powerful technique to dope silicon in the alloying range 2-10 at.% where superconductivity occurs. The superconducting transitions are sharp and well defined both in resistivity and magnetic susceptibility. The variation of Tc on the boron concentration is in contradiction with a classical exponential dependence on superconducting parameters. Electrical measurements were performed in magnetic field on the sample with cB = 8 at.% (400 laser shots) which has the highest Tc (0.6 K). No hysteresis was found for the transitions in magnetic field, which is characteristic of a type-II superconductor. The corresponding upper critical field was on the order of 1000 G at low temperatures, much smaller than the value previously reported. The temperature dependence of Hc2 is very well reproduced by the linearized Gorkov equations neglecting spin effects in the very dirty limit. These measurements in magnetic field allow an estimation of the electronic mean-free path, the coherence length, and the London penetration depth within a simple two-band free electron model

    Thickness dependence of the superconducting critical temperature in heavily doped Si:B epilayers

    Get PDF
    International audienceWe report on the superconducting properties of a series of heavily doped Si:B epilayers grown by gas immersion laser doping with boron content (nB) ranging from ∼3 × 1020 cm−3 to ∼6 × 1021cm−3 and thickness (d) varying between ∼20 nm and ∼210 nm. We show that superconductivity is only observed for nB values exceeding a threshold value (nc,S ) which scales as nc,S ∝ 1/d. The critical temperature (Tc) then rapidly increases with nB, largely exceeding the theoretical values which can be estimated by introducing the electron-phonon coupling constant (λe-ph) deduced from ab initio calculations into the McMillan equation. Surprisingly Tc(nB,d) is fully determined by the boron dose (nB × d) and can be well approximated by a simple Tc(nB,d) ≈ Tc,0[1 − A/(nB.d)] law, with Tc,0 ∼ 750 mK and A ∼ 8(±1) × 1015 cm−2
    corecore