15 research outputs found

    On the Relationship Between the Optical Emission-Line and X-ray Luminosities in Seyfert 1 Galaxies

    Full text link
    We have explored the relationship between the [O III] λ\lambda5007 and the 2--10 keV luminosities for a sample of Broad- and Narrow-Line Seyfert 1 galaxies (BLSy1 and NLSy1, respectively). We find that both types of Seyferts span the same range in luminosity and possess similar [O III]/X-ray ratios. The NLSy1s are more luminous than BLSy1s, when normalized to their central black hole masses, which is attributed to higher mass accretion rates. However, we find no evidence for elevated [O III]/X-ray ratios in NLSy1s, which would have been expected if they had excess EUV continuum emission compared to BLSy1s. Also, other studies suggest that the gas in narrow-line regions (NLR) of NLSy1s and NLSy1s span a similar range in ionization, contrary to what is expected if those of the former are exposed to a stronger flux of EUV radiation. The simplest interpretation is that, like BLSy1s, a large EUV bump is not present in NLSy1s. However, we show that the [OIII]/X-ray ratio can be lowered as a result of absorption of the ionizing continuum by gas close to the central source, although there is no evidence that intrinsic line-of-sight absorption is more common among NLSy1s, as would be expected if there were a larger amount of circumnuclear gas. Other possible explanations include: 1) anisotropic emission of the ionizing radiation, 2) higher gas densities in the NLR of NLSy1s, resulting in lower average ionization, or 3) the presence of strong winds in the the nuclei of NLSy1s which may drive off much of the gas in the narrow-line region, resulting in lower cover fraction and weaker [O III] emission.Comment: 18 pages, including 3 figures, 2 tables. Accepted for publication in The Astrophysical Journa

    Analytical Determination of Allergenic Fragrances in Indoor Air

    No full text
    Among all the emerging contaminants, fragrances are gaining more relevance for their proven allergenic and, in some cases, endocrine-disrupting properties. To date, little information exists on their concentration in the air. This study aims to fill this gap by developing a method for the determination of semivolatile fragrances in the indoor gaseous phase with sampling protocols usually adopted for the collection of atmospheric particulate matter (sampling time 24 h, flow rate 10 L min−1) and instrumental analysis by gas chromatography coupled with mass spectrometry. The method was developed on 66 analytes and tested at three concentration levels: 20 compounds showed analytical recoveries ≥72% with percentage standard deviations always better than 20%. For most compounds, negligible sampling breakthroughs were observed. The method was then applied to real samples collected in a coffee bar and in a private house. Considering the fragrances for which the method has shown good effectiveness, the highest concentrations were observed for carvone in the coffee bar (349 ng m−3) and camphor in the house (157 ng m−3). As concerns certain or suspected endocrine disruptors, lilyal and galaxolide were detected at both sites, α-isomethylionone was the second most concentrated compound in the house (63.2 ng m−3), musk xylene and musk ketone were present at lower concentration (≈ 1 or 2 ng m−3)

    Analytical Determination of Allergenic Fragrances in Indoor Air

    No full text
    Among all the emerging contaminants, fragrances are gaining more relevance for their proven allergenic and, in some cases, endocrine-disrupting properties. To date, little information exists on their concentration in the air. This study aims to fill this gap by developing a method for the determination of semivolatile fragrances in the indoor gaseous phase with sampling protocols usually adopted for the collection of atmospheric particulate matter (sampling time 24 h, flow rate 10 L min−1) and instrumental analysis by gas chromatography coupled with mass spectrometry. The method was developed on 66 analytes and tested at three concentration levels: 20 compounds showed analytical recoveries ≄72% with percentage standard deviations always better than 20%. For most compounds, negligible sampling breakthroughs were observed. The method was then applied to real samples collected in a coffee bar and in a private house. Considering the fragrances for which the method has shown good effectiveness, the highest concentrations were observed for carvone in the coffee bar (349 ng m−3) and camphor in the house (157 ng m−3). As concerns certain or suspected endocrine disruptors, lilyal and galaxolide were detected at both sites, α-isomethylionone was the second most concentrated compound in the house (63.2 ng m−3), musk xylene and musk ketone were present at lower concentration (≈ 1 or 2 ng m−3)

    Low-Cost Benzene Toluene Xylene Measurement Gas System Based on the Mini Chromatographic Cartridge

    No full text
    Benzene, toluene and xylene (BTX) are an important part of the volatile organic compounds (VOCs) to be detected and monitored in the air, due to their toxicity towards human health. One of the most reliable technique used in BTX detection is gas chromatography (GC), which presents a high sensitivity. On the other hand, it has important drawbacks, such as high costs, the need for qualified personnel and frequent maintenance. To overcome these drawbacks, this work reports the development of a low cost and portable BTX gas detection system based on a mini chromatographic cartridge, a photo ionization detector (PID), a simple control unit (based on Arduino architecture) and a mini pump. In order to separate the BTX components, we propose the use of a cartridge 80 mm in length, composed of several commercial chromatographic column sections. To test the system performances, we have injected different amounts (from about 0.3 to 5.3 µg) of benzene, toluene and xylene and two of the most frequent possible interferents (ethanol, acetone). Experimental results have shown different retention time values (i.e., 25 ± 0.5 s, 51 ± 1.2 s and 117 ± 4 s, respectively) for benzene, toluene and xylene

    Basic fibroblast growth factor autocrine loop controls human osteosarcoma phenotyping and differentiation.

    No full text
    BACKGROUND: We focused on the phenotype of non-mineralizing MG 63 and mineralizing TE 85 human osteosarcoma cells and investigated the role of bFGF in modulating their differentiative responses. Basic FGF expression and bFGF effects on osteocalcin, runt-related transcription factor-2 (RUNX2), matrix molecular production and bFGF receptors, were evaluated. MATERIALS AND METHODS: Osteocalcin and RUNX2 gene expression were studied by RT-PCR analysis. We evaluated cell proliferation by DNA content and performed differentiation studies on glycosaminoglican (GAG), collagen and proteoglican (PG) synthesis by using radiolabelled precursors and Northern blotting. BFGF receptors were quantified by bFGF receptor binding assay. RESULTS: Osteocalcin is expressed in MG63 and TE65. RUNX2 RNA is differentially spliced in the two cell lines. BFGF elicits the effects of differentially splicing RUNX2. Proliferation, GAG synthesis, bFGF and proteoglycan mRNA expression, high and low affinity bFGF receptors, were more marked in MG 63 and differently affected by bFGF. Procollagen expression and alkaline phosphatase activity were significantly reduced. BFGF increased TE 85 cell proliferation and reduced TE 85 procollagen and osteocalcin production. CONCLUSIONS: The different splice variants in RUNX2 gene in the two cell lines might be related to their different phenotypes. The less differentiated stage of MG63 could also be related to bFGF over-production and more bFGF receptors. The consequent increase in bFGF-bFGF receptor binding could explain the bFGF differentiative effects on MG 63. We suggest an autocrine role of bFGF endogenous release in controlling the different osteosarcoma phenotypes

    A specific anti‐COVID‐19 BNT162b2 vaccine‐induced early innate immune signature positively correlates with the humoral protective response in healthy and multiple sclerosis vaccine recipients

    No full text
    Abstract Objectives The very rapidly approved mRNA‐based vaccines against SARS‐CoV‐2 spike glycoprotein, including Pfizer‐BioNTech BNT162b2, are effective in protecting from severe coronavirus disease 2019 (COVID‐19) in immunocompetent population. However, establishing the duration and identifying correlates of vaccine‐induced protection will be crucial to optimise future immunisation strategies. Here, we studied in healthy vaccine recipients and people with multiple sclerosis (pwMS), undergoing different therapies, the regulation of innate immune response by mRNA vaccination in order to correlate it with the magnitude of vaccine‐induced protective humoral responses. Methods Healthy subjects (n = 20) and matched pwMS (n = 22) were longitudinally sampled before and after mRNA vaccination. Peripheral blood mononuclear cell (PBMC)‐associated type I and II interferon (IFN)‐inducible gene expression, serum innate cytokine/chemokine profile as well as binding and neutralising anti‐SARS‐COV‐2 antibodies (Abs) were measured. Results We identified an early immune module composed of the IFN‐inducible genes Mx1, OAS1 and IRF1, the serum cytokines IL‐15, IL‐6, TNF‐α and IFN‐γ and the chemokines IP‐10, MCP‐1 and MIG, induced 1 day post second and third BNT162b2 vaccine doses, strongly correlating with magnitude of humoral response to vaccination in healthy and MS vaccinees. Moreover, induction of the early immune module was dramatically affected in pwMS treated with fingolimod and ocrelizumab, both groups unable to induce a protective humoral response to COVID‐19 vaccine. Conclusion Overall, this study suggests that the vaccine‐induced early regulation of innate immunity is mediated by IFN signalling, impacts on the magnitude of adaptive responses and it might be indicative of vaccine‐induced humoral protection
    corecore