48 research outputs found
Evaluation of Gear Condition Indicator Performance on Rotorcraft Fleet
The U.S. Army is currently expanding its fleet of Health Usage Monitoring Systems (HUMS) equipped aircraft at significant rates, to now include over 1,000 rotorcraft. Two different on-board HUMS, the Honeywell Modern Signal Processing Unit (MSPU) and the Goodrich Integrated Vehicle Health Management System (IVHMS), are collecting vibration health data on aircraft that include the Apache, Blackhawk, Chinook, and Kiowa Warrior. The objective of this paper is to recommend the most effective gear condition indicators for fleet use based on both a theoretical foundation and field data. Gear diagnostics with better performance will be recommended based on both a theoretical foundation and results of in-fleet use. In order to evaluate the gear condition indicator performance on rotorcraft fleets, results of more than five years of health monitoring for gear faults in the entire HUMS equipped Army helicopter fleet will be presented. More than ten examples of gear faults indicated by the gear CI have been compiled and each reviewed for accuracy. False alarms indications will also be discussed. Performance data from test rigs and seeded fault tests will also be presented. The results of the fleet analysis will be discussed, and a performance metric assigned to each of the competing algorithms. Gear fault diagnostic algorithms that are compliant with ADS-79A will be recommended for future use and development. The performance of gear algorithms used in the commercial units and the effectiveness of the gear CI as a fault identifier will be assessed using the criteria outlined in the standards in ADS-79A-HDBK, an Army handbook that outlines the conversion from Reliability Centered Maintenance to the On-Condition status of Condition Based Maintenance
Data Fusion Tool for Spiral Bevel Gear Condition Indicator Data
Tests were performed on two spiral bevel gear sets in the NASA Glenn Spiral Bevel Gear Fatigue Test Rig to simulate the fielded failures of spiral bevel gears installed in a helicopter. Gear sets were tested until damage initiated and progressed on two or more gear or pinion teeth. During testing, gear health monitoring data was collected with two different health monitoring systems. Operational parameters were measured with a third data acquisition system. Tooth damage progression was documented with photographs taken at inspection intervals throughout the test. A software tool was developed for fusing the operational data and the vibration based gear condition indicator (CI) data collected from the two health monitoring systems. Results of this study illustrate the benefits of combining the data from all three systems to indicate progression of damage for spiral bevel gears. The tool also enabled evaluation of the effectiveness of each CI with respect to operational conditions and fault mode
Ancilla-assisted quantum process tomography
Complete and precise characterization of a quantum dynamical process can be
achieved via the method of quantum process tomography. Using a source of
correlated photons, we have implemented several methods investigating a wide
range of processes, e.g., unitary, decohering, and polarizing. One of these
methods, ancilla-assisted process tomography (AAPT), makes use of an additional
``ancilla system,'' and we have theoretically determined the conditions when
AAPT is possible. All prior schemes for AAPT make use of entangled states. Our
results show that, surprisingly, entanglement is not required for AAPT, and we
present process tomography data obtained using an input state that has no
entanglement. However, the use of entanglement yields superior results.Comment: To appear in Physical Review Letter
Novel Cascaded Ultra Bright Pulsed Source of Polarization Entangled Photons
A new ultra bright pulsed source of polarization entangled photons has been
realized using type-II phase matching in spontaneous parametric down conversion
process in two cascaded crystals. The optical axes of the crystals are aligned
in such a way that the extraordinarily (ordinarily) polarized cone from one
crystal overlaps with the ordinarily (extraordinarily) polarized cone from the
second crystal. This spatial overlapping removes the association between the
polarization and the output angle of the photons that exist in a single type-II
down conversion process. Hence, entanglement of photons originating from any
point on the output cones is possible if a suitable optical delay line is used.
This delay line is particularly simple and easy to implement.Comment: 8 pages 8 figure
Maximally entangled mixed states: Creation and concentration
Using correlated photons from parametric downconversion, we extend the
boundaries of experimentally accessible two-qubit Hilbert space. Specifically,
we have created and characterized maximally entangled mixed states (MEMS) that
lie above the Werner boundary in the linear entropy-tangle plane. In addition,
we demonstrate that such states can be efficiently concentrated, simultaneously
increasing both the purity and the degree of entanglement. We investigate a
previously unsuspected sensitivity imbalance in common state measures, i.e.,
the tangle, linear entropy, and fidelity.Comment: 4 pages, 3 figures, 1 table; accepted versio
Time-dependent distinguishability: Choosing to be a wave or a particle
Interference experiments with connected parametric down-converters have demonstrated that the possibility, in principle, of identifying the photon path through the interferometer is sufficient to wipe out all interference, irrespective of whether the identification is actually made. The distinguishability of the photon path can be controlled by a time-dependent shutter, which leaves the choice whether the photon behaves as a wave or as a particle in the experimenter's hands. By contrast, in some more recent experiments involving the addition of a low-Q cavity, each idler photon makes the choice whether the associated signal photon behaves like a wave and exhibits interference, or like a particle
Generating Entangled Two-Photon States with Coincident Frequencies
It is shown that parametric downconversion, with a short-duration pump pulse
and a long nonlinear crystal that is appropriately phase matched, can produce a
frequency-entangled biphoton state whose individual photons are coincident in
frequency. Quantum interference experiments which distinguish this state from
the familiar time-coincident biphoton state are described.Comment: Revised version (a typo was corrected) as published on PR
Tailoring Single and Multiphoton Probabilities of a Single Photon On-Demand Source
As typically implemented, single photon sources cannot be made to produce
single photons with high probability, while simultaneously suppressing the
probability of yielding two or more photons. Because of this, single photon
sources cannot really produce single photons on demand. We describe a
multiplexed system that allows the probabilities of producing one and more
photons to be adjusted independently, enabling a much better approximation of a
source of single photons on demand.Comment: 4 pages, LaTex, 2 figures, twocolumn and RevTex Style for PR
An entangled two photon source using biexciton emission of an asymmetric quantum dot in a cavity
A semiconductor based scheme has been proposed for generating entangled
photon pairs from the radiative decay of an electrically-pumped biexciton in a
quantum dot. Symmetric dots produce polarisation entanglement, but
experimentally-realised asymmetric dots produce photons entangled in both
polarisation and frequency. In this work, we investigate the possibility of
erasing the `which-path' information contained in the frequencies of the
photons produced by asymmetric quantum dots to recover polarisation-entangled
photons. We consider a biexciton with non-degenerate intermediate excitonic
states in a leaky optical cavity with pairs of degenerate cavity modes close to
the non-degenerate exciton transition frequencies. An open quantum system
approach is used to compute the polarisation entanglement of the two-photon
state after it escapes from the cavity, measured by the visibility of
two-photon interference fringes. We explicitly relate the two-photon visibility
to the degree of Bell-inequality violation, deriving a threshold at which
Bell-inequality violations will be observed. Our results show that an ideal
cavity will produce maximally polarisation-entangled photon pairs, and even a
non-ideal cavity will produce partially entangled photon pairs capable of
violating a Bell-inequality.Comment: 16 pages, 10 figures, submitted to PR