4,127 research outputs found
Shifts in shuttle SRM performance because of ammonium perchlorate crystal shape on missions 51-I/J and 61-A/B
The design of the Space Shuttle vehicle configuration requires that the SRMs produce thrust within tightly-controlled limits. These limits provide assurance that Shuttle ascent performance goals will be achieved within the vehicle flight load constraints. The SRM's will perform within these limits if overall SRM reproducibility is maintained. This report will initially describe the excellent performance reproducibility of the 24 SRMs during the first 12 flights STS-8 through STS-26 (Mission 51-F) using the HPM SRM. Secondly, this report will describe the transient phenomena which interrupted the reproducibility in the first 20 sec of flight for four flights (Missions 51-I/J and 61-A/B). The cause of this 20 sec phenomena is postulated to be a change in the crystal shape of the ammonium perchlorate used in the propellant. This shape change coincided with the performance shift on these four flights. The ballistic effect of the crystal shape change is manifested as a change to the generic HUMP or BARF curve of the Shuttle SRM thrust/pressure-time curve. As the crystal shape change was corrected by the vendor, the performance produced by the Shuttle SRM returned to normal
Space Shuttle booster thrust imbalance analysis
An analysis of the Shuttle SRM thrust imbalance during the steady-state and tailoff portions of the boost phase of flight are presented. Results from flights STS-1 through STS-13 are included. A statistical analysis of the observed thrust imbalance data is presented. A 3 sigma thrust imbalance history versus time was generated from the observed data and is compared to the vehicle design requirements. The effect on Shuttle thrust imbalance from the use of replacement SRM segments is predicted. Comparisons of observed thrust imbalances with respect to predicted imbalances are presented for the two space shuttle flights which used replacement aft segments (STS-9 and STS-13)
Elemental Abundance Ratios in Stars of the Outer Galactic Disk. II. Field Red Giants
We summarize a selection process to identify red giants in the direction of
the southern warp of the Galactic disk, employing VI_C photometry and
multi-object spectroscopy. We also present results from follow-up
high-resolution, high-S/N echelle spectroscopy of three field red giants,
finding [Fe/H] values of about -0.5. The field stars, with Galactocentric
distances estimated at 10 to 15 kpc, support the conclusion of Yong, Carney, &
de Almeida (2005) that the Galactic metallicity gradient disappears beyond R_GC
values of 10 to 12 kpc for the older stars and clusters of the outer disk. The
field and cluster stars at such large distances show very similar abundance
patterns, and, in particular, all show enhancements of the "alpha" elements O,
Mg, Si, Ca, and Ti and the r-process element Eu. These results suggest that
Type II supernovae have been significant contributors to star formation in the
outer disk relative to Type Ia supernovae within the past few Gyrs. We also
compare our results with those available for much younger objects. The limited
results for the H II regions and B stars in the outer disk also suggest that
the radial metallicity gradient in the outer disk is shallow or absent. The
much more extensive results for Cepheids confirm these trends, and that the
change in slope of the metallicity gradient may occur at a larger
Galactocentric distance than for the older stars and clusters. However, the
younger stars also show rising alpha element enhancements with increasing R_GC,
at least beyond 12 kpc. These trends are consistent with the idea of a
progressive growth in the size of the Galactic disk with time, and episodic
enrichment by Type II supernovae as part of the disk's growth. [Abridged]Comment: Accepted for publication in A
Oxygen Abundances in Two Metal-Poor Subgiants from the Analysis of the 6300 A Forbidden O I Line
Recent LTE analyses (Israelian et al. 1998 and Bosegaard et al. 1999) of the
OH bands in the optical-ultraviolet spectra of nearby metal-poor subdwarfs
indicate that oxygen abundances are generally higher than those previously
determined. The difference increases with decreasing metallicity and reaches
delta([O/Fe]) ~ +0.6 dex as [Fe/H] approaches -3.0.
Employing high resolution (R = 50000), high S/N (~ 250) echelle spectra of
the two stars found by Israelian et al. (1998) to have the highest
[O/Fe]-ratios, viz, BD +23 3130 and BD +37 1458, we conducted abundance
analyses based on about 60 Fe I and 7-9 Fe II lines. We determined from Kurucz
LTE models the values of the stellar parameters, as well as abundances of Na,
Ni, and the traditional alpha-elements, independent of the calibration of color
vs scales. We determined oxygen abundances from spectral synthesis of
the stronger line (6300 A) of the [O I] doublet.
The syntheses of the [O I] line lead to smaller values of [O/Fe], consistent
with those found earlier among halo field and globular cluster giants. We
obtain [O/Fe] = +0.35 +/- 0.2 for BD +23 3130 and +0.50 +/- 0.2 for BD +37
1458. In the former, the [O I] line is very weak (~ 1 mA), so that the quoted
[O/Fe] value may in reality be an upper limit.
Therefore in these two stars a discrepancy exists between the [O/Fe]- ratios
derived from [O I] and the OH feature, and the origin of this difference
remains unclear. Until the matter is clarified, we suggest it is premature to
conclude that the ab initio oxygen abundances of old, metal-poor stars need to
be revised drastically upward.Comment: 38 pages, 5 tables, 14 figures To appear in July 1999 AJ Updated
April 16, 1999. Fixed typo
Abundances of Baade's Window Giants from Keck/HIRES Spectra: I. Stellar Parameters and [Fe/H] Values
We present the first results of a new abundance survey of the Milky Way bulge
based on Keck/HIRES spectra of 27 K-giants in the Baade's Window (, ) field. The spectral data used in this study are of much higher resolution
and signal-to-noise than previous optical studies of Galactic bulge stars. The
[Fe/H] values of our stars, which range between -1.29 and , were used to
recalibrate large low resolution surveys of bulge stars. Our best value for the
mean [Fe/H] of the bulge is . This mean value is similar to the
mean metallicity of the local disk and indicates that there cannot be a strong
metallicity gradient inside the solar circle. The metallicity distribution of
stars confirms that the bulge does not suffer from the so-called ``G-dwarf''
problem. This paper also details the new abundance techniques necessary to
analyze very metal-rich K-giants, including a new Fe line list and regions of
low blanketing for continuum identification.Comment: Accepted for publication in January 2006 Astrophysical Journal. Long
tables 3--6 withheld to save space (electronic tables in journal paper). 53
pages, 10 figures, 9 table
Space shuttle launch vehicle performance trajectory, exchange ratios, and dispersion analysis
A baseline space shuttle performance trajectory for Mission 3A launched from WTR has been generated. Design constraints of maximum dynamic pressure, longitudinal acceleration, and delivered payload were satisfied. Payload exchange ratios are presented with explanation on use. Design envelopes of dynamic pressure, SRB staging point, aerodynamic heating and flight performance reserves are calculated and included
Introduction to orbital flight planning (1)
This workbook is designed for students interested in space flight planning, who after training, may serve as flight planning aides. Routine flight planning activities requiring engineering-type calculations and analysis are covered. Practice exercises and brief instructions are given for the programming and use of the hand calculator as well as the calculation of position and velocity in the orbital plane. Calculation of relative orbital position is also covered with emphasis upon celestial coordinates and time measurement
Heat flow and geothermal potential of Kansas
Temperature, thermal-conductivity measurements, and heat-flow values are presented for four holes in Kansas originally drilled for cooperative water-resources investigations by the Kansas Geological Survey and the U.S. Geological Survey. These holes cut most of the sedimentary section and were cased and allowed to reach temperature equilibrium. Several types of geophysical logs were run for these holes. Temperature data from an additional five wells also are presented. Temperature gradients in the sedimentary section vary over a large range (over 4:1), and significantly different temperatures occur at the same depth in different portions of the state. Temperatures as high as 34°C (93°F) occur at a depth of 500 m (1,650 ft) in the south-central portion of the state but are 28°C (82°F) or lower at that depth in other parts of the state. In addition to cuttings measurements, thermal conductivities were estimated from geophysical well-log parameters; useful results suggest more use of the technique in the future. With these results, geophysical well logs can be used to predict temperatures as a function of depth in areas for which no temperatures are available if heat flow is assumed. The extreme variation in gradients observed in the holes occurs because of the large contrast in thermal-conductivity values. Shale thermal-conductivity values appear to have been overestimated in the past; Paleozoic shales in Kansas have thermal-conductivity values of approximately 1.18 ± 0.03 Wm-1K-1. Conversely, evaporite and dolomite units have thermal conductivities of over 4 Wm-1K-1. In spite of the large variations of gradient, the heat-flow values throughout the holes do not vary more than 10%, and any water-flow effects which might be present from the lateral motion on any of the aquifers are less than 10%. The best estimates for heat flow in the four holes come from carbonate units below the base of the Pennsylvanian and range in value from 48 mWm-2 to 62 mWm-2. Two of the holes were drilled to the basement, and correlation of the heat flow with basement radioactivity suggests that the heat-flow/heat-production line postulated for the midcontinent by Roy, Blackwell, and Birch (1968) applies to these data. Because of the low thermal conductivity of the shales, the radiogenic-pluton concept should apply to the midcontinent. Thus, if very radioactive plutons can be identified, much higher temperatures may occur in the sedimentary section than have been thought possible in the past. However, the past overestimation of the shale-conductivity values suggests that some previous high heat-flow values in the midcontinent probably are not correct, and the high gradients are due instead to normal heat flow and very low thermal-conductivity values. In spite of the presence of-low thermal-conductivity values in the midcontinent region, significant use could be made of geothermal energy in Kansas for space heating, thermal assistance, and heat-pump applications because the temperatures in the sedimentary section in much of Kansas are in excess of 40°C (104°F)
Heat flow and geothermal potential of Kansas
Temperature, thermal-conductivity measurements, and heat-flow values are presented for four holes in Kansas originally drilled for cooperative water-resources investigations by the Kansas Geological Survey and the U.S. Geological Survey. These holes cut most of the sedimentary section and were cased and allowed to reach temperature equilibrium. Several types of geophysical logs were run for these holes. Temperature data from an additional five wells also are presented. Temperature gradients in the sedimentary section vary over a large range (over 4:1), and significantly different temperatures occur at the same depth in different portions of the state. Temperatures as high as 34°C (93°F) occur at a depth of 500 m (1,650 ft) in the south-central portion of the state but are 28°C (82°F) or lower at that depth in other parts of the state. In addition to cuttings measurements, thermal conductivities were estimated from geophysical well-log parameters; useful results suggest more use of the technique in the future. With these results, geophysical well logs can be used to predict temperatures as a function of depth in areas for which no temperatures are available if heat flow is assumed. The extreme variation in gradients observed in the holes occurs because of the large contrast in thermal-conductivity values. Shale thermal-conductivity values appear to have been overestimated in the past; Paleozoic shales in Kansas have thermal-conductivity values of approximately 1.18 ± 0.03 Wm-1K-1. Conversely, evaporite and dolomite units have thermal conductivities of over 4 Wm-1K-1. In spite of the large variations of gradient, the heat-flow values throughout the holes do not vary more than 10%, and any water-flow effects which might be present from the lateral motion on any of the aquifers are less than 10%. The best estimates for heat flow in the four holes come from carbonate units below the base of the Pennsylvanian and range in value from 48 mWm-2 to 62 mWm-2. Two of the holes were drilled to the basement, and correlation of the heat flow with basement radioactivity suggests that the heat-flow/heat-production line postulated for the midcontinent by Roy, Blackwell, and Birch (1968) applies to these data. Because of the low thermal conductivity of the shales, the radiogenic-pluton concept should apply to the midcontinent. Thus, if very radioactive plutons can be identified, much higher temperatures may occur in the sedimentary section than have been thought possible in the past. However, the past overestimation of the shale-conductivity values suggests that some previous high heat-flow values in the midcontinent probably are not correct, and the high gradients are due instead to normal heat flow and very low thermal-conductivity values. In spite of the presence of-low thermal-conductivity values in the midcontinent region, significant use could be made of geothermal energy in Kansas for space heating, thermal assistance, and heat-pump applications because the temperatures in the sedimentary section in much of Kansas are in excess of 40°C (104°F)
- …