809 research outputs found
Importance of controlling the degree of saturation in soil compaction
n the typical conventional fill compaction, the dry density ρd and the water content w are controlled in relation to (ρd)max and wopt determined by laboratory compaction tests using a representative sample at a certain compaction energy level CEL. Although CEL and actual soil type affect significantly the values of (ρd)max and wopt, they change inevitably in a given earthwork project while CEL in the field may not match the value used in the laboratory compaction tests. Compaction control based on the stiffness of compacted soil in the field has such a drawback that the stiffness drops upon wetting more largely as the degree of saturation, Sr, of compacted soil becomes lower than the optimum degree of saturation (Sr)opt defined as Sr when (ρd)max is obtained for a given CEL. In comparison, the value of (Sr)opt and the ρd/(ρd)max vs. Sr - (Sr)opt relation of compacted soil are rather insensitive to variations in CEL and soil type, while the strength and stiffness of unsoaked and soaked compacted soil is controlled by ρd and “Sr at the end of compaction”. It is proposed to control not only w and ρd but also Sr so that Sr becomes (Sr)opt and ρd becomes large enough to ensue soil properties required in design.Fundação para a Ciência e Tecnologia (FCT)info:eu-repo/semantics/publishedVersio
Recommended from our members
Young's modulus, Poisson's ratio, and residual stress and strain in (111)-oriented scandium nitride thin films on silicon
Epitaxial scandium nitride films (225 nm thick) were grown on silicon by molecular beam epitaxy, using ammonia as a reactive nitrogen source. The main crystallographic orientation of ScN with respect to Si is (111)(ScN)parallel to(111)(Si) and [1-10](ScN)parallel to[0-11](Si); however, some twinning is also present in the films. The films displayed a columnar morphology with rough surfaces, due to low adatom mobility during growth. The strain-free lattice parameter of ScN films grown under optimized conditions was found to be 4.5047 +/- 0.0005 A, as determined using high-resolution x-ray diffraction (HRXRD). In-plane and out-of-plane strains were subsequently evaluated using HRXRD and were used to determine the Poisson ratio of ScN along the direction, which is found to be 0.188 +/- 0.005. Wafer curvature measurements were made and combined with the strain information to determine the average Young's modulus of the films, which is found to be 270 +/- 25 GPa. Residual film stresses ranged from -1 to 1 GPa (depending on film growth temperature and film thickness) due to competition between the tensile stress (induced by the differential thermal contraction between the ScN film and the Si substrate) and intrinsic compressive stresses generated during growth
In Situ Observations of Phase Transitions in Metastable Nickel (Carbide)/Carbon Nanocomposites.
Nanocomposite thin films comprised of metastable metal carbides in a carbon matrix have a wide variety of applications ranging from hard coatings to magnetics and energy storage and conversion. While their deposition using nonequilibrium techniques is established, the understanding of the dynamic evolution of such metastable nanocomposites under thermal equilibrium conditions at elevated temperatures during processing and during device operation remains limited. Here, we investigate sputter-deposited nanocomposites of metastable nickel carbide (Ni3C) nanocrystals in an amorphous carbon (a-C) matrix during thermal postdeposition processing via complementary in situ X-ray diffractometry, in situ Raman spectroscopy, and in situ X-ray photoelectron spectroscopy. At low annealing temperatures (300 °C) we observe isothermal Ni3C decomposition into face-centered-cubic Ni and amorphous carbon, however, without changes to the initial finely structured nanocomposite morphology. Only for higher temperatures (400-800 °C) Ni-catalyzed isothermal graphitization of the amorphous carbon matrix sets in, which we link to bulk-diffusion-mediated phase separation of the nanocomposite into coarser Ni and graphite grains. Upon natural cooling, only minimal precipitation of additional carbon from the Ni is observed, showing that even for highly carbon saturated systems precipitation upon cooling can be kinetically quenched. Our findings demonstrate that phase transformations of the filler and morphology modifications of the nanocomposite can be decoupled, which is advantageous from a manufacturing perspective. Our in situ study also identifies the high carbon content of the Ni filler crystallites at all stages of processing as the key hallmark feature of such metal-carbon nanocomposites that governs their entire thermal evolution. In a wider context, we also discuss our findings with regard to the much debated potential role of metastable Ni3C as a catalyst phase in graphene and carbon nanotube growth
ImmunoCluster provides a computational framework for the non-specialist to profile high- dimensional cytometry data
High dimensional cytometry is an innovative tool for immune monitoring in health and disease, it has provided novel insight into the underlying biology as well as biomarkers for a variety of diseases. However, the analysis of large multiparametric datasets usually requires specialist computational knowledge. Here we describe ImmunoCluster (https://github.com/kordastilab/ImmunoCluster) an R package for immune profiling cellular heterogeneity in high dimensional liquid and imaging mass cytometry, and flow cytometry data, designed to facilitate computational analysis by a non-specialist. The analysis framework implemented within ImmunoCluster is readily scalable to millions of cells and provides a variety of visualization and analytical approaches, as well as a rich array of plotting tools that can be tailored to users' needs. The protocol consists of three core computational stages: 1, data import and quality control; 2, dimensionality reduction and unsupervised clustering; and 3, annotation and differential testing, all contained within an R-based open-source framework
Presynaptic partner selection during retinal circuit reassembly varies with timing of neuronal regeneration in vivo
Whether neurons can restore their original connectivity patterns during circuit repair is unclear. Taking advantage of the regenerative capacity of zebrafish retina, we show here the remarkable specificity by which surviving neurons reassemble their connectivity upon regeneration of their major input. H3 horizontal cells (HCs) normally avoid red and green cones, and prefer ultraviolet over blue cones. Upon ablation of the major (ultraviolet) input, H3 HCs do not immediately increase connectivity with other cone types. Instead, H3 dendrites retract and re-extend to contact new ultraviolet cones. But, if regeneration is delayed or absent, blue-cone synaptogenesis increases and ectopic synapses are made with red and green cones. Thus, cues directing synapse specificity can be maintained following input loss, but only within a limited time period. Further, we postulate that signals from the major input that shape the H3 HC's wiring pattern during development persist to restrict miswiring after damage
HER2-HER3 heterodimer quantification by FRET-FLIM and patient subclass analysis of the COIN colorectal trial
BACKGROUND: The phase 3 MRC COIN trial showed no statistically significant benefit from adding the EGFR-target cetuximab to oxaliplatin-based chemotherapy in first-line treatment of advanced colorectal cancer. This study exploits additional information on HER2-HER3 dimerization to achieve patient stratification and reveal previously hidden subgroups of patients who had differing disease progression and treatment response. METHODS: HER2-HER3 dimerization was quantified by "FLIM Histology" in primary tumor samples from 550 COIN trial patients receiving oxaliplatin and fluoropyrimidine chemotherapy +/-cetuximab. Bayesian latent class analysis (LCA) and covariate reduction was performed to analyze the effects of HER2-HER3 dimer, RAS mutation and cetuximab on progression-free survival (PFS) and overall survival (OS). All statistical tests were two-sided. RESULTS: LCA on a cohort of 398 patients revealed two patient subclasses with differing prognoses (median OS: 1624 days [95%CI=1466-1816] vs 461 [95%CI=431-504]): Class 1 (15.6%) showed a benefit from cetuximab in OS (HR = 0.43 [95%CI=0.25-0.76]; p = 0.004). Class 2 showed an association of increased HER2-HER3 with better OS (HR = 0.64 [95%CI=0.44-0.94]; p = 0.02). A class prediction signature was formed and tested on an independent validation cohort (N = 152) validating the prognostic utility of the dimer assay. Similar subclasses were also discovered in full trial dataset (N = 1,630) based on 10 baseline clinicopathological and genetic covariates. CONCLUSIONS: Our work suggests that the combined use of HER dimer imaging and conventional mutation analyses will be able to identify a small subclass of patients (>10%) who will have better prognosis following chemotherapy. A larger prospective cohort will be required to confirm its utility in predicting the outcome of anti-EGFR treatment
In situ Biological Dose Mapping Estimates the Radiation Burden Delivered to ‘Spared’ Tissue between Synchrotron X-Ray Microbeam Radiotherapy Tracks
Microbeam radiation therapy (MRT) using high doses of synchrotron X-rays can destroy tumours in animal models whilst causing little damage to normal tissues. Determining the spatial distribution of radiation doses delivered during MRT at a microscopic scale is a major challenge. Film and semiconductor dosimetry as well as Monte Carlo methods struggle to provide accurate estimates of dose profiles and peak-to-valley dose ratios at the position of the targeted and traversed tissues whose biological responses determine treatment outcome. The purpose of this study was to utilise γ-H2AX immunostaining as a biodosimetric tool that enables in situ biological dose mapping within an irradiated tissue to provide direct biological evidence for the scale of the radiation burden to ‘spared’ tissue regions between MRT tracks. Γ-H2AX analysis allowed microbeams to be traced and DNA damage foci to be quantified in valleys between beams following MRT treatment of fibroblast cultures and murine skin where foci yields per unit dose were approximately five-fold lower than in fibroblast cultures. Foci levels in cells located in valleys were compared with calibration curves using known broadbeam synchrotron X-ray doses to generate spatial dose profiles and calculate peak-to-valley dose ratios of 30–40 for cell cultures and approximately 60 for murine skin, consistent with the range obtained with conventional dosimetry methods. This biological dose mapping approach could find several applications both in optimising MRT or other radiotherapeutic treatments and in estimating localised doses following accidental radiation exposure using skin punch biopsies
Characterization of cDNA clones of the family of trypsin/α-amylase inhibitors (CM-proteins) in barley (Hordeum vulgare L.)
Recombinants encoding members of the trypsin/-amylase inhibitors family (also designated CM-proteins) were selected from a cDNA library prepared from developing barley endosperm. Inserts in two of the clones, pUP-13 and pUP-38, were sequenced and found to encode proteins which clearly belong to this family, as judged from the extensive homology of the deduced sequences with that of the barley trypsin inhibitor CMe, the only member of the group for which a complete amino acid sequence has been obtained by direct protein sequencing. These results, together with previously obtained N-terminal sequences of purified CM-proteins, imply that there are at least six different members of this dispersed gene family in barley. The relationship of this protein family to the B-3 hordein and to reserve prolamins from related species is discussed in terms of their genome structure and evolution
Cloning of cDNA and chromosomal location of genes encoding the three types of subunits of the wheat tetrameric inhibitor of insect a-amylase
We have characterized three cDNA clones corresponding to proteins CM1, CM3 and CM16, which represent the three types of subunits of the wheat tetrameric inhibitor of insect -amylases. The deduced amino acid sequences of the mature polypeptides are homologous to those of the dimeric and monomeric -amylase inhibitors and of the trypsin inhibitors. The mature polypeptides are preceded by typical signal peptides. Southern blot analysis of appropriate aneuploids, using the cloned cDNAs as probes, has revealed the location of genes for subunits of the CM3 and of the CM16 type within a few kb of each other in chromosomes 4A, 4B and 4D, and those for the CM1 type of subunit in chromosomes 7A, 7B and 7D. Known subunits of the tetrameric inhibitor corresponding to genes from the B and D genomes have been previously characterized. No proteins of this class have been found to be encoded by the A genome in hexaploid wheat (genomes AA, BB, DD) or in diploid wheats (AA) and no anti -amylase activity has been detected in the latter, so that the A-genome genes must be either silent (pseudogenes) or expressed at a much lower level
MICE: The muon ionization cooling experiment. Step I: First measurement of emittance with particle physics detectors
Copyright @ 2011 APSThe Muon Ionization Cooling Experiment (MICE) is a strategic R&D project intended to demonstrate the only practical solution to providing high brilliance beams necessary for a neutrino factory or muon collider. MICE is under development at the Rutherford Appleton Laboratory (RAL) in the United Kingdom. It comprises a dedicated beamline to generate a range of input muon emittances and momenta, with time-of-flight and Cherenkov detectors to ensure a pure muon beam. The emittance of the incoming beam will be measured in the upstream magnetic spectrometer with a scintillating fiber tracker. A cooling cell will then follow, alternating energy loss in Liquid Hydrogen (LH2) absorbers to RF cavity acceleration. A second spectrometer, identical to the first, and a second muon identification system will measure the outgoing emittance. In the 2010 run at RAL the muon beamline and most detectors were fully commissioned and a first measurement of the emittance of the muon beam with particle physics (time-of-flight) detectors was performed. The analysis of these data was recently completed and is discussed in this paper. Future steps for MICE, where beam emittance and emittance reduction (cooling) are to be measured with greater accuracy, are also presented.This work was supported by NSF grant PHY-0842798
- …