No Evidence for Shared Representations of Task Sets in Joint Task Switching

Action Contro

The validity and reliability of the exposure index as a metric for estimating the radiation dose to the patient

Introduction With the introduction of digital radiography, the feedback between image quality and over-exposure has been partly lost which in some cases has led to a steady increase in dose. Over the years the introduction of exposure index (EI) has been used to resolve this phenomenon referred to as ‘dose creep’. Even though EI is often vendor specific it is always a related of the radiation exposure to the detector. Due to the nature of this relationship EI can also be used as a patient dose indicator, however this is not widely investigated in literature. Methods A total of 420 dose-area-product (DAP) and EI measurements were taken whilst varying kVp, mAs and body habitus on two different anthropomorphic phantoms (pelvis and chest). Using linear regression, the correlation between EI and DAP were examined. Additionally, two separate region of interest (ROI) placements/per phantom where examined in order to research any effect on EI. Results When dividing the data into subsets, a strong correlation between EI and DAP was shown with all R-squared values > 0.987. Comparison between the ROI placements showed a significant difference between EIs for both placements. Conclusion This research shows a clear relationship between EI and radiation dose which is dependent on a wide variety of factors such as ROI placement, body habitus. In addition, pathology and manufacturer specific EI’s are likely to be of influence as well. Implications for practice The combination of DAP and EI might be used as a patient dose indicator. However, the influencing factors as mentioned in the conclusion should be considered and examined before implementation

Tracing the flows of copper and copper alloys in the Early Iron Age societies of the eastern Eurasian steppe

Abstract</jats:p

The Recovery of Weight-Bearing Symmetry After Total Hip Arthroplasty Is Activity-Dependent

This study aimed to characterize ipsilateral loading and return to weight-bearing symmetry (WBS) in patients undergoing total hip arthroplasty (THA) during activities of daily living (ADLs) using instrumented insoles. A prospective study in 25 THA patients was performed, which included controlled pre- and postoperative follow-ups in a single rehabilitation center of an orthopedic department. Ipsilateral loading and WBS of ADLs were measured with insoles in THA patients and in a healthy control group of 25 participants. Measurements in the THA group were performed at 4 different visits: a week pre-THA, within a week post-THA, 3-6 weeks post-THA, and 6-12 weeks post-THA, whereas the healthy control group was measured once. ADLs included standing comfortably, standing evenly, walking, and sit-to-stand-to-sit (StS) transitions. All ADLs were analyzed using discrete methods, and walking included a time-scale analysis to provide temporal insights in the ipsilateral loading and WBS waveforms. THA patients only improved beyond their pre-surgery levels while standing comfortably (ipsilateral loading and WBS, p < 0.05) and during StS transitions (WBS, p < 0.05). Nevertheless, patients improved upon their ipsilateral loading and WBS deficits observed within a week post-surgery across all investigated ADLs. Ipsilateral loading and WBS of THA patients were comparable to healthy participants at 6-12 weeks post-THA, except for ipsilateral loading during walking (p < 0.05) at the initial and terminal double-leg support period of the stance phase. Taken together, insole measurements allow for the quantification of ipsilateral loading and WBS deficits during ADLs, identifying differences between pre- and postoperative periods, and differentiating THA patients from healthy participants. However, post-THA measurements that lack pre-surgery assessments may not be sensitive to identifying patient-specific improvements in ipsilateral loading and WBS. Moreover, StS transitions and earlier follow-up time points should be considered an important clinical metric of biomechanical recovery after THA

The 3D-structure of a natural inhibitor of cell adhesion molecule expression

AbstractThe three-dimensional structure of cyclopeptolide HUN-7293, a naturally-occurring inhibitor of cell adhesion molecule expression, has been determined from nuclear magnetic resonance data recorded in solution and from X-ray diffraction analysis of single crystals. The backbone conformation of HUN-7293 is characterized by two cis-peptide bonds in both the solution and crystalline state. Differences between the solution and crystal structure are visible for the orientation of some side chains and the strength of two transannular hydrogen bonds. Such structural information helps to provide insight into the molecular architecture of HUN-7293 on the atomic level and opens the way for structure-based modifications of this novel inhibitor of cell adhesion molecule expression

Bend it like Beckham: embodying the motor skills of famous athletes.

Observing an action activates the same representations as does the actual performance of the action. Here we show for the first time that the action system can also be activated in the complete absence of action perception. When the participants had to identify the faces of famous athletes, the responses were influenced by their similarity to the motor skills of the athletes. Thus, the motor skills of the viewed athletes were retrieved automatically during person identification and had a direct influence on the action system of the observer. However, our results also indicated that motor behaviours that are implicit characteristics of other people are represented differently from when actions are directly observed. That is, unlike the facilitatory effects reported when actions were seen, the embodiment of the motor behaviour that is not concurrently perceived gave rise to contrast effects where responses similar to the behaviour of the athletes were inhibited

Location of the Energy Levels of the Rare-Earth Ion in BaF2 and CdF2

The location of the energy levels of rare-earth (RE) elements in the energy band diagram of BaF2 and CdF2 crystals is determined. The role of RE3+ and RE2+ ions in the capture of charge carriers, luminescence, and the formation of radiation defects is evaluated. It is shown that the substantial difference in the luminescence properties of BaF2:RE and CdF2:RE is associated with the location of the excited energy levels in the band diagram of the crystals