15 research outputs found
Morphological and physicochemical properties of dip-coated poly {(2,5-diyl pyrrole) [4-nitrobenzylidène]} (PPNB) thin films: towards photovoltaic applications
A new material: conjugated poly {(2,5-diyl pyrrole) [4-nitrobenzylidène]}, that we called (PPNB), has been synthesized and characterized. The cyclic voltammetry has been used in order to estimate first oxidation (Ep) and reduction (En) potentials of our polymer. These values have been assigned, respectively, to the position of the highest occupied molecular orbital (HOMO) and the lowest unoccupied molecular orbital (LUMO) and determination of the energy band gap which have been estimated to be 6.16, 3.89 and 2.27 eV respectively. Energy levels values of the HOMO and LUMO of the PPNB polymeric donor material were evaluated and the results are compatible with an electron transfer to C60 within an eventual junction, such values show that PPNB could be probed for applications in organic solar cells as donor material. PPNB Thin films have been deposited by dip-coating technique from Dichloromethane solvent with different polymer concentrations, and a dipping speed of 3.0 cm/min. For morphological characterization of the films scanning electron microscopy (SEM) was carried out. The samples, when observed by SEM, reveals that the films deposited are less dense, uniform. Cross-sectional SEM micrographs PPNB films show that thickness of the layers is homogeneous and has value of 35–40 nm. Optical characteristics of the polymer thin films were studied using UV-vis spectroscopy; absorption of wide range of wavelengths from 350 to 700 nm was observed. The optical band gap energy ranges between 1.9 eV and 1.94 eV. Based on these analyzes we realized heterojunction organic solar cells with the structure: ITO/Au/PPNB/C60/BCP/Al, the cells had a photovoltaique effect after J-V measuring, however the efficiency of photo generation under AM1.5 illumination was weak (about 0.02%) and needs to be improved
Synthesis and Characterization of Zn Phtalocyanine (ZnPc) Using Maghnite-Zn as Clay Catalyst
Metal-loaded mesoporous MCM-41 for the catalytic wet peroxide oxidation (CWPO) of acetaminophen
MCM-41 based catalysts (molar ratio Si/Al = 40) were prepared by a hydrothermal route, modified by ionic exchange with different metals (Cu, Cr, Fe and Zn) and finally calcined at 550 °C. The catalysts were fully characterized by different techniques that confirmed the formation of oxides of the different metals on the surfaces of all materials. Low-angle X-ray diffraction (XRD) analyses showed that calcination resulted in the incorporation of metallic Zn, Fe and Cr in the framework of MCM-41, while in the case of Cu, thin layers of CuO were formed on the surface of MCM-41. The solids obtained were tested in the catalytic wet peroxide oxidation (CWPO) of acetaminophen at different temperatures (25–55 °C). The activity followed the order: Cr/MCM-41 ≥ Fe/MCM-41 > Cu/MCM-41 > Zn/MCM-41. The increase of the reaction temperature improved the performance and activity of Cr/MCM-41 and Fe/MCM-41 catalysts, which achieved complete conversion of acetaminophen in short reaction times (15 min in the case of Cr/MCM-41). Fe/MCM-41 and Cr/MCM-41 were submitted to long-term experiments, being the Fe/MCM-41 catalyst the most stable with a very low metal leaching. The leaching results were better than those previously reported in the literature, confirming the high stability of Fe/MCM-41 catalysts synthesized in this study