Flexible protection architectures using distributed optical sensors

In this paper we describe recent developments in flexible protection schemes that make use of passive fibre Bragg grating (FBG) based transducers for the distributed measurement of voltage and current. The technology underpinning the passive optical approach is described in detail, and both the present development and the future potential of the approach are discussed. In co-operation with Toshiba, the integration of the technique with an existing busbar protection relay is demonstrated, illustrating the flexibility offered by protection schemes that are based on the use of small, passive, multiplexable, dielectric transducers

Técnicas de monitorização em redes ópticas de próxima geração

Doutoramento em Engenharia FísicaIn this work several techniques to monitor the performance of optical networks were developed. These techniques are dedicated either to the measurement of the data signal parameters (optical signal to noise ratio and dispersion) or to the detection of physical failures on the network infrastructure. The optical signal to noise ratio of the transmitted signal was successfully monitored using methods based on the presence of Bragg gratings imprinted on high birefringent fibres that allowed the distinction of the signal from the noise due to its polarization properties. The monitoring of the signal group-velocity dispersion was also possible. In this case, a method based on the analysis of the electric spectrum of the signal was applied. It was experimentally demonstrated that this technique is applicable on both amplitude and phase modulated signals. It was also developed a technique to monitor the physical infrastructure of an optical access network. Once again, the application of Bragg gratings (this time imprinted on standard single mode fibres) was the basis of the developed method.Neste trabalho foram desenvolvidas diversas técnicas que permitem a monitorização de desempenho das redes de comunicações ópticas. Estas técnicas dedicam-se quer à determinação de parâmetros do próprio sinal de dados (como a relação sinal ruído óptico e a dispersão), quer à detecção de eventuais falhas físicas na infra-estrutura da rede. Relativamente à monitorização da relação sinal-ruído óptico foram desenvolvidos métodos baseados na aplicação de redes de Bragg gravadas em fibras birrefringentes que permitiram distinguir o sinal do ruído através das suas propriedades de polarização. A monitorização da dispersão cromática sofrida pelo sinal durante a sua propagação também foi possível. Neste caso foi testada uma técnica baseada na análise do espectro eléctrico do sinal. Demonstrou-se que esta técnica pode ser aplicada quer em sinais modulados na amplitude quer em sinais modulados na fase. Foi também desenvolvida uma técnica para a monitorização da infra-estrutura física de uma rede de acesso. Mais uma vez, aqui foi utilizado um método baseado na presença de redes de Bragg, desta vez gravadas em fibras monomodo que são utilizadas como pontos de monitorização em locais estratégicos da rede

Data transport over optical fibre for ska using advanced modulation flexible spectrum technology

Flexible Spectrum Dense Wavelength Division Multiplexed (DWDM) optical fibre networks are next-generation technology for handling extremely high data rates of the kind produced by MeerKAT and SKA.We optimise the flexible spectrum for real-time dynamic channel wavelength assignment, to ensure optimum network performance. We needed to identify and develop novel hardware and dynamic algorithms for these networks to function optimally to perform critical tasks. Such tasks include wavelength assignment, signal routing, network restoration and network protection. The antennas of the Square Kilometre Array (SKA) network connect to the correlator and data processor in a simple point-to-point fixed configuration. The connection of the astronomer users to the data processor, however, requires a more complex network architecture. This is because the network has users scattered around South Africa, Africa and the whole world. This calls for upgrade of the classical fixed wavelength spectrum grids, to flexible spectrum grid that has improved capacity, reliable, simple and cost-effectiveness through sharing of network infrastructure. The exponential growth of data traffic in current optical communication networks requires higher capacity for the bandwidth demands at a reduced cost per bit. All-optical signal processing is a promising technique to improve network resource utilisation and resolve wavelength contention associated with the flexible spectrum. Flexible Spectrum Dense Wavelength Division Multiplexed (DWDM) optical fibre networks are next-generation technology for handling extremely high data rates of the kind produced by MeerKAT and SKA. Each DWDM channel is capable of 10 Gbps transmission rate, which is sliceable into finer flexible grid 12.5 GHz granularity to offer the network elastic spectrum and channel spacing capable of signal routing and wavelength switching for the scalability of aggregate bandwidth. The variable-sized portions of the flexible spectrum assignment to end users at different speeds depend on bandwidth demand, allowing efficient utilisation of the spectrum resources. The entire bandwidth of dynamic optical connections must be contiguously allocated. However, there is an introduction of spectrum fragmentation due to spectrum contiguity related to the optical channels having different width. Thus large traffic demands are likely to experience blocking regardless of available bandwidth. To minimise the congestion and cost-effectively obtain high performance, the optical network must be reconfigurable, achievable by adding wavelength as an extra degree of freedom for effectiveness. This can introduce colourless, directionless and contentionless reconfigurability to route individual wavelengths from fibre to fibre across multiple nodes to avoid wavelength blocking/collisions, increasing the flexibility and capacity of a network. For these networks to function optimally, novel hardware and dynamic algorithms identification and development is a critical task. Such tasks include wavelength assignment, signal routing, network restoration and network protection. In this work, we for the first time to our knowledge proposed a spectrum defragmentation technique through reallocation of the central frequency of the optical transmitter, to increase the probability of finding a sufficient continuous spectrum. This is to improve network resource utilisation, capacity and resolve wavelength contention associated with a flexible spectrum in optical communication networks. The following chapter provides details on a flexible spectrum in optical fibre networks utilising DWDM, optimising transmitter-receivers, advanced modulation formats, coherent detection, reconfigurable optical add and drop multiplexer (ROADM) technology to implement hardware and middleware platforms which address growing bandwidth demands for scalability, flexibility and cost-efficiency. A major attribute is tunable lasers, an essential component for future flexible spectrum with application to wavelength switching, routing, wavelength conversion and ROADM for the multi-node optical network through spectrum flexibility and cost-effective sharing of fibre links, transmitters and receivers. Spectrum slicing into fine granular sub-carriers and assigning several frequency slots to accommodate diverse traffic demands is a viable approach. This work experimentally presents a spectral efficient technique for bandwidth variability, wavelength allocation, routing, defragmentation and wavelength selective switches in the nodes of a network, capable of removing the fixed grid spacing using low cost, high bandwidth, power-efficient and wavelength-tunable vertical-cavity surface-emitting laser (VCSEL) transmitter directly modulated with 10 Gbps data. This to ensure that majority of the spectrum utilisation at finer channel spacing, wastage of the spectrum resource as caused by the wavelength continuity constraint reduction and it improves bandwidth utilisation. The technique is flexible in terms of modulation formats and accommodates various formats with spectrally continuous channels, fulfilling the future bandwidth demands with transmissions beyond 100 Gbps per channel while maintaining spectral efficiency

Data transport over optical fibre for ska using advanced modulation flexible spectrum technology

Flexible Spectrum Dense Wavelength Division Multiplexed (DWDM) optical fibre networks are next-generation technology for handling extremely high data rates of the kind produced by MeerKAT and SKA.We optimise the flexible spectrum for real-time dynamic channel wavelength assignment, to ensure optimum network performance. We needed to identify and develop novel hardware and dynamic algorithms for these networks to function optimally to perform critical tasks. Such tasks include wavelength assignment, signal routing, network restoration and network protection. The antennas of the Square Kilometre Array (SKA) network connect to the correlator and data processor in a simple point-to-point fixed configuration. The connection of the astronomer users to the data processor, however, requires a more complex network architecture. This is because the network has users scattered around South Africa, Africa and the whole world. This calls for upgrade of the classical fixed wavelength spectrum grids, to flexible spectrum grid that has improved capacity, reliable, simple and cost-effectiveness through sharing of network infrastructure. The exponential growth of data traffic in current optical communication networks requires higher capacity for the bandwidth demands at a reduced cost per bit. All-optical signal processing is a promising technique to improve network resource utilisation and resolve wavelength contention associated with the flexible spectrum. Flexible Spectrum Dense Wavelength Division Multiplexed (DWDM) optical fibre networks are next-generation technology for handling extremely high data rates of the kind produced by MeerKAT and SKA. Each DWDM channel is capable of 10 Gbps transmission rate, which is sliceable into finer flexible grid 12.5 GHz granularity to offer the network elastic spectrum and channel spacing capable of signal routing and wavelength switching for the scalability of aggregate bandwidth. The variable-sized portions of the flexible spectrum assignment to end users at different speeds depend on bandwidth demand, allowing efficient utilisation of the spectrum resources. The entire bandwidth of dynamic optical connections must be contiguously allocated. However, there is an introduction of spectrum fragmentation due to spectrum contiguity related to the optical channels having different width. Thus large traffic demands are likely to experience blocking regardless of available bandwidth. To minimise the congestion and cost-effectively obtain high performance, the optical network must be reconfigurable, achievable by adding wavelength as an extra degree of freedom for effectiveness. This can introduce colourless, directionless and contentionless reconfigurability to route individual wavelengths from fibre to fibre across multiple nodes to avoid wavelength blocking/collisions, increasing the flexibility and capacity of a network. For these networks to function optimally, novel hardware and dynamic algorithms identification and development is a critical task. Such tasks include wavelength assignment, signal routing, network restoration and network protection. In this work, we for the first time to our knowledge proposed a spectrum defragmentation technique through reallocation of the central frequency of the optical transmitter, to increase the probability of finding a sufficient continuous spectrum. This is to improve network resource utilisation, capacity and resolve wavelength contention associated with a flexible spectrum in optical communication networks. The following chapter provides details on a flexible spectrum in optical fibre networks utilising DWDM, optimising transmitter-receivers, advanced modulation formats, coherent detection, reconfigurable optical add and drop multiplexer (ROADM) technology to implement hardware and middleware platforms which address growing bandwidth demands for scalability, flexibility and cost-efficiency. A major attribute is tunable lasers, an essential component for future flexible spectrum with application to wavelength switching, routing, wavelength conversion and ROADM for the multi-node optical network through spectrum flexibility and cost-effective sharing of fibre links, transmitters and receivers. Spectrum slicing into fine granular sub-carriers and assigning several frequency slots to accommodate diverse traffic demands is a viable approach. This work experimentally presents a spectral efficient technique for bandwidth variability, wavelength allocation, routing, defragmentation and wavelength selective switches in the nodes of a network, capable of removing the fixed grid spacing using low cost, high bandwidth, power-efficient and wavelength-tunable vertical-cavity surface-emitting laser (VCSEL) transmitter directly modulated with 10 Gbps data. This to ensure that majority of the spectrum utilisation at finer channel spacing, wastage of the spectrum resource as caused by the wavelength continuity constraint reduction and it improves bandwidth utilisation. The technique is flexible in terms of modulation formats and accommodates various formats with spectrally continuous channels, fulfilling the future bandwidth demands with transmissions beyond 100 Gbps per channel while maintaining spectral efficiency

Strain state detection in composite structures: Review and new challenges

Developing an advanced monitoring system for strain measurements on structural components represents a significant task, both in relation to testing of in-service parameters and early identification of structural problems. This paper aims to provide a state-of-the-art review on strain detection techniques in composite structures. The review represented a good opportunity for direct comparison of different novel strain measurement techniques. Fibers Bragg grating (FBG) was discussed as well as non-contact techniques together with semiconductor strain gauges (SGs), specifically infrared (IR) thermography and the digital image correlation (DIC) applied in order to detect strain and failure growth during the tests. The challenges of the research community are finally discussed by opening the current scenario to new objectives and industrial applications

Strain State Detection in Composite Structures: Review and New Challenges

Developing an advanced monitoring system for strain measurements on structural components represents a significant task, both in relation to testing of in-service parameters and early identification of structural problems. This paper aims to provide a state-of-the-art review on strain detection techniques in composite structures. The review represented a good opportunity for direct comparison of different novel strain measurement techniques. Fibers Bragg grating (FBG) was discussed as well as non-contact techniques together with semiconductor strain gauges (SGs), specifically infrared (IR) thermography and the digital image correlation (DIC) applied in order to detect strain and failure growth during the tests. The challenges of the research community are finally discussed by opening the current scenario to new objectives and industrial applications

Transparent heterogeneous terrestrial optical communication networks with phase modulated signals

This thesis presents a large scale numerical investigation of heterogeneous terrestrial optical communications systems and the upgrade of fourth generation terrestrial core to metro legacy interconnects to fifth generation transmission system technologies. Retrofitting (without changing infrastructure) is considered for commercial applications. ROADM are crucial enabling components for future core network developments however their re-routing ability means signals can be switched mid-link onto sub-optimally configured paths which raises new challenges in network management. System performance is determined by a trade-off between nonlinear impairments and noise, where the nonlinear signal distortions depend critically on deployed dispersion maps. This thesis presents a comprehensive numerical investigation into the implementation of phase modulated signals in transparent reconfigurable wavelength division multiplexed fibre optic communication terrestrial heterogeneous networks. A key issue during system upgrades is whether differential phase encoded modulation formats are compatible with the cost optimised dispersion schemes employed in current 10 Gb/s systems. We explore how robust transmission is to inevitable variations in the dispersion mapping and how large the margins are when suboptimal dispersion management is applied. We show that a DPSK transmission system is not drastically affected by reconfiguration from periodic dispersion management to lumped dispersion mapping. A novel DPSK dispersion map optimisation methodology which reduces drastically the optimisation parameter space and the many ways to deploy dispersion maps is also presented. This alleviates strenuous computing requirements in optimisation calculations. This thesis provides a very efficient and robust way to identify high performing lumped dispersion compensating schemes for use in heterogeneous RZ-DPSK terrestrial meshed networks with ROADMs. A modified search algorithm which further reduces this number of configuration combinations is also presented. The results of an investigation of the feasibility of detouring signals locally in multi-path heterogeneous ring networks is also presented

The Public Service Media and Public Service Internet Manifesto

This book presents the collectively authored Public Service Media and Public Service Internet Manifesto and accompanying materials.The Internet and the media landscape are broken. The dominant commercial Internet platforms endanger democracy. They have created a communications landscape overwhelmed by surveillance, advertising, fake news, hate speech, conspiracy theories, and algorithmic politics. Commercial Internet platforms have harmed citizens, users, everyday life, and society. Democracy and digital democracy require Public Service Media. A democracy-enhancing Internet requires Public Service Media becoming Public Service Internet platforms – an Internet of the public, by the public, and for the public; an Internet that advances instead of threatens democracy and the public sphere. The Public Service Internet is based on Internet platforms operated by a variety of Public Service Media, taking the public service remit into the digital age. The Public Service Internet provides opportunities for public debate, participation, and the advancement of social cohesion. Accompanying the Manifesto are materials that informed its creation: Christian Fuchs’ report of the results of the Public Service Media/Internet Survey, the written version of Graham Murdock’s online talk on public service media today, and a summary of an ecomitee.com discussion of the Manifesto’s foundations