High Quality Test Generation Targeting Power Supply Noise

Delay test is an essential structural manufacturing test used to determine the maximal frequency at which a chip can run without incurring any functional failures. The central unsolved challenge is achieving high delay correlation with the functional test, which is dominated by power supply noise (PSN). Differences in PSN between functional and structural tests can lead to differences in chip operating frequencies of 30% or more. Pseudo functional test (PFT), based on a multiple-cycle clocking scheme, has better PSN correlation with functional test compared with traditional two-cycle at-speed test. However, PFT is vulnerable to under-testing when applied to delay test. This work aims to generate high quality PFT patterns, achieving high PSN correlation with functional test. First, a simulation-based don’t-care filling algorithm, Bit-Flip, is proposed to improve the PSN for PFT. It relies on randomly flipping a group of bits in the test pattern to explore the search space and find patterns that stress the circuits with the worst-case, but close to functional PSN. Experimental results on un-compacted patterns show Bit-Flip is able to improve PSN as much as 38.7% compared with the best random fill. Second, techniques are developed to improve the efficiency of Bit-Flip. A set of partial patterns, which sensitize transitions on critical cells, are pre-computed and later used to guide the selection of bits to flip. Combining random and deterministic flipping, we achieve similar PSN control as Bit-Flip but with much less simulation time. Third, we address the problem of automatic test pattern generation for extracting circuit timing sensitivity to power supply noise during post-silicon validation. A layout-aware path selection algorithm selects long paths to fully span the power delivery network. The selected patterns are intelligently filled to bring the PSN to a desired level. These patterns can be used to understand timing sensitivity in post-silicon validation by repeatedly applying the path delay test while sweeping the PSN experienced by the path from low to high. Finally, the impacts of compression on power supply noise control are studied. Illinois Scan and embedded deterministic test (EDT) patterns are generated. Then Bit-Flip is extended to incorporate the compression constraints and applied to compressible patterns. The experimental results show that EDT lowers the maximal PSN by 24.15% and Illinois Scan lowers it by 2.77% on un-compacted patterns

Neural Network Architectures and Ensembles for Packet Classification: Addressing Visibility, Security and Quality of Service Challenges in Communication Networks

Increasingly researchers are turning to machine learning techniques such as artificial neural networks (ANN) to address communication network research challenges in the areas of enhanced security, quality of service, visibility and control. Central to each is the need to classify packets. Determining an effective architecture for the artificial neural network is more difficult because traditional techniques such as principal component analysis (PCA) show reduced effectiveness. Presented are the techniques for preprocessing datasets and selecting input traffic features for the multi-layer perceptron (MLP) architecture. This methodology achieves classification accuracy above 99%. An investigation into neural network architectures revealed the optimal structure and parameters for communication packet classification. This work also studies optimization algorithms with completely balanced datasets and provides performance criteria for training time and accuracy. The application of MLPs to security challenges is also investigated. Port scans are a persistent problem on contemporary communication networks. Sequential MLPs are investigated to classify packets and determine TCP packet type. Following classification, analysis is performed in order to discover scan attempts. Neural networks can be used to successfully classify general packet traffic and more complex TCP classes at rates that are above 99\%. The proposed methodology achieves accurate scan detection without having to utilize an intrusion detection system. In order to harness the power of Convolutional Neural Networks (CNNs), the conversion of packets to images is investigated. Additionally, a sequence of packets are combined into larger images to gain insight into conversations, exchanges, losses and threats. The use of this technique to identify potential latency problems is demonstrated. This approach of using contemporary network traffic and convolutional neural networks has success rate for individual packets exceeding 99%. Larger images achieve the same high level of accuracy. Finally, neural network ensembles are researched that reach 100% accuracy for packet classification. Ensembles are also studied to accurately predict Mean Opinion Score for voice traffic and explored for their use in combating adversarial attacks against the source data

Distributed multimedia systems

A distributed multimedia system (DMS) is an integrated communication, computing, and information system that enables the processing, management, delivery, and presentation of synchronized multimedia information with quality-of-service guarantees. Multimedia information may include discrete media data, such as text, data, and images, and continuous media data, such as video and audio. Such a system enhances human communications by exploiting both visual and aural senses and provides the ultimate flexibility in work and entertainment, allowing one to collaborate with remote participants, view movies on demand, access on-line digital libraries from the desktop, and so forth. In this paper, we present a technical survey of a DMS. We give an overview of distributed multimedia systems, examine the fundamental concept of digital media, identify the applications, and survey the important enabling technologies.published_or_final_versio

Proceedings of the Third International Mobile Satellite Conference (IMSC 1993)

Satellite-based mobile communications systems provide voice and data communications to users over a vast geographic area. The users may communicate via mobile or hand-held terminals, which may also provide access to terrestrial cellular communications services. While the first and second International Mobile Satellite Conferences (IMSC) mostly concentrated on technical advances, this Third IMSC also focuses on the increasing worldwide commercial activities in Mobile Satellite Services. Because of the large service areas provided by such systems, it is important to consider political and regulatory issues in addition to technical and user requirements issues. Topics covered include: the direct broadcast of audio programming from satellites; spacecraft technology; regulatory and policy considerations; advanced system concepts and analysis; propagation; and user requirements and applications

Application of advanced on-board processing concepts to future satellite communications systems

An initial definition of on-board processing requirements for an advanced satellite communications system to service domestic markets in the 1990's is presented. An exemplar system architecture with both RF on-board switching and demodulation/remodulation baseband processing was used to identify important issues related to system implementation, cost, and technology development

Future benefits and applications of intelligent on-board processing to VSAT services

The trends and roles of VSAT services in the year 2010 time frame are examined based on an overall network and service model for that period. An estimate of the VSAT traffic is then made and the service and general network requirements are identified. In order to accommodate these traffic needs, four satellite VSAT architectures based on the use of fixed or scanning multibeam antennas in conjunction with IF switching or onboard regeneration and baseband processing are suggested. The performance of each of these architectures is assessed and the key enabling technologies are identified

Earth imaging with microsatellites: An investigation, design, implementation and in-orbit demonstration of electronic imaging systems for earth observation on-board low-cost microsatellites.

This research programme has studied the possibilities and difficulties of using 50 kg microsatellites to perform remote imaging of the Earth. The design constraints of these missions are quite different to those encountered in larger, conventional spacecraft. While the main attractions of microsatellites are low cost and fast response times, they present the following key limitations: Payload mass under 5 kg, Continuous payload power under 5 Watts, peak power up to 15 Watts, Narrow communications bandwidths (9.6 / 38.4 kbps), Attitude control to within 5°, No moving mechanics. The most significant factor is the limited attitude stability. Without sub-degree attitude control, conventional scanning imaging systems cannot preserve scene geometry, and are therefore poorly suited to current microsatellite capabilities. The foremost conclusion of this thesis is that electronic cameras, which capture entire scenes in a single operation, must be used to overcome the effects of the satellite's motion. The potential applications of electronic cameras, including microsatellite remote sensing, have erupted with the recent availability of high sensitivity field-array CCD (charge-coupled device) image sensors. The research programme has established suitable techniques and architectures necessary for CCD sensors, cameras and entire imaging systems to fulfil scientific/commercial remote sensing despite the difficult conditions on microsatellites. The author has refined these theories by designing, building and exploiting in-orbit five generations of electronic cameras. The major objective of meteorological scale imaging was conclusively demonstrated by the Earth imaging camera flown on the UoSAT-5 spacecraft in 1991. Improved cameras have since been carried by the KITSAT-1 (1992) and PoSAT-1 (1993) microsatellites. PoSAT-1 also flies a medium resolution camera (200 metres) which (despite complete success) has highlighted certain limitations of microsatellites for high resolution remote sensing. A reworked, and extensively modularised, design has been developed for the four camera systems deployed on the FASat-Alfa mission (1995). Based on the success of these missions, this thesis presents many recommendations for the design of microsatellite imaging systems. The novelty of this research programme has been the principle of designing practical camera systems to fit on an existing, highly restrictive, satellite platform, rather than conceiving a fictitious small satellite to support a high performance scanning imager. This pragmatic approach has resulted in the first incontestable demonstrations of the feasibility of remote sensing of the Earth from inexpensive microsatellites

Potential markets for advanced satellite communications

This report identifies trends in the volume and type of traffic offered to the U.S. domestic communications infrastructure and extrapolates these trends through the year 2011. To describe how telecommunications service providers are adapting to the identified trends, this report assesses the status, plans, and capacity of the domestic communications infrastructure. Cable, satellite, and radio components of the infrastructure are examined separately. The report also assesses the following major applications making use of the infrastructure: (1) Broadband services, including Broadband Integrated Services Digital Network (BISDN), Switched Multimegabit Data Service (SMDS), and frame relay; (2) mobile services, including voice, location, and paging; (3) Very Small Aperture Terminals (VSAT), including mesh VSAT; and (4) Direct Broadcast Satellite (DBS) for audio and video. The report associates satellite implementation of specific applications with market segments appropriate to their features and capabilities. The volume and dollar value of these market segments are estimated. For the satellite applications able to address the needs of significant market segments, the report also examines the potential of each satellite-based application to capture business from alternative technologies

A reduced reference video quality assessment method for provision as a service over SDN/NFV-enabled networks

139 p.The proliferation of multimedia applications and services has generarted a noteworthy upsurge in network traffic regarding video content and has created the need for trustworthy service quality assessment methods. Currently, predominent position among the technological trends in telecommunication networkds are Network Function Virtualization (NFV), Software Defined Networking (SDN) and 5G mobile networks equipped with small cells. Additionally Video Quality Assessment (VQA) methods are a very useful tool for both content providers and network operators, to understand of how users perceive quality and this study the feasibility of potential services and adapt the network available resources to satisfy the user requirements

BEAM STEERING CONTROL SYSTEM FOR LOW-COST PHASED ARRAY WEATHER RADARS: DESIGN AND CALIBRATION TECHNIQUES

Phase array antennas are a promising technology for weather surveillance radars. Their fast beam steering capability offer the potential of improving weather observations and extending warning lead times. However, one major problem associated with this technology is their high acquisition cost to be use in networked radar systems. One promising technology that could have a significant impact in the deployment of future dense networks of short-range X-band weather radars is the ``Phase-Tilt Radar\u27\u27, a system that uses a one-dimensional phase scanned antenna array mounted over a tilting mechanism. This dissertation addresses some of specific challenges that arise in designing and implementing air-cooled, low-cost, one-dimensional phased antenna arrays for phase-tilt radars. The goal of this work is to develop methods that can lead to reduce the cost and enhance the performance of this type of systems. Specifically, the thesis focuses on three concrete areas. The first one is on the development of a versatile low-cost beam steering system that can enable dual-polarimetric phased array radars to operate with high-frequency repetition pulses, difference pulsing schemes, and modern scanning strategies. In particular, the dissertation will present the development of critical components and describes the concept of operations of the beam steering system. The second area is to develop a calibration technique for small phased arrays. The work focused in finding the calibration settings for the array that best fit to the desired excitation. The technique provides lower random errors than conventional approaches, enabling the implementation of radiation patterns with sidelobes closer to the desired level. Additionally, the technique is extended to solve the gain-drift problem occurring in the two-way antenna pattern due to the temperature changes. The third area studies the use of mutual coupling as signal injection technique to maintain the calibration of both array and radar. Future air-cooled phased array radars will require the use internal circuitry to calibrate the aspect of the radar that tends to change over time. In particular, this work is focused on developing low-cost calibration techniques to correct the antenna gain and radar constant from effects of temperature changes and element failures