The influences of basic physical properties of clayey silt and silty sand on its laboratory electrical resistivity value in loose and dense conditions

Non-destructive test which refers to electrical resistivity method is recently popular in engineering, environmental, archaeological and mining studies. Based on the previous studies, the results on electrical resistivity interpretation were often debated due to lack of clarification and evidences in quantitative perspective. Traditionally, most of the previous result interpretations were depending on qualitative point of view which is risky to produce unreliable outcomes. In order to minimise those problems, this study has performed a laboratory experiment on soil box electrical resistivity test which was supported by an additional basic physical properties of soil test like particle size distribution test (d), moisture content test (w), density test (ρbulk) and Atterberg limit test (LL, PL and PI). The test was performed to establish a series of electrical resistivity value (ERV) with different quantity of water content for clayey silt and silty sand in loose and dense condition. Apparently, the soil resistivity value was different under loose (L) and dense (C) conditions with moisture content and density variations (silty SAND = ERVLoose: 600 - 7300 Ωm & ERVDense: 490 - 7900 Ωm while Clayey SILT = ERVLoose: 13 - 7700 Ωm & ERVDense: 14 - 8400 Ωm) due to several factors. Moreover, correlation of moisture content (w) and density (ρbulk) due to the ERV was established as follows; Silty SAND: w(L) = 638.8ρ-0.418, w(D) = 1397.1ρ-0.574, ρBulk(L) = 2.6188e-6E-05ρ, ρBulk(D) = 4.099ρ-0.07 while Clayey SILT: w(L) = 109.98ρ-0.268, w(D) = 121.88ρ-0.363, ρBulk(L) = -0.111ln(ρ) + 1.7605, ρBulk(D) = 2.5991ρ-0.037 with determination coefficients, R2 that varied from 0.5643 – 0.8927. This study was successfully demonstrated that the consistency of ERV was greatly influenced by the variation of soil basic physical properties (d, w, ρBulk, LL, PL and PI). Finally, the reliability of the ERV result interpretation can be enhanced due to its ability to produce a meaningful outcome based on supported data from basic geotechnical properties

The influences of basic physical properties of clayey silt and silty sand on its laboratory electrical resistivity value in loose and dense conditions

Non-destructive test which refers to electrical resistivity method is recently popular in engineering, environmental, archaeological and mining studies. Based on the previous studies, the results on electrical resistivity interpretation were often debated due to lack of clarification and evidences in quantitative perspective. Traditionally, most of the previous result interpretations were depending on qualitative point of view which is risky to produce unreliable outcomes. In order to minimise those problems, this study has performed a laboratory experiment on soil box electrical resistivity test which was supported by an additional basic physical properties of soil test like particle size distribution test (d), moisture content test (w), density test (ρbulk) and Atterberg limit test (LL, PL and PI). The test was performed to establish a series of electrical resistivity value (ERV) with different quantity of water content for clayey silt and silty sand in loose and dense condition. Apparently, the soil resistivity value was different under loose (L) and dense (C) conditions with moisture content and density variations (silty SAND = ERVLoose: 600 - 7300 Ωm & ERVDense: 490 - 7900 Ωm while Clayey SILT = ERVLoose: 13 - 7700 Ωm & ERVDense: 14 - 8400 Ωm) due to several factors. Moreover, correlation of moisture content (w) and density (ρbulk) due to the ERV was established as follows; Silty SAND: w(L) = 638.8ρ-0.418, w(D) = 1397.1ρ-0.574, ρBulk(L) = 2.6188e-6E-05ρ, ρBulk(D) = 4.099ρ-0.07 while Clayey SILT: w(L) = 109.98ρ-0.268, w(D) = 121.88ρ-0.363, ρBulk(L) = -0.111ln(ρ) + 1.7605, ρBulk(D) = 2.5991ρ-0.037 with determination coefficients, R2 that varied from 0.5643 – 0.8927. This study was successfully demonstrated that the consistency of ERV was greatly influenced by the variation of soil basic physical properties (d, w, ρBulk, LL, PL and PI). Finally, the reliability of the ERV result interpretation can be enhanced due to its ability to produce a meaningful outcome based on supported data from basic geotechnical properties

A forward view on reliable computers for flight control

The requirements for fault-tolerant computers for flight control of commercial aircraft are examined; it is concluded that the reliability requirements far exceed those typically quoted for space missions. Examination of circuit technology and alternative computer architectures indicates that the desired reliability can be achieved with several different computer structures, though there are obvious advantages to those that are more economic, more reliable, and, very importantly, more certifiable as to fault tolerance. Progress in this field is expected to bring about better computer systems that are more rigorously designed and analyzed even though computational requirements are expected to increase significantly

Heater Control for Thermionic Power Generation

The purpose of this report is to detail the conceptualization, analysis, budget, manufacturing, and assembly the heater for a thermionic energy converter for portable energy generation. This proof of concept will be created to provide a full thermionic energy converter with a reliable and satisfactory heater than can be used in future systems. The report highlights the feasibility and realities in the design and fabrication of the system

Sustainable Development Report: Blockchain, the Web3 & the SDGs

This is an output paper of the applied research that was conducted between July 2018 - October 2019 funded by the Austrian Development Agency (ADA) and conducted by the Research Institute for Cryptoeconomics at the Vienna University of Economics and Business and RCE Vienna (Regional Centre of Expertise on Education for Sustainable Development).Series: Working Paper Series / Institute for Cryptoeconomics / Interdisciplinary Researc

Deployment characterization of a floatable tidal energy converter on a tidal channel, Ria Formosa, Portugal

This paper presents the results of a pilot experiment with an existing tidal energy converter (TEC), Evopod 1 kW floatable prototype, in a real test case scenario (Faro Channel, Ria Formosa, Portugal). A baseline marine geophysical, hydrodynamic and ecological study based on the experience collected on the test site is presented. The collected data was used to validate a hydro-morphodynamic model, allowing the selection of the installation area based on both operational and environmental constraints. Operational results related to the description of power generation capacity, energy capture area and proportion of energy flux are presented and discussed, including the failures occurring during the experimental setup. The data is now available to the scientific community and to TEC industry developers, enhancing the operational knowledge of TEC technology concerning efficiency, environmental effects, and interactions (i.e. device/environment). The results can be used by developers on the licensing process, on overcoming the commercial deployment barriers, on offering extra assurance and confidence to investors, who traditionally have seen environmental concerns as a barrier, and on providing the foundations whereupon similar deployment areas can be considered around the world for marine tidal energy extraction.Acknowledgements The paper is a contribution to the SCORE project, funded by the Portuguese Foundation for Science and Technology (FCT e PTDC/ AAG-TEC/1710/2014). Andre Pacheco was supported by the Portu- guese Foundation for Science and Technology under the Portuguese Researchers' Programme 2014 entitled “Exploring new concepts for extracting energy from tides” (IF/00286/2014/CP1234). Eduardo GGorbena has received funding for the OpTiCA project from the ~ Marie Skłodowska-Curie Actions of the European Union's H2020- MSCA-IF-EF-RI-2016/under REA grant agreement n [748747]. The authors would like to thank to the Portuguese Maritime Authorities and Sofareia SA for their help on the deployment.info:eu-repo/semantics/publishedVersio

Applied Research Through Partnership: the Experience of the Yorkshire and Humberside Regional Research Observatory

Paper presented at a seminar on ‘Los Observatorios Regionales de Políticas Públicas como Herramientas de Gestión de Información: Una Aproximación al Estudio del Rendimiento Autonómico, at the Centro de Estudios de Gestión, Análisis y Información, Campus de Somosaguas, La Universidad Complutense, Madrid, 23-24 November, 2000 Ten years ago, a Regional Research Observatory (ReRO) was established to provide ‘clients’ in Yorkshire and Humberside with a single point access to a region-wide data and analysis service. The Observatory’s portfolio covered activities relating to applied research and consultancy, intelligence, education and training, publications and networking. The first part of the paper explains the concept of the Observatory as it was initially conceived as a form of partnership across all the universities in the region, outlines the structure of the organization that was created, explains the arrangements for operating the Observatory as a partnership initiative, and exemplifies the outputs and achievements during the first half of the decade. In order to facilitate its regional monitoring activities, ReRO constructed a Regional Intelligence Centre (RIC), a customised geographical information system in which to store key data sets and generate a range of statistical indicators for the region as a whole or its constituent parts. The second part of the paper explains the structure of the RIC and its contents. It argues that the main advantage that derives from the construction of such a centre is the value that is added to raw information through data handling and integration, through skilled interpretation and through the provision of new information, maybe in the form of forecasts of what is likely to happen in the future, as well as analyses of what has happened in the past. The third and final part of the paper explores some of the key issues and difficulties relating to the operation of the Observatory and considers some of the reasons that have accounted for its loss of momentum in the last few years. This has occurred over a period of increased political attention to regional administration and planning in the UK, exemplified by the creation of Scottish and Welsh Assemblies and the emergence of Regional Development Agencies and Regional Assemblies across England. A retrospective evaluation demonstrates a number of lessons that have been learnt and provides a number of useful guidelines to those attempting to establish similar structures elsewhere in the developed world

Sustainable Development Report: Blockchain, the Web3 & the SDGs

This is an output paper of the applied research that was conducted between July 2018 - October 2019 funded by the Austrian Development Agency (ADA) and conducted by the Research Institute for Cryptoeconomics at the Vienna University of Economics and Business and RCE Vienna (Regional Centre of Expertise on Education for Sustainable Development).Series: Working Paper Series / Institute for Cryptoeconomics / Interdisciplinary Researc