Waveforms for the Massive MIMO Downlink: Amplifier Efficiency, Distortion and Performance

In massive MIMO, most precoders result in downlink signals that suffer from high PAR, independently of modulation order and whether single-carrier or OFDM transmission is used. The high PAR lowers the power efficiency of the base station amplifiers. To increase power efficiency, low-PAR precoders have been proposed. In this article, we compare different transmission schemes for massive MIMO in terms of the power consumed by the amplifiers. It is found that (i) OFDM and single-carrier transmission have the same performance over a hardened massive MIMO channel and (ii) when the higher amplifier power efficiency of low-PAR precoding is taken into account, conventional and low-PAR precoders lead to approximately the same power consumption. Since downlink signals with low PAR allow for simpler and cheaper hardware, than signals with high PAR, therefore, the results suggest that low-PAR precoding with either single-carrier or OFDM transmission should be used in a massive MIMO base station

Partial-Data Superimposed Training with Data Precoding for OFDM Systems

Superimposed training (ST) is a recently addressed technique used for channel estimation where known training sequences are arithmetically added to data symbols, avoiding the use of dedicated pilot subcarriers, and thus, increasing the available bandwidth compared with traditional pilot symbol assisted modulation schemes. However, the system handles data interference over channel estimation as a result of the ST process; also, data detection is degraded by pilot interference. Recent ST methods have analyzed the data interference and presented schemes that deal with it. We propose a novel superimposed model over a precoded data scheme, named partial-data superimposed training (PDST), where an interference control factor assigns the adequate information level to be added to the training sequence in orthogonal frequency division multiplexing systems. Also, a data detection method is introduced to improve the symbol error rate performance. Moreover, a capacity analysis of the system has been derived. Finally, simulation results confirm that performance of PDST is superior to previous proposals

Democratic Representations

Minimization of the $\ell_{\infty}$ (or maximum) norm subject to a constraint that imposes consistency to an underdetermined system of linear equations finds use in a large number of practical applications, including vector quantization, approximate nearest neighbor search, peak-to-average power ratio (or "crest factor") reduction in communication systems, and peak force minimization in robotics and control. This paper analyzes the fundamental properties of signal representations obtained by solving such a convex optimization problem. We develop bounds on the maximum magnitude of such representations using the uncertainty principle (UP) introduced by Lyubarskii and Vershynin, and study the efficacy of $\ell_{\infty}$-norm-based dynamic range reduction. Our analysis shows that matrices satisfying the UP, such as randomly subsampled Fourier or i.i.d. Gaussian matrices, enable the computation of what we call democratic representations, whose entries all have small and similar magnitude, as well as low dynamic range. To compute democratic representations at low computational complexity, we present two new, efficient convex optimization algorithms. We finally demonstrate the efficacy of democratic representations for dynamic range reduction in a DVB-T2-based broadcast system.Comment: Submitted to a Journa

Single-Frequency Network Terrestrial Broadcasting with 5GNR Numerology

L'abstract è presente nell'allegato / the abstract is in the attachmen

Interference mitigation using group decoding in multiantenna systems

fi=vertaisarvioitu|en=peerReviewed

Performance enhancement for LTE and beyond systems

A thesis submitted to the University of Bedfordshire, in partial fulfilment of the requirements for the degree of Doctor of PhilosophyWireless communication systems have undergone fast development in recent years. Based on GSM/EDGE and UMTS/HSPA, the 3rd Generation Partnership Project (3GPP) specified the Long Term Evolution (LTE) standard to cope with rapidly increasing demands, including capacity, coverage, and data rate. To achieve this goal, several key techniques have been adopted by LTE, such as Multiple-Input and Multiple-Output (MIMO), Orthogonal Frequency-Division Multiplexing (OFDM), and heterogeneous network (HetNet). However, there are some inherent drawbacks regarding these techniques. Direct conversion architecture is adopted to provide a simple, low cost transmitter solution. The problem of I/Q imbalance arises due to the imperfection of circuit components; the orthogonality of OFDM is vulnerable to carrier frequency offset (CFO) and sampling frequency offset (SFO). The doubly selective channel can also severely deteriorate the receiver performance. In addition, the deployment of Heterogeneous Network (HetNet), which permits the co-existence of macro and pico cells, incurs inter-cell interference for cell edge users. The impact of these factors then results in significant degradation in relation to system performance. This dissertation aims to investigate the key techniques which can be used to mitigate the above problems. First, I/Q imbalance for the wideband transmitter is studied and a self-IQ-demodulation based compensation scheme for frequencydependent (FD) I/Q imbalance is proposed. This combats the FD I/Q imbalance by using the internal diode of the transmitter and a specially designed test signal without any external calibration instruments or internal low-IF feedback path. The instrument test results show that the proposed scheme can enhance signal quality by 10 dB in terms of image rejection ratio (IRR). In addition to the I/Q imbalance, the system suffers from CFO, SFO and frequency-time selective channel. To mitigate this, a hybrid optimum OFDM receiver with decision feedback equalizer (DFE) to cope with the CFO, SFO and doubly selective channel. The algorithm firstly estimates the CFO and channel frequency response (CFR) in the coarse estimation, with the help of hybrid classical timing and frequency synchronization algorithms. Afterwards, a pilot-aided polynomial interpolation channel estimation, combined with a low complexity DFE scheme, based on minimum mean squared error (MMSE) criteria, is developed to alleviate the impact of the residual SFO, CFO, and Doppler effect. A subspace-based signal-to-noise ratio (SNR) estimation algorithm is proposed to estimate the SNR in the doubly selective channel. This provides prior knowledge for MMSE-DFE and automatic modulation and coding (AMC). Simulation results show that this proposed estimation algorithm significantly improves the system performance. In order to speed up algorithm verification process, an FPGA based co-simulation is developed. Inter-cell interference caused by the co-existence of macro and pico cells has a big impact on system performance. Although an almost blank subframe (ABS) is proposed to mitigate this problem, the residual control signal in the ABS still inevitably causes interference. Hence, a cell-specific reference signal (CRS) interference cancellation algorithm, utilizing the information in the ABS, is proposed. First, the timing and carrier frequency offset of the interference signal is compensated by utilizing the cross-correlation properties of the synchronization signal. Afterwards, the reference signal is generated locally and channel response is estimated by making use of channel statistics. Then, the interference signal is reconstructed based on the previous estimate of the channel, timing and carrier frequency offset. The interference is mitigated by subtracting the estimation of the interference signal and LLR puncturing. The block error rate (BLER) performance of the signal is notably improved by this algorithm, according to the simulation results of different channel scenarios. The proposed techniques provide low cost, low complexity solutions for LTE and beyond systems. The simulation and measurements show good overall system performance can be achieved

Improved Hybrid Blind PAPR Reduction Algorithm for OFDM Systems

The ever growing demand for high data rate communication services resulted into the development of long-term evolution (LTE) technology. LTE uses orthogonal frequency division multiplexing (OFDM) as a transmission technology in its PHY layer for down-link (DL) communications. OFDM is spectrally efficient multicarrier modulation technique ideal for high data transmissions over highly time and frequency varying channels. However, the transmitted signal in OFDM can have high peak values in the time domain due to inverse fast Fourier transform (IFFT) operation. This creates high peak-to-average power ratio (PAPR) when compared to single carrier systems. PAPR drives the power amplifiers to saturation degrading its efficiency by consuming more power. In this paper a hybrid blind PAPR reduction algorithm for OFDM systems is proposed, which is a combination of distortion technique (Clipping) and distortionless technique (DFT spreading). The DFT spreading is done prior to clipping reducing significantly the probability of having higher peaks in the composite signal prior to transmission. Simulation results show that the proposed algorithm outperforms unprocessed conventional OFDM transmission by 9 dB. Comparison with existing blind algorithms shows 7 dB improvement at error rate 10–3 and 3 dB improvement at error rate 10–1 when operating in flat fading and doubly dispersive channels, respectively.Keywords:    LTE Systems; OFDM; Peak to Average Power Ratio; DFT spreading; Signal to Noise Power Ratio

Low complexity receivers for single carrier large-scale spatial modulation systems

The dissertation aims to study the low-complexity receivers for Single Carrier (SC) systems and generalized spatial modulation (GSM) in order to reduce the number of radio frequency (RF) chains used in the emitter and making the system more efficient energetically. In the first instance, the study addressed the use of multiple-Input multipleOutput (MIMO) schemes in conjunction with GSM in SC systemsin order to increase the throughput of a telecommunications network without diminishing energy efficiency. This study was followed by the development of an algorithm based on the alternating Direction method of Multipliers (ADMM) as a low-complexity receiver intending to achieve performances close to the optimal Maximum Likelihood Detector (MLD). The study of the ADMM receptor was done in two stages, the first step consists of the exclusive study of the ADMM receptor is SC systems where the main parameters of the receiver are tested. The second step compared the ADMM receiver with other receivers, namely the MMSE and the Zero Forcing in severe time dispersive environments. The realization of the various simulations with various receivers and scenarios allows to demonstrate that the ADMM can be an efficient and robust alternative. The referred technologies promote the reduction of the ecological footprint and the development of the technologies.A dissertação visa estudar os receptores de baixa complexidade para sistemas "Single Carrier" (SC) e modulações espaciais generalizadas (GSM) de modo a reduzir o número de cadeias radio frequência (RF) utilizadas no emissor e tornando o sistema mais eficiente energeticamente. Em primeira instância o estudo apresentado abordou a utilização de esquemas "Multiple-Input Multiple-Output" (MIMO) em conjunto com o GSM em sistemas SC de forma a aumentar o "throughput" de uma rede de telecomunicações sem que a eficiência energética diminua. De seguida foi realizado o estudo de um algoritmo baseado no método "Alternating Direction Method of Multipliers" (ADMM) como um receptor de baixa complexidade, pretendendo-se obter desempenhos próximos do receptor ótimo "Maximum Likelihood Detector" (MLD). O estudo do receptor ADMM foi feito em duas etapas. A primeira etapa consistiu no estudo exclusivo do receptor ADMM onde foram testados os parâmetros principais do receptor. A segunda etapa consistiu em comparar o receptor ADMM com outros receptores, nomeadamente o MMSE e o Zero Forcing em ambiente altamente dispersivo no tempo. A realização das diversas simulações com vários receptores e cenários, permitiu demonstrar que o ADMM pode ser uma alternativa bastante eficiente e robusta. As tecnologias referidas promovem a diminuição da pegada ecológica e o desenvolvimento das mesmas