Spectroscopy of Global Dust/Soils Particles and their Optical Constants for use in Radiative Transfer Models and Remote Sensing

Mineral dust particles dominate aerosol mass in the atmosphere and directly modify Earth’s radiative balance through absorption and scattering. This radiative forcing varies strongly with mineral composition and optical properties (e.g., optical constants), yet there is still limited knowledge about these aspects of atmospheric mineral dust. In this study we examined both airfall dust and surface soils from dust entrainment regions in order to characterize their constituent mineralogy, spectral and optical properties. We first measured 37 airfall dust samples using visible, shortwave infrared (VSWIR) reflectance spectroscopy, combined with a Hapke radiative transfer model to identify their spectral diversity, mineralogy, and mineral abundances. We next investigated the diversity in the mineralogical composition and spectra of 26 global surface soil samples using VSWIR and longwave infrared (LWIR) reflectance, as well as LWIR transmission and conducted linear spectral mixture (LSM) modeling on the transmission data. We compared the mineralogy and mineral abundances derived using spectroscopy with results obtained with x-ray diffraction (XRD) and optical mineralogy (OM). The results for soil and airfall dust samples show that VSWIR is very sensitive to iron-bearing minerals and non-mineral components and better identifies their type compared to XRD and OM. Although clay minerals and carbonates have a multiple SWIR absorption signatures, they frequently overlap, making it difficult to ascribe specific spectral features to them. For the airfall dust, the derived abundance values for total clays and carbonate obtained from XRD and SWIR spectroscopy correlate, however the former technique somewhat underpredicts clays and the latter technique significantly underpredicts carbonates. LWIR reflectance for soils easily distinguishes various carbonates from the band center shifts, even in trace amounts that were not identified with other techniques. LWIR reflectance for silicates are more complicated to interpret and to model using LSM. On the other hand, the strongest absorptions in LWIR transmission spectra of soils are caused by the interaction and overlapping of absorptions of multiple silicates. Despite this, there is often good agreement between the determined mineralogy from LSM modeling of transmission and the results from XRD. In the final step, we employed transmission spectral measurements in order to estimate optical constants for same the 26 global soil samples. Because mineral mixtures were successfully retrieved by LSM modeling of LWIR transmission spectra we anticipate that the estimated dust aerosol optical constants (imaginary (k) and real (n) indices of refraction) features are representative of these mineral mixtures. The k spectra were derived from transmission spectra of KBr pellets containing dispersed dust and the n spectra were estimated with the subtractive Kramers–Kronig (SKK) method. Our values were compared to past studies where we observe additional spectral diversity in optical constants for these samples. The magnitude and spectral shape of k and n obtained from our soil samples are in good agreement with previously published values that used dust aerosols re-suspended in a chamber. This suggests these soils are a good analog to suspended mineral dust. We note the SKK method can offer a reliable mechanism for measuring IR spectra of both optical constants for soils. The spectral measurements and optical constants presented in this research can be used to improve global soil atlases and to support interpretation and validation of data from current and future remote sensing instruments

Caracterização e estudo comparativo de exsudações de hidrocarbonetos e plays petrolíferos em bacias terrestres das regiões central do Irã e sudeste do Brasil usando sensoriamento remoto espectral

Orientador: Carlos Roberto de Souza FilhoTese (doutorado) - Universidade Estadual de Campinas, Instituto de GeociênciasResumo: O objetivo desta pesquisa foi explorar as assinaturas de exsudações de hidrocarbonetos na superfície usando a tecnologia de detecção remota espectral. Isso foi alcançado primeiro, realizando uma revisão abrangente das capacidades e potenciais técnicas de detecção direta e indireta. Em seguida, a técnica foi aplicada para investigar dois locais de teste localizados no Irã e no Brasil, conhecidos por hospedar sistemas ativos de micro-exsudações e afloramentos betuminosos, respectivamente. A primeira área de estudo está localizada perto da cidade de Qom (Irã), e está inserida no campo petrolífero Alborz, enterrado sob sedimentos datados do Oligoceno da Formação Upper Red. O segundo local está localizado perto da cidade de Anhembi (SP), na margem oriental da bacia do Paraná, no Brasil, e inclui acumulações de betume em arenitos triássicos da Formação Pirambóia. O trabalho na área de Qom integrou evidências de (i) estudos petrográficos e geoquímicos em laboratório, (ii) investigações de afloramentos em campo, e (iii) mapeamento de anomalia em larga escala através de conjuntos de dados multi-espectrais ASTER e Sentinel-2. O resultado deste estudo se trata de novos indicadores mineralógicos e geoquímicos para a exploração de micro-exsudações e um modelo de micro-exsudações atualizado. Durante este trabalho, conseguimos desenvolver novas metodologias para análise de dados espectroscópicos. Através da utilização de dados simulados, indicamos que o instrumento de satélite WorldView-3 tem potencial para detecção direta de hidrocarbonetos. Na sequência do estudo, dados reais sobre afloramentos de arenitos e óleo na área de Anhembi foram investigados. A área foi fotografada novamente no chão e usando o sistema de imagem hiperespectral AisaFENIX. Seguiu-se estudos e amostragem no campo,incluindo espectroscopia de alcance fechado das amostras no laboratório usando instrumentos de imagem (ou seja, sisuCHEMA) e não-imagem (ou seja, FieldSpec-4). O estudo demonstrou que uma abordagem espectroscópica multi-escala poderia fornecer uma imagem completa das variações no conteúdo e composição do betume e minerais de alteração que acompanham. A assinatura de hidrocarbonetos, especialmente a centrada em 2300 nm, mostrou-se consistente e comparável entre as escalas e capaz de estimar o teor de betume de areias de petróleo em todas as escalas de imagemAbstract: The objective of this research was to explore for the signatures of seeping hydrocarbons on the surface using spectral remote sensing technology. It was achieved firstly by conducting a comprehensive review of the capacities and potentials of the technique for direct and indirect seepage detection. Next, the technique was applied to investigate two distinctive test sites located in Iran and Brazil known to retain active microseepage systems and bituminous outcrops, respectively. The first study area is located near the city of Qom in Iran, and consists of Alborz oilfield buried under Oligocene sediments of the Upper-Red Formation. The second site is located near the town of Anhembi on the eastern edge of the Paraná Basin in Brazil and includes bitumen accumulations in the Triassic sandstones of the Pirambóia Formation. Our work in Qom area integrated evidence from (i) petrographic, spectroscopic, and geochemical studies in the laboratory, (ii) outcrop investigations in the field, and (iii) broad-scale anomaly mapping via orbital remote sensing data. The outcomes of this study was novel mineralogical and geochemical indicators for microseepage characterization and a classification scheme for the microseepage-induced alterations. Our study indicated that active microseepage systems occur in large parts of the lithofacies in Qom area, implying that the extent of the petroleum reservoir is much larger than previously thought. During this work, we also developed new methodologies for spectroscopic data analysis and processing. On the other side, by using simulated data, we indicated that WorldView-3 satellite instrument has the potential for direct hydrocarbon detection. Following this demonstration, real datasets were acquired over oil-sand outcrops of the Anhembi area. The area was further imaged on the ground and from the air by using an AisaFENIX hyperspectral imaging system. This was followed by outcrop studies and sampling in the field and close-range spectroscopy in the laboratory using both imaging (i.e. sisuCHEMA) and nonimaging instruments. The study demonstrated that a multi-scale spectroscopic approach could provide a complete picture of the variations in the content and composition of bitumen and associated alteration mineralogy. The oil signature, especially the one centered at 2300 nm, was shown to be consistent and comparable among scales, and capable of estimating the bitumen content of oil-sands at all imaging scalesDoutoradoGeologia e Recursos NaturaisDoutor em Geociências2015/06663-7FAPES

Interpretation of the Reflectance Spectra of Lithium (Li) Minerals and Pegmatites: A Case Study for Mineralogical and Lithological Identification in the Fregeneda-Almendra Area

Reflectance spectroscopy has been used to identify several deposit types. However, applications concerning lithium (Li)-pegmatites are still scarce. Reflectance spectroscopic studies complemented by microscopic and geochemical studies were employed in the Fregeneda-Almendra (Spain-Portugal) pegmatite field to analyze the spectral behavior of Li-minerals and field lithologies. The spectral similarity of the target class (Li-pegmatites) with other elements was also evaluated. Lepidolite was discriminated from other white micas and the remaining Li-minerals. No diagnostic feature of petalite and spodumene was identified, since their spectral curves are dominated by clays. Their presence was corroborated (by complementary techniques) in petalite relics and completely replaced crystals, although the clay-related absorption depths decrease with Li content. This implies that clays can be used as pathfinders only in areas where argillic alteration is not prevalent. All sampled lithologies present similar water and/or hydroxide features. The overall mineral assemblage is very distinct, with lepidolite, cookeite, and orthoclase exclusively identified in Li-pegmatite (being these minerals crucial targets for Li-pegmatite discrimination in real-life applications), while chlorite and biotite can occur in the remaining lithologies. Satellite data can be used to discriminate Li-pegmatites due to distinct reflectance magnitude and mineral assemblages, higher absorptions depths, and distinct Al-OH wavelength position. The potential use of multi- and hyperspectral data was evaluated; the main limitations and advantages were discussed. These new insights on the spectral behavior of Li-minerals and pegmatites may aid in new Li-pegmatite discoveries around the world

Scale-Wavelength Decomposition of Hyperspectral Signals - Use for Mineral Classification & Quantification

An approach for material identification & soil constituent quantification based on a generalized multi-scale derivative analysis of hyperspectral signals is presented. It employs the continuous wavelet transform to project input spectra onto a scale-wavelength space. This allows investigating the spectra at selectable level of detail while normalizing/separating disturbances. Benefits & challenges of this decomposition for mineral classification & quantification will be shown for a mining site

Mapping hydrothermal and supergene alteration zones associated with carbonate-hosted Zn-Pb deposits by using PRISMA satellite imagery supported by field-based hyperspectral data, mineralogical and geochemical analysis

Delineating hydrothermal alteration and supergene caps is fundamental for mineral exploration of sulfide ores. The aim of this study is to apply a multi-scale workflow based on hyperspectral remote and proximal sensing data in order to delineate hydrothermal dolomitization and supergene alteration associated with the Mississippi Valley-Type Zn-Pb(-Ag) deposit of Jabali (Western Yemen). The area was investigated through hyperspectral images derived from the new launched Italian Space Agency's PRISMA satellite, which has a higher spectral resolution compared to multispectral sensors and covers the mineral-diagnostic wavelength regions (such as the 2100 nm to 2300 nm range) with a Signal to Noise Ratio (SNR) ≥ 100. Spectral mineral maps were produced through the band ratios method using specific feature extraction indices applied to the hyperspectral satellite data. The results were validated by using Visible Near InfraRed (VNIR) to Short Wave InfraRed (SWIR) reflectance spectra, mineralogical (XRPD) and geochemical (ICP-ES/MS) analyses on rock samples collected in the Jabali area. The dolomites footprint was mapped using a PRISMA Level 2C image, by enhancing the spectral differences between limestones and dolomites in the SWIR-2 region (major features centered at 2340 nm and 2320 nm, respectively). Gossans were detected due to the Fe3+ absorption band in the VNIR region at 900 nm. The Zn-Pb mineralized area, extended for approximately 25 km2, was thus identified by recognizing gossan occurrences in dolomites. The study demonstrates that the PRISMA satellite is effective in identifying Zn-Pb mineralized outcrops in sedimentary basins

Analysis of deep-ocean sediments from the TAG hydrothermal field (MAR, 26° N): application of short-wave infrared reflectance (SWIR) spectra for offshore geochemical exploration

Purpose The cost-efficient methods of analysis, such as rapid short-wave infrared (SWIR) spectral analysis, have been applied for the efficient exploration of critical raw materials (CRM), including mineral components and rare earth elements (REE) from the deep-ocean sediments. Methods Gravity cored sediment samples were collected during an oceanographic mission to the Trans-Atlantic Geotraverse (TAG) hydrothermal field of the Mid-Atlantic Ridge (MAR, 26° N). SWIR reflectance spectra (dependent variable) of samples were mathematically tested against referent geochemical data (independent variable), obtained by conventional analysis (ICP/OES, ICP/MS), after applied full cross-validation multivariate partial least square regression (CVPLSR). Value of parameter-residual predictive deviation (RPD) was used for evaluation of CVPLSR modeling: RPD > 2.5 (satisfactory calibration model for the screening purposes) and RPD > 5.0 (model adequate for the quality control of the studied elements). Results The CVPLSR modeling provided significant results for the determination of several mineral components: major elements (Fe and Si) had the values of RPD equal to 3.65 and 2.84, respectively, which indicated a viable potential for their routine analysis, whereas RPD for Ca was equal to 5.51, thus assuring its quality control by SWIR analysis, in sediment samples of the studied location. Among the REE, Ce (RPD = 2.55) and Er (RPD = 2.59) yielded the most satisfactory results. Conclusions The findings highlight the benefit of rapidly obtained empirical SWIR-reflectance data, which can be used for near-real-time exploration of geochemical deposits hosted in deep-ocean sediments