THE PEAK WINDOWING FOR PAPR REDUCTION IN SOFTWARE DEFINED RADIO BASE STATIONS

The utilization of the techniques for Peak to Average Power Ratio (PAPR) reduction makes the wireless infrastructure conform to rigorous telecommunication standard specifications (error vector magnitude (EVM), bit error rate (BER), transmit spectrum mask (TSM)). In modern modulation schemes reduction of PAPR is important requirement for distortion free and energy-efficient operation of power amplifiers (PA). In this paper novel implementation of Peak Windowing method for PAPR reduction in Software Defined Radio (SDR) Base Stations (BS) is presented. The measurement results in terms of EVM and ACPR are given for 5MHz, 10MHz, 15MHz, 20MHz Long-Term Evolution (LTE) and Wideband Code Division Multiple Access (WCDMA) modulations. In case of 10MHz LTE signal, we achieved PAPR=8dB, EVM=2.0%, ACPR -52dBc at modulated PA output, antenna point

Experimental evaluation in wireless communications

This editorial sums up relevant topics on the assessment of wireless communication systems covered by the especial issue entitled "Experimental Evaluation in Wireless Communications". The topics include practical aspects on the implementation of distributed asynchronous non-linear kernel methods over wireless sensor networks; localization methods based on the exploitation of radio-frequency identification (RFID) wireless sensors and cellular networks or on sparsity approximations; channel sounding and assessment of broadband orthogonal frequency-division multiplexing (OFDM)-based wireless systems in high-speed vehicular communications; coexistence analysis of femtocell-based and outdoor-to-indoor systems; techniques for peak-to-average power ratio (PAPR) reduction; new solutions for baseband and radio frequency (RF) hardware impairments in full-duplex wireless systems; and, finally, suitability of interference alignment for broadband indoor wireless communications

PERFORMANCE EVALUATION OF A MULTICARRIER MIMO SYSTEM BASED ON DFT-PRECODING AND SUBCARRIER MAPPING

The ever-increasing end user demands are instigating the development of innovative methods targeting not only data rate enhancement but additionally better service quality in each subsequent wireless communication standard. This quest to achieve higher data rates has compelled the next generation communication technologies to use multicarrier systems e.g. orthogonal frequency division multiplexing (OFDM), while also relying on the multiple-input multiple-output (MIMO) technology. This paper is focused on implementing a MIMO-OFDM system and on using various techniques to optimize it in terms of the bit-error rate performance. The test case considered is a system implementation constituting the enabling technologies for 4G and beyond communication systems. The bit-error rate optimizations considered are based on preceding the OFDM modulation step by Discrete Fourier Transform (DFT) while also considering various subcarrier mapping schemes. MATLAB-based simulation of a 2 × 2 MIMO-OFDM system exhibits a maximum of 2 to 5 orders of magnitude reduction in bit-error rate due to DFT-precoding and subcarrier mapping respectively at high signal-to-noise ratio values in various environments. A 2-3dBs reduction in peak-to-average power ratio due to DFT-precoding in different environments is also exhibited in the various simulations

Linear Operation of Switch-Mode Outphasing Power Amplifiers

Radio transceivers are playing an increasingly important role in modern society. The ”connected” lifestyle has been enabled by modern wireless communications. The demand that has been placed on current wireless and cellular infrastructure requires increased spectral efficiency however this has come at the cost of power efficiency. This work investigates methods of improving wireless transceiver efficiency by enabling more efficient power amplifier architectures, specifically examining the role of switch-mode power amplifiers in macro cell scenarios. Our research focuses on the mechanisms within outphasing power amplifiers which prevent linear amplification. From the analysis it was clear that high power non-linear effects are correctable with currently available techniques however non-linear effects around the zero crossing point are not. As a result signal processing techniques for suppressing and avoiding non-linear operation in low power regions are explored. A novel method of digital pre-distortion is presented, and conventional techniques for linearisation are adapted for the particular needs of the outphasing power amplifier. More unconventional signal processing techniques are presented to aid linearisation of the outphasing power amplifier, both zero crossing and bandwidth expansion reduction methods are designed to avoid operation in nonlinear regions of the amplifiers. In combination with digital pre-distortion the techniques will improve linearisation efforts on outphasing systems with dynamic range and bandwidth constraints respectively. Our collaboration with NXP provided access to a digital outphasing power amplifier, enabling empirical analysis of non-linear behaviour and comparative analysis of behavioural modelling and linearisation efforts. The collaboration resulted in a bench mark for linear wideband operation of a digital outphasing power amplifier. The complimentary linearisation techniques, bandwidth expansion reduction and zero crossing reduction have been evaluated in both simulated and practical outphasing test benches. Initial results are promising and indicate that the benefits they provide are not limited to the outphasing amplifier architecture alone. Overall this thesis presents innovative analysis of the distortion mechanisms of the outphasing power amplifier, highlighting the sensitivity of the system to environmental effects. Practical and novel linearisation techniques are presented, with a focus on enabling wide band operation for modern communications standards

Enhanced Multicarrier Techniques for Professional Ad-Hoc and Cell-Based Communications (EMPhAtiC) Document Number D3.3 Reduction of PAPR and non linearities effects

Livrable d'un projet Européen EMPHATICLike other multicarrier modulation techniques, FBMC suffers from high peak-to-average power ratio (PAPR), impacting its performance in the presence of a nonlinear high power amplifier (HPA) in two ways. The first impact is an in-band distortion affecting the error rate performance of the link. The second impact is an out-of-band effect appearing as power spectral density (PSD) regrowth, making the coexistence between FBMC based broad-band Professional Mobile Radio (PMR) systems with existing narrowband systems difficult to achieve. This report addresses first the theoretical analysis of in-band HPA distortions in terms of Bit Error Rate. Also, the out-of band impact of HPA nonlinearities is studied in terms of PSD regrowth prediction. Furthermore, the problem of PAPR reduction is addressed along with some HPA linearization techniques and nonlinearity compensation approaches

On PAPR Reduction of OFDM using Partial Transmit Sequence with Intelligent Optimization Algorithms

In recent time, the demand for multimedia data services over wireless links has grown up rapidly. Orthogonal Frequency Division Multiplexing (OFDM) forms the basis for all 3G and beyond wireless communication standards due to its efficient frequency utilization permitting near ideal data rate and ubiquitous coverage with high mobility. OFDM signals are prone to high peak-to-average-power ratio (PAPR). Unfortunately, the high PAPR inherent to OFDM signal envelopes occasionally drives high power amplifiers (HPAs) to operate in the nonlinear region of their characteristic leading out-of-band radiation, reduction in efficiency of communication system etc. A plethora of research has been devoted to reducing the performance degradation due to the PAPR problem inherent to OFDM systems. Advanced techniques such as partial transmit sequences (PTS) and selected mapping (SLM) have been considered most promising for PAPR reduction. Such techniques are seen to be efficient for distortion-less signal processing but suffer from computational complexity and often requires transmission of extra information in terms of several side information (SI) bits leading to loss in effective data rate. This thesis investigates the PAPR problem using Partial Transmit Sequence (PTS) scheme, where optimization is achieved with evolutionary bio-inspired metaheuristic stochastic algorithms. The phase factor optimization in PTS is used for PAPR reduction. At first, swarm intelligence based Firefly PTS (FF-PTS) algorithm is proposed which delivers improved PAPR performance with reduced searching complexity. Following this, Cuckoo Search based PTS (CS-PTS) technique is presented, which offers good PAPR performance in terms of solution quality and convergence speed. Lastly, Improved Harmony search based PTS (IHS-PTS) is introduced, which provides improved PAPR. The algorithm has simple structure with a very few parameters for larger PTS sub-blocks. The PAPR performance of the proposed technique with different parameters is also verified through extensive computer simulations. Furthermore, complexity analysis of algorithms demonstrates that the proposed schemes offer significant complexity reduction when compared to standard PAPR reduction techniques. Findings have been validated through extensive simulation tests

The First 15 Years of SEFDM: A Brief Survey

Spectrally efficient frequency division multiplexing (SEFDM) is a multi-carrier signal waveform, which achieves higher spectral efficiency, relative to conventional orthogonal frequency division multiplexing (OFDM), by violating the orthogonality of its sub-carriers. This survey provides the history of SEFDM development since its inception in 2003, covering fundamentals and concepts, wireless and optical communications applications, circuit design and experimental testbeds. We focus on work done at UCL and outline work done other universities and research laboratories worldwide. We outline techniques to improve the performance of SEFDM and its practical utility with focus on signal generation, detection and channel estimation

Design and Characterization of Power Converters and Amplifiers for Supply-Modulation based Transmitter Architectures

The rapid evolution of telecommunication systems has strongly influenced our lives, and the way we communicate and exchange information. Nevertheless, much progress is expected to happen in the next years with the introduction of new generations of wireless communications standards, which require signals with large bandwidth and very high Peak-to-Average Power Ratio (PAPR) in order to enhance the spectral efficiency and maximize the data rate. However, such developments can only take place through the evolution of Radio-Frequency (RF) which should be capable of working at higher frequencies, higher bandwidth and with higher efficiencies than before. In order to meet these demanding specifications, transmitter architectures have to evolve from a single linear RF Power-Amplifier (PA) into more complex architectures. Envelope Tracking (ET) is one of the most promising solutions for the efficiency-enhancement of next generation transmitters. The research described in this thesis aims to provide solutions to enhance the efficiency of the RF PA by means of an ET architecture. To this purpose, a novel discrete level supply modulator is investigated, which is based on a direct digital-to-analog power conversion. This supply modulator is capable of synthesizing eight voltage steps by means of three isolated voltage sources, thus behaving like a Power Digital-to-Analog Converter (Power-DAC). A hybrid version of the Power-DAC exploiting very fast GaN devices is developed and tested with an L-band PA achieving efficiency improvement up to 13% with 10 MHz of bandwidth. Furthermore, a monolithic GaN version of the Power-DAC is prototyped and tested with an X-band PA achieving efficiency improvement up to 20% and bandwidth of 20 MHz. This supply modulator is tested with outphasing PAs showing promising results with modulated signals and efficiency improvement up to 9%. Finally, dispersive phenomena, which affect PAs and switches in supply modulators, are investigated, characterized and modeled

Intelligent genetic algorithms for next-generation broadband multi-carrier CDMA wireless networks

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This dissertation proposes a novel intelligent system architecture for next-generation broadband multi-carrier CDMA wireless networks. In our system, two novel and similar intelligent genetic algorithms, namely Minimum Distance guided GAs (MDGAs) are invented for both peak-to-average power ratio (PAPR) reduction at the transmitter side and multi-user detection (MUD) at the receiver side. Meanwhile, we derive a theoretical BER performance analysis for the proposed MC-CDMA system in A WGN channel. Our analytical results show that the theoretical BER performance of synchronized MC-CDMA system is the same as that of the synchronized DS-CDMA system which is also used as a theoretical guidance of our novel MUD receiver design. In contrast to traditional GAs, our MDGAs start with a balanced ratio of exploration and exploitation which is maintained throughout the process. In our algorithms, a new replacement strategy is designed which increases significantly the convergence rate and reduces dramatically computational complexity as compared to the conventional GAs. The simulation results demonstrate that, if compared to those schemes using exhaustive search and traditional GAs, (1) our MDGA-based P APR reduction scheme achieves 99.52% and 50+% reductions in computational complexity, respectively; (2) our MDGA-based MUD scheme achieves 99.54% and 50+% reductions in computational complexity, respectively. The use of one core MDGA solution for both issues can ease the hardware design and dramatically reduce the implementation cost in practice

On Efficient Signal Processing Algorithms for Signal Detection and PAPR Reduction in OFDM Systems

The driving force of the study is susceptibility of LS algorithm to noise. As LS algorithm is simple to implement, hence it’s performance improvement can contribute a lot to the wireless technology that are especially deals with high computation. Cascading of AdaBoost algorithm with LS greatly influences the OFDM system performance. Performance of Adaptive Boosting based symbol recovery was investigated on the performance of LS, MMSE, BLUE were also compared with the performance of AdaBoost algorithm and MMSE has been found the higher computational complexity. Furthermore, MMSE also requires apriori channel statistics and computational complexity O(5N3) of the MMSE increases exponentially as the number of carrier increases. For the Adaboost case the computational complexity calculation is little different.Therefore, in the training stage of the AdaBoost algorithm, the computational complexity is only O(nT M) Furthermore, as it is a classification algorithm so in the receiver side we will require a separate de-mapper (or decoder) to get the desired data bits, i.e., a. SAS aided DCT based PAPR reduction 1326 and b. SAS aided DCT based PAPR reduction. A successive addition subtraction preprocessed DCT based PAPR reduction technique was proposed. Here, the performance of proposed method was compared with other preexisting techniques like SLM and PTS and the performance of the proposed method was seen to outperform specially in low PAPR region. In the proposed PAPR reduction method, the receiver is aware of the transmitted signal processing, this enables a reverse operation at the receiver to extract the transmit data. Hence the requirement of sending extra information through extra subcarrier is eliminated. The proposed method is also seen to be spectrally efficient. In the case of PTS and SLM it is inevitable to send the side information to retrieve the transmit signal. Hence, these two methods are spectrally inefficient. Successive addition subtraction based PAPR reduction method was also applied to MIMO systems. The performance of the SAS based PAPR reduction method also showed better performance as compared to other technique. An extensive simulation of MIMO OFDM PAPR reduction was carried out by varying the number of subcarriers and number of transmitter antennas. A detailed computational complexity analysis was also carried out. BATE aided SDMA multi user detection. A detailed study of SDMA system was carried out with it’s mathematical analysis.Many linear and non linear detectors like ML, MMSE, PIC, SIC have been proposed in literature for multiuser detection of SDMA system. However, except MMSE every receivers other are computational extensive. So as to enhance the performance of the MMSE MUD a meta heuristic Bat algorithm was incorporated in cascade with MMSE