GeoSAR Feasibility Study: Summary of the Group Design Project. MSc in Astronautics and Space Engineering 2012/13

Students of the MSc course in Astronautics and Space Engineering 2012–13 at Cranfield University performed a feasibility study of a geosynchronous radar mission for their group project. This report summarises the students’ work and their findings. The report consists of an overview and discussion of the technical work of the project and a compilation of the executive summaries which describe the specific contributions of each student. The mission studied is a Ku-band monostatic SAR in a small inclination (80 km relative orbit diameter) geosynchronous orbit. The total launch mass is 2 tonnes, and images with resolution 40 m to monitor land subsidence in urban areas are produced. The mission appears to be feasible within the scope of an ESA Earth Explorer proposal

Research progress on geosynchronous synthetic aperture radar

Based on its ability to obtain two-dimensional (2D) high-resolution images in all-time and all-weather conditions, spaceborne synthetic aperture radar (SAR) has become an important remote sensing technique and the study of such systems has entered a period of vigorous development. Advanced imaging modes such as radar interferometry, tomography, and multi-static imaging, have been demonstrated. However, current in-orbit spaceborne SARs, which all operate in low Earth orbits, have relatively long revisit times ranging from several days to dozens of days, restricting their temporal sampling rate. Geosynchronous SAR (GEO SAR) is an active research area because it provides significant new capability, especially its much-improved temporal sampling. This paper reviews the research progress of GEO SAR technologies in detail. Two typical orbit schemes are presented, followed by the corresponding key issues, including system design, echo focusing, main disturbance factors, repeat-track interferometry, etc, inherent to these schemes. Both analysis and solution research of the above key issues are described. GEO SAR concepts involving multiple platforms are described, including the GEO SAR constellation, GEO-LEO/airborne/unmanned aerial vehicle bistatic SAR, and formation flying GEO SAR (FF-GEO SAR). Due to the high potential of FF-GEO SAR for three-dimensional (3D) deformation retrieval and coherence-based SAR tomography (TomoSAR), we have recently carried out some research related to FF-GEO SAR. This research, which is also discussed in this paper, includes developing a formation design method and an improved TomoSAR processing algorithm. It is found that GEO SAR will continue to be an active topic in the aspect of data processing and multi-platform concept in the near future

Laplace plane GeoSAR feasibility study: summary of the group design project MSc in astronautics and space engineering 2014-15, Cranfield University

Students of the MSc course in Astronautics and Space Engineering 2014-15 at Cranfield University performed a feasibility study of a geosynchronous radar mission for their group project. This report summarises the students' work and their findings. The report consists of an overview and discussion of the technical work of the project and a compilation of the executive summaries which describe the special contributions of each student. The mission studied is a geosynchronous synthetic aperture radar Earth observation mission using the Laplace orbit plane to reduce station-keeping propulsion demand. User applications are drawn from a wide range of sectors (agriculture, meteorology, geohazards, etc.) and are translated into system design requirements. The proposed mission design uses satellites with 13 m diameter antennas and a total electrical power demand of 6 kW. The mission seems feasible, although further study is recommended especially for the areas of _ orbit selection with respect to user requirements, imaging performance and orbit maintenance, _ mass budget (driven largely by the propulsion system), _ user requirements, imaging performance and operational imaging modes, _ opportunities for improved imaging with a constellation

High-Temporal-Resolution High-Spatial-Resolution Spaceborne SAR Based on Continuously Varying PRF

Synthetic Aperture Radar (SAR) is a well-established and powerful imaging technique for acquiring high-spatial-resolution images of the Earth's surface. With the development of beam steering techniques, sliding spotlight and staring spotlight modes have been employed to support high-spatial-resolution applications. In addition to this strengthened high-spatial-resolution and wide-swath capability, high-temporal-resolution (short repeat-observation interval) represents a key capability for numerous applications. However, conventional SAR systems are limited in that the same patch can only be illuminated for several seconds within a single pass. This paper considers a novel high-squint-angle system intended to acquire high-spatial-resolution spaceborne SAR images with repeat-observation intervals varying from tens of seconds to several minutes within a single pass. However, an exponentially increased range cell migration would arise and lead to a conflict between the receive window and 'blind ranges'. An efficient data acquisition technique for high-temporal-resolution, high-spatial-resolution and high-squint-angle spaceborne SAR, in which the pulse repetition frequency (PRF) is continuously varied according to the changing slant range, is presented in this paper. This technique allows echo data to remain in the receive window instead of conflicting with the transmitted pulse or nadir echo. Considering the precision of hardware, a compromise and practical strategy is also proposed. Furthermore, a detailed performance analysis of range ambiguities is provided with respect to parameters of TerraSAR-X. For strong point-like targets, the range ambiguity of this technique would be better than that of uniform PRF technique. For this innovative technique, a resampling strategy and modified imaging algorithm have been developed to handle the non-uniformly sampled echo data. Simulations are performed to validate the efficiency of the proposed technique and the associated imaging algorithm

Technology for large space systems: A bibliography with indexes (supplement 13)

This bibliography lists 399 reports, articles and other documents introduced into the NASA scientific and technical information system between January 1, 1985 and June 30, 1985. Its purpose is to provide helpful information to the researcher, manager, and designer in technology development and mission design according to system, interactive analysis and design, structural and thermal analysis and design, structural concepts and control systems, electronics, advanced materials, assembly concepts, propulsion, and solar power satellite systems

Technologies and methods employed to design a university-class microsatellite, according to ESA Standards

The objective of this thesis is the study of the applicability of ESA (European Space Agency) standards to university-class microsatellites missions. At the same time the university microsatellite design technologies used to manufacture EduSAT spacecraft have been investigated in depth and ESA standards have been applied during the EduSAT mission phases. Afterwards a micro satellite optical payload for in-orbit space environment monitoring has been designed, exploiting useful instruments provided by ESA ECSS (European Cooperation for Space Standardization) standards

Lasers for Satellite Uplinks and Downlinks

The article of record as published may be found at http://dx.doi.org/10.3390/sci2030071The use of Light Amplification by Stimulated Emission of Radiation (i.e., LASERs or lasers) by the U.S. Department of Defense is not new and includes laser weapons guidance, laser-aided measurements, even lasers as weapons (e.g., Airborne Laser). Lasers in support of telecommunications is also not new. The use of laser light in fiber optics shattered thoughts on communications bandwidth and throughput. Even the use of lasers in space is no longer new. Lasers are being used for satellite-to-satellite crosslinking. Laser communication can transmit orders-of-magnitude more data using orders-of-magnitude less power and can do so with minimal risk of exposure to the sending and receiving terminals. What is new is using lasers as the uplink and downlink between the terrestrial segment and the space segment of satellite systems. More so, the use of lasers to transmit and receive data between moving terrestrial segments (e.g., ships at sea, airplanes in flight) and geosynchronous satellites is burgeoning. This manuscript examines the technological maturation of employing lasers as the signal carrier for satellite communications linking terrestrial and space systems. The purpose of the manuscript is to develop key performance parameters (KPPs) to inform U.S. Department of Defense initial capabilities documents (ICDs) for near-future satellite acquisition and development. By appreciating the history and technological challenges of employing lasers rather than traditional radio frequency sources for satellite uplink and downlink signal carrier, this manuscript recommends ways for the U.S. Department of Defense to employ lasers to transmit and receive high bandwidth, large-throughput data from moving platforms that need to retain low probabilities of detection, intercept, and exploitation (e.g., carrier battle group transiting to a hostile area of operations, unmanned aerial vehicle collecting over adversary areas). The manuscript also intends to identify commercial sector early-adopter fields and those fields likely to adapt to laser employment for transmission and receipt.U.S. Air Forc

Application of advanced technology to space automation

Automated operations in space provide the key to optimized mission design and data acquisition at minimum cost for the future. The results of this study strongly accentuate this statement and should provide further incentive for immediate development of specific automtion technology as defined herein. Essential automation technology requirements were identified for future programs. The study was undertaken to address the future role of automation in the space program, the potential benefits to be derived, and the technology efforts that should be directed toward obtaining these benefits

PLACE: Post LANDSAT D Advanced Concept Evaluation

There are no author-identified significant results in this report

Geosynchronous synthetic aperture radar for Earth continuous observation missions

This thesis belongs to the field of remote sensing, particularly Synthetic Aperture Radar (SAR) systems from the space. These systems acquire the signals along the orbital track of one or more satellites where the transmitter and receiver are mounted, and coherently process the echoes in order to form the synthetic aperture. So, high resolution images can be obtained without using large arrays of antennas. The study presented in this thesis is centred in a novel concept in SAR, which is known as Geosynchronous SAR or GEOSAR, where the transmitter and/or receiver are placed in a platform in a geostationary orbit. In this case, the small relative motions between the satellite and the Earth surface are taken to get the necessary motion to form the synthetic aperture and focus the image. The main advantage of these systems with respect to the current technology (where LEO satellites with lower height are considered) is the possibility of permanently acquire images from the same region thanks to the small motion of the platform. Therefore, the different possibilities in the orbital design that offer this novel technology as well as the geometric resolutions obtained in the final image have been firstly studied. However, the use of geosynchronous satellites as illuminators results in slant ranges between 35.000-38.000 Km, which are much higher than the typical values obtained in LEOSAR, under 1.000 Km. Fortunately, the slow motion of the satellite makes possible large integration of pulses during minutes or even hours, reaching Signal-to-Noise Ratio (SNR) levels in the order of LEO acquisitions without using high transmitted power or large antennas. Moreover, such large integration times, increases the length of the synthetic aperture to get the desired geometric resolutions of the image (in the order of a few meters or kilometres depending on the application). On the other hand, the use of long integration time presents some drawbacks such as the scene targets decorrelation, atmospheric artefacts due to the refraction index variations in the tropospheric layer, transmitter and receiver clock jitter, clutter decorrelation or orbital positioning errors; which will affect the correct focusing of the image. For this reason, a detailed theoretical study is presented in the thesis in order to characterize and model these artefacts. Several simulations have been performed in order to see their effects on the final images. Some techniques and algorithms to track and remove these errors from the focused image are presented and the improvement of the final focused image is analysed. Additionally, the real data from a GB-SAR (Ground-Based SAR) have been reused to simulate a long integration time acquisition and see the effects in the image focusing as well as to check the performance of compensation algorithms in the final image. Finally, a ground receiver to reuse signals of opportunity from a broadcasting satellite have been designed and manufactured. This hardware is expected to be an important tool for experimental testing in future GEOSAR analysis.Aquesta tesi s'emmarca dins de l'àmbit de la teledetecció, en particular, en els sistemes coneguts com a radar d'obertura sintètica (SAR en anglès) des de l'espai. Aquests sistemes adquireixen senyal al llarg de l'òrbita d'un o més satèl·lits on estan situats el transmissor i el receptor, i processa els ecos de forma coherent per a formar l'obertura sintètica. D'aquesta manera es poden aconseguir imatge d'alta resolució sense la necessitat d'emprar un array d'antenes molt gran. El treball realitzat en aquest estudi es centra en un nou concepte dins del món SAR que consisteix en l'ús de satèl·lits en òrbita geostacionària per a l'adquisició d'imatges, sistemes coneguts com a Geosynchronous SAR o GEOSAR. En aquest cas, els petits moviments relatius dels satèl·lits respecte de la superfície terrestre s'empren per a aconseguir el desplaçament necessari per a formar l'obertura sintètica i així obtenir la imatge. El principal avantatge d'aquests sistemes respecte a la tecnologia actual (on s'utilitzen satèl·lits en orbites més baixes LEO) és la possibilitat d'adquirir imatges d'una mateixa zona de forma permanent gràcies als petits desplaçaments del satèl·lit. Així doncs, en aquesta tesi s'estudien les diferents possibilitats en el disseny orbital que ofereixen aquests sistemes així com les resolucions d'imatge que s'obtindrien. Tot i així, l'ús de satèl·lits en òrbita geoestacionària, resulta en una distància entre el transmissor/receptor i l'escena entre 35000-38000 Km, molt més gran que les distàncies típiques en els sistemes LEO per sota dels 1000 Km. Tot i així, el moviment lent de les plataformes geostacionàries fa possible la integració de polsos durant minuts o hores, arribant a nivells acceptables de relació senyal a soroll (SNR) sense necessitat d'utilitzar potències transmeses i antenes massa grans. A més a més, aquesta llarga integració també permet assolir unes longituds d'obertura sintètica adients per a arribar a resolucions d'imatge desitjades (de l'ordre de pocs metres o kilòmetres segons l'aplicació). Malgrat això, l'ús de temps d'integració llargs té una sèrie d'inconvenients com poden ser la decorrelació dels blancs de l'escena, l'aparició d'artefactes atmosfèrics deguts als canvis d'índex de refracció en la troposfera, derives dels rellotges del transmissor i receptor, decorrelació del clutter o errors en el posicionament orbital, que poden afectar la correcta focalització de la imatge. Així doncs, en la tesi s'ha fet un detallat estudi teòric d'aquests problemes per tal de modelitzar-los i posteriorment s'han realitzat diverses simulacions per veure els seus efectes en una imatge. Diverses tècniques per a compensar aquests errors i millorar la qualitat de la imatge també s'han estudiat al llarg de la tesi. Per altra banda, dades reals d'un GB-SAR (SAR en una base terrestre) s'han reutilitzat per adaptar-les a una possible adquisició de llarga durada i veure així de forma experimental com afecta la llarga integració en les imatges i com millora l'enfocament després d'aplicar els algoritmes de compensació. Per últim, en la tesi es presenta un sistema receptor terrestre per a poder realitzar un anàlisi experimental del cas GEOSAR utilitzant un il·luminador d'oportunitat. Els primers passos en el disseny i la fabricació del hardware també es presenten en aquesta tes