The Partial Elements Equivalent Circuit Method: The State Of The Art

This year marks about half a century since the birth of the technique known as the partial element equivalent circuit modeling approach. This method was initially conceived to model the behavior of interconnect-type problems for computer-integrated circuits. An important industrial requirement was the computation of general inductances in integrated circuits and packages. Since then, the advances in methods and applications made it suitable for modeling a large class of electromagnetic problems, especially in the electromagnetic compatibility (EMC)/signal and power integrity (SI/PI) areas. The purpose of this article is to present an overview of all aspects of the method, from its beginning to the present day, with special attention to the developments that have made it suitable for EMC/SI/PI problems

SCEE 2008 book of abstracts : the 7th International Conference on Scientific Computing in Electrical Engineering (SCEE 2008), September 28 – October 3, 2008, Helsinki University of Technology, Espoo, Finland

This report contains abstracts of presentations given at the SCEE 2008 conference.reviewe

System level power integrity transient analysis using a physics-based approach

With decreasing supply voltage level and massive demanding current on system chipset, power integrity design becomes more and more critical for system stability. The ultimate goal of well-designed power delivery network (PDN) is to deliver desired voltage level from the source to destination, in other words, to minimize voltage noise delivered to digital devices. The thesis is composed of three parts. The first part focuses on-die level power models including simplified chip power model (CPM) for system level analysis and the worst scenario current profile. The second part of this work introduces the physics-based equivalent circuit model to simplify the passive PDN model to RLC circuit netlist, to be compatible with any spice simulators and tremendously boost simulation speed. Then a novel system/chip level end-to-end transient model is proposed, including the die model and passive PDN model discussed in previous two chapters as well as a SIMPLIS based small signal VRM model. In the last part of the thesis, how to model voltage regulator module (VRM) is explicitly discussed. Different linear approximated VRM modeling approaches have been compared with the SIMPLIS small signal VRM model in both frequency domain and time domain. The comparison provides PI engineers a guideline to choose specific VRM model under specific circumstances. Finally yet importantly, a PDN optimization example was given. Other than previous PDN optimization approaches, a novel hybrid target impedance concept was proposed in this thesis, in order to improve system level PDN optimization process --Abstract, page iv

Custom Integrated Circuits

Contains table of contents for Part III, table of contents for Section 1 and reports on eleven research projects.IBM CorporationMIT School of EngineeringNational Science Foundation Grant MIP 94-23221Defense Advanced Research Projects Agency/U.S. Army Intelligence Center Contract DABT63-94-C-0053Mitsubishi CorporationNational Science Foundation Young Investigator Award Fellowship MIP 92-58376Joint Industry Program on Offshore Structure AnalysisAnalog DevicesDefense Advanced Research Projects AgencyCadence Design SystemsMAFET ConsortiumConsortium for Superconducting ElectronicsNational Defense Science and Engineering Graduate FellowshipDigital Equipment CorporationMIT Lincoln LaboratorySemiconductor Research CorporationMultiuniversity Research IntiativeNational Science Foundatio

Simulation and Measurement for Decoupling on Multilayer PCB DC Power Buses

DC power bus decoupling of a multi-layer PCB is modeled by a combination of a lumped circuit model at low frequencies ( \u3c 200 MHz), and a mixed-potential integral equation approach at high frequencies. In order to determine the lumped parameters of via interconnects, an effective procedure using a network analyzer has been developed to characterize the trace/via inductances/resistances. For an 8 inch × 10 inch ten-layer test board used in this study, the simulations show good agreement with the measurement. This method can lead to new design strategies of decoupling for multilayer PCB power buses