4,991 research outputs found

    FAXY: Fault Aware Routing Algorithm Based on XY Algorithm for Network on Chip

    Get PDF
    The performance of Network-on-Chip (NoC) largely depends on the underlying routing techniques. In this paper we present and evaluate a Fault aware routing algorithm scheme called FAXY based on XY routing algorithm. The simulation results show the effectiveness of FAXY by comparing it with XY routing schemes under different traffic patterns. Simulation results depict that the proposed routing algorithm is able to route packet even in the case of faulty links or switches in the NoC. Moreover, simulation results demonstrate the advantage of FAXY routing algorithm in terms of average packet latency, packet loss rate compared with XY routing algorithm in the presence of permanent faults. For the proposed algorithm, it can get much less average packet latency (10%) and lead to less than average 15% packet loss rate

    Fault-tolerant networks-on-chip routing with coarse and fine-grained look-ahead

    Get PDF
    Fault tolerance and adaptive capabilities are challenges for modern networks-on-chip (NoC) due to the increase in physical defects in advanced manufacturing processes. Two novel adaptive routing algorithms, namely coarse and fine-grained (FG) look-ahead algorithms, are proposed in this paper to enhance 2-D mesh/torus NoC system fault-tolerant capabilities. These strategies use fault flag codes from neighboring nodes to obtain the status or conditions of real-time traffic in an NoC region, then calculate the path weights and choose the route to forward packets. This approach enables the router to minimize congestion for the adjacent connected channels and also to bypass a path with faulty channels by looking ahead at distant neighboring router paths. The novelty of the proposed routing algorithms is the weighted path selection strategies, which make near-optimal routing decisions to maintain the NoC system performance under high fault rates. Results show that the proposed routing algorithms can achieve performance improvement compared to other state of the art works under various traffic loads and high fault rates. The routing algorithm with FG look-ahead capability achieves a higher throughput compared with the coarse-grained approach under complex fault patterns. The hardware area/power overheads of both routing approaches are relatively low which does not prohibit scalability for large-scale NoC implementations

    On Dynamic Monitoring Methods for Networks-on-Chip

    Get PDF
    Rapid ongoing evolution of multiprocessors will lead to systems with hundreds of processing cores integrated in a single chip. An emerging challenge is the implementation of reliable and efficient interconnection between these cores as well as other components in the systems. Network-on-Chip is an interconnection approach which is intended to solve the performance bottleneck caused by traditional, poorly scalable communication structures such as buses. However, a large on-chip network involves issues related to congestion problems and system control, for instance. Additionally, faults can cause problems in multiprocessor systems. These faults can be transient faults, permanent manufacturing faults, or they can appear due to aging. To solve the emerging traffic management, controllability issues and to maintain system operation regardless of faults a monitoring system is needed. The monitoring system should be dynamically applicable to various purposes and it should fully cover the system under observation. In a large multiprocessor the distances between components can be relatively long. Therefore, the system should be designed so that the amount of energy-inefficient long-distance communication is minimized. This thesis presents a dynamically clustered distributed monitoring structure. The monitoring is distributed so that no centralized control is required for basic tasks such as traffic management and task mapping. To enable extensive analysis of different Network-on-Chip architectures, an in-house SystemC based simulation environment was implemented. It allows transaction level analysis without time consuming circuit level implementations during early design phases of novel architectures and features. The presented analysis shows that the dynamically clustered monitoring structure can be efficiently utilized for traffic management in faulty and congested Network-on-Chip-based multiprocessor systems. The monitoring structure can be also successfully applied for task mapping purposes. Furthermore, the analysis shows that the presented in-house simulation environment is flexible and practical tool for extensive Network-on-Chip architecture analysis.Siirretty Doriast

    NoCo: ILP-based worst-case contention estimation for mesh real-time manycores

    Get PDF
    Manycores are capable of providing the computational demands required by functionally-advanced critical applications in domains such as automotive and avionics. In manycores a network-on-chip (NoC) provides access to shared caches and memories and hence concentrates most of the contention that tasks suffer, with effects on the worst-case contention delay (WCD) of packets and tasks' WCET. While several proposals minimize the impact of individual NoC parameters on WCD, e.g. mapping and routing, there are strong dependences among these NoC parameters. Hence, finding the optimal NoC configurations requires optimizing all parameters simultaneously, which represents a multidimensional optimization problem. In this paper we propose NoCo, a novel approach that combines ILP and stochastic optimization to find NoC configurations in terms of packet routing, application mapping, and arbitration weight allocation. Our results show that NoCo improves other techniques that optimize a subset of NoC parameters.This work has been partially supported by the Spanish Ministry of Economy and Competitiveness under grant TIN2015- 65316-P and the HiPEAC Network of Excellence. It also received funding from the European Research Council (ERC) under the European Union’s Horizon 2020 research and innovation programme (agreement No. 772773). Carles Hernández is jointly supported by the MINECO and FEDER funds through grant TIN2014-60404-JIN. Jaume Abella has been partially supported by the Spanish Ministry of Economy and Competitiveness under Ramon y Cajal postdoctoral fellowship number RYC-2013-14717. Enrico Mezzetti has been partially supported by the Spanish Ministry of Economy and Competitiveness under Juan de la Cierva-Incorporaci´on postdoctoral fellowship number IJCI-2016-27396.Peer ReviewedPostprint (author's final draft

    Run-time management of many-core SoCs: A communication-centric approach

    Get PDF
    The single core performance hit the power and complexity limits in the beginning of this century, moving the industry towards the design of multi- and many-core system-on-chips (SoCs). The on-chip communication between the cores plays a criticalrole in the performance of these SoCs, with power dissipation, communication latency, scalability to many cores, and reliability against the transistor failures as the main design challenges. Accordingly, we dedicate this thesis to the communicationcentered management of the many-core SoCs, with the goal to advance the state-ofthe-art in addressing these challenges. To this end, we contribute to on-chip communication of many-core SoCs in three main directions. First, we start with a synthesizable SoC with full system simulation. We demonstrate the importance of the networking overhead in a practical system, and propose our sophisticated network interface (NI) that offloads the work from SW to HW. Our results show around 5x and up to 50x higher network performance, compared to previous works. As the second direction of this thesis, we study the significance of run-time application mapping. We demonstrate that contiguous application mapping not only improves the network latency (by 23%) and power dissipation (by 50%), but also improves the system throughput (by 3%) and quality-of-service (QoS) of soft real-time applications (up to 100x less deadline misses). Also our hierarchical run-time application mapping provides 99.41% successful mapping when up to 8 links are broken. As the final direction of the thesis, we propose a fault-tolerant routing algorithm, the maze-routing. It is the first-in-class algorithm that provides guaranteed delivery, a fully-distributed solution, low area overhead (by 16x), and instantaneous reconfiguration (vs. 40K cycles down time of previous works), all at the same time. Besides the individual goals of each contribution, when applicable, we ensure that our solutions scale to extreme network sizes like 12x12 and 16x16. This thesis concludes that the communication overhead and its optimization play a significant role in the performance of many-core SoC

    Adaptive Routing Approaches for Networked Many-Core Systems

    Get PDF
    Through advances in technology, System-on-Chip design is moving towards integrating tens to hundreds of intellectual property blocks into a single chip. In such a many-core system, on-chip communication becomes a performance bottleneck for high performance designs. Network-on-Chip (NoC) has emerged as a viable solution for the communication challenges in highly complex chips. The NoC architecture paradigm, based on a modular packet-switched mechanism, can address many of the on-chip communication challenges such as wiring complexity, communication latency, and bandwidth. Furthermore, the combined benefits of 3D IC and NoC schemes provide the possibility of designing a high performance system in a limited chip area. The major advantages of 3D NoCs are the considerable reductions in average latency and power consumption. There are several factors degrading the performance of NoCs. In this thesis, we investigate three main performance-limiting factors: network congestion, faults, and the lack of efficient multicast support. We address these issues by the means of routing algorithms. Congestion of data packets may lead to increased network latency and power consumption. Thus, we propose three different approaches for alleviating such congestion in the network. The first approach is based on measuring the congestion information in different regions of the network, distributing the information over the network, and utilizing this information when making a routing decision. The second approach employs a learning method to dynamically find the less congested routes according to the underlying traffic. The third approach is based on a fuzzy-logic technique to perform better routing decisions when traffic information of different routes is available. Faults affect performance significantly, as then packets should take longer paths in order to be routed around the faults, which in turn increases congestion around the faulty regions. We propose four methods to tolerate faults at the link and switch level by using only the shortest paths as long as such path exists. The unique characteristic among these methods is the toleration of faults while also maintaining the performance of NoCs. To the best of our knowledge, these algorithms are the first approaches to bypassing faults prior to reaching them while avoiding unnecessary misrouting of packets. Current implementations of multicast communication result in a significant performance loss for unicast traffic. This is due to the fact that the routing rules of multicast packets limit the adaptivity of unicast packets. We present an approach in which both unicast and multicast packets can be efficiently routed within the network. While suggesting a more efficient multicast support, the proposed approach does not affect the performance of unicast routing at all. In addition, in order to reduce the overall path length of multicast packets, we present several partitioning methods along with their analytical models for latency measurement. This approach is discussed in the context of 3D mesh networks.Siirretty Doriast

    Reconfigurable High Performance Secured NoC Design Using Hierarchical Agent-based Monitoring System

    Get PDF
    With the rapid increase in demand for high performance computing, there is also a significant growth of data communication that leads to leverage the significance of network on chip. This paper proposes a reconfigurable fault tolerant on chip architecture with hierarchical agent based monitoring system for enhancing the performance of network based multiprocessor system on chip against faulty links and nodes. These distributed agents provide healthy status and congestion information of the network. This status information is used for further packet routing in the network with the help of XY routing algorithm. The functionality of Agent is enhanced not only to work as information provider but also to take decision for packet to either pass or stop to the processing element by setting the firewall in order to provide security. Proposed design provides a better performance and area optimization by avoiding deadlock and live lock as compared to existing approaches over network design
    • …
    corecore