Studies of atmospheric water vapor by means of passive microwave techniques

Atmospheric water vapor determined with passive microwave technique

The Mutual Interpretation of Active and Passive Microwave Sensor Outputs

Mutual interpretation of active and passive microwave sensor output

Nonlinear mechanisms in passive microwave devices

Premi extraordinari doctorat curs 2010-2011, àmbit d’Enginyeria de les TICThe telecommunications industry follows a tendency towards smaller devices, higher power and higher frequency, which imply an increase on the complexity of the electronics involved. Moreover, there is a need for extended capabilities like frequency tunable devices, ultra-low losses or high power handling, which make use of advanced materials for these purposes. In addition, increasingly demanding communication standards and regulations push the limits of the acceptable performance degrading indicators. This is the case of nonlinearities, whose effects, like increased Adjacent Channel Power Ratio (ACPR), harmonics, or intermodulation distortion among others, are being included in the performance requirements, as maximum tolerable levels. In this context, proper modeling of the devices at the design stage is of crucial importance in predicting not only the device performance but also the global system indicators and to make sure that the requirements are fulfilled. In accordance with that, this work proposes the necessary steps for circuit models implementation of different passive microwave devices, from the linear and nonlinear measurements to the simulations to validate them. Bulk acoustic wave resonators and transmission lines made of high temperature superconductors, ferroelectrics or regular metals and dielectrics are the subject of this work. Both phenomenological and physical approaches are considered and circuit models are proposed and compared with measurements. The nonlinear observables, being harmonics, intermodulation distortion, and saturation or detuning, are properly related to the material properties that originate them. The obtained models can be used in circuit simulators to predict the performance of these microwave devices under complex modulated signals, or even be used to predict their performance when integrated into more complex systems. A key step to achieve this goal is an accurate characterization of materials and devices, which is faced by making use of advanced measurement techniques. Therefore, considerations on special measurement setups are being made along this thesis.Award-winningPostprint (published version

Optimization of microwave radiometric systems for earth resource surveys Final report

Optimization of passive microwave radiometric systems for earth resource surveys from ground and aircraft based measurement

Proceedings of the Interdisciplinary Workshop on Vertical Radiometric Probing

Rayleigh and Mie scattering, passive microwave radiometry, and linear and nonlinear inversion methods for inferring atmospheric thermal structure from satellite observation

Passive microwave mapping of ice thickness

Basic calculations are presented for evaluating the feasibility of a scanning microwave radiometer system for mapping the thickness of lake ice. An analytical model for the apparent brightness temperature as a function of ice thickness has been developed, and elaborated to include such variables as galactic and atmospheric noise, aspect angle, polarization, temperature gradient in the ice, the presence of transition layers such as snow, slush, and water, increased loss due to air inclusions in the ice layer, and the presence of multiple ice thicknesses within the antenna footprint. It was found that brightness temperature measurements at six or seven frequencies in the range of 0.4 to 0.7 GHz were required to obtain unambiquous thickness estimates. A number of data processing methods were examined. The effects of antenna beamwidth, scanning rate, receiver bandwidth, noise figure, and integration time were studied

A hydrological analysis of East Australian floods using Nimbus 5 electrically scanning microwave radiometer data

A chronology of a major Australian flood in 1974 is presented using Nimbus 5 Passive Microwave Data (ESMR) and other conventional and satellite supporting data

Comparison of passive microwave and modeled estimates of total watershed SWE in the continental United States

In the U.S., a dedicated system of snow measurement stations and snowpack modeling products is available to estimate the snow water equivalent (SWE) throughout the winter season. In other regions of the world that depend on snowmelt for water resources, snow data can be scarce, and these regions are vulnerable to drought or flood conditions. Even in the U.S., water resource management is hampered by limited snow data in certain regions, as evident by the 2011 Missouri Basin flooding due in large part to the significant Plains snowpack. Satellite data could potentially provide important information in under‐sampled areas. This study compared the daily AMSR‐E and SSM/I SWE products over nine winter seasons to spatially distributed, modeled output SNODAS summed over 2100 watersheds in the conterminous U.S. Results show large areas where the passive microwave retrievals are highly correlated to the SNODAS data, particularly in the northern Great Plains and southern Rocky Mountain regions. However, the passive microwave SWE is significantly lower than SNODAS in heavily forested areas, and regions that typically receive a deep snowpack. The best correlations are associated with basins in which maximum annual SWE is less than 200 mm, and forest fraction is less than 20%. Even in many watersheds with poor correlations between the passive microwave data and SNODAS maximum annual SWE values, the overall pattern of accumulation and ablation did show good agreement and therefore may provide useful hydrologic information on melt timing and season length

Antarctic Sea Ice variations 1973 - 1975

Variations in the extent and concentration of sea ice cover on the Southern Ocean are described for the three-year period 1973-75 using information derived from the Nimbus-5 passive microwave imager

Investigation of remote sensing techniques of measuring soil moisture

Major activities described include development and evaluation of theoretical models that describe both active and passive microwave sensing of soil moisture, the evaluation of these models for their applicability, the execution of a controlled field experiment during which passive microwave measurements were acquired to validate these models, and evaluation of previously acquired aircraft microwave measurements. The development of a root zone soil water and soil temperature profile model and the calibration and evaluation of gamma ray attenuation probes for measuring soil moisture profiles are considered. The analysis of spatial variability of soil information as related to remote sensing is discussed as well as the implementation of an instrumented field site for acquisition of soil moisture and meteorologic information for use in validating the soil water profile and soil temperature profile models