Hydrogen vs. Battery in the long-term operation. A comparative between energy management strategies for hybrid renewable microgrids

The growth of the world’s energy demand over recent decades in relation to energy intensity and demography is clear. At the same time, the use of renewable energy sources is pursued to address decarbonization targets, but the stochasticity of renewable energy systems produces an increasing need for management systems to supply such energy volume while guaranteeing, at the same time, the security and reliability of the microgrids. Locally distributed energy storage systems (ESS) may provide the capacity to temporarily decouple production and demand. In this sense, the most implemented ESS in local energy districts are small–medium-scale electrochemical batteries. However, hydrogen systems are viable for storing larger energy quantities thanks to its intrinsic high mass-energy density. To match generation, demand and storage, energy management systems (EMSs) become crucial. This paper compares two strategies for an energy management system based on hydrogen-priority vs. battery-priority for the operation of a hybrid renewable microgrid. The overall performance of the two mentioned strategies is compared in the long-term operation via a set of evaluation parameters defined by the unmet load, storage efficiency, operating hours and cumulative energy. The results show that the hydrogen-priority strategy allows the microgrid to be led towards island operation because it saves a higher amount of energy, while the battery-priority strategy reduces the energy efficiency in the storage round trip. The main contribution of this work lies in the demonstration that conventional EMS for microgrids’ operation based on battery-priority strategy should turn into hydrogen-priority to keep the reliability and independence of the microgrid in the long-term operation

Micro-scale strain distribution in hot-worked duplex stainless steel

A modified microgrid technique has been applied to a laboratory-made duplex stainless steel, to experimentally simulate the local state of deformation of the austenite-ferrite microstructure of low-alloy steels subject to intercritical deformation. A sample containing such a microgrid was deformed by plane strain compression at high temperature under conditions representative of hot rolling processes. The distortion of the microgrid after hot deformation revealed, in a quantifiable manner, the plastic flow of both phases and different deformation features. The micro-strain distributions measured can be used to validate the models predicting the hot deformation of low alloyed C-Mn steels during intercritical rolling

Mixed-integer-linear-programming-based energy management system for hybrid PV-wind-battery microgrids: Modeling, design, and experimental verification

© 2017 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other worksMicrogrids are energy systems that aggregate distributed energy resources, loads, and power electronics devices in a stable and balanced way. They rely on energy management systems to schedule optimally the distributed energy resources. Conventionally, many scheduling problems have been solved by using complex algorithms that, even so, do not consider the operation of the distributed energy resources. This paper presents the modeling and design of a modular energy management system and its integration to a grid-connected battery-based microgrid. The scheduling model is a power generation-side strategy, defined as a general mixed-integer linear programming by taking into account two stages for proper charging of the storage units. This model is considered as a deterministic problem that aims to minimize operating costs and promote self-consumption based on 24-hour ahead forecast data. The operation of the microgrid is complemented with a supervisory control stage that compensates any mismatch between the offline scheduling process and the real time microgrid operation. The proposal has been tested experimentally in a hybrid microgrid at the Microgrid Research Laboratory, Aalborg University.Peer ReviewedPostprint (author's final draft

Doktrin pengasingan kuasa : falsafah, praktis dan kerelatifan di Malaysia

Penulisan ini membincangkan tentang doktrin pengasingan kuasa berdasarkan kerangka teori institusionalisme. Doktrin ini dipraktiskan dalam trias politica atau politik tiga serangkai iaitu badan legislatif, eksekutif dan kehakiman. Falsafah dan praktis doktrin pengasingan kuasa ini adalah ditekankan bagi sesebuah negara bercorak demokrasi untuk mempamerkan wujudnya pengasingan kuasa serta autonomi bidangan di antara ketigatiga badan kerajaan. Hal ini penting untuk disoroti kerana Malaysia tidak terkecuali daripada mengamalkan sistem demokrasi dan pada masa yang sama mempraktiskan doktrin pengasingan kuasa dalam kerajaan federalisme berlapisnya sebagai satu pegangan fundamental. Akauntabiliti untuk menzahirkan doktrin pengasingan kuasa ini merupakan perkara yang penting memandangkan ia telah dimaktubkan dalam Perlembagaan Persekutuan

System configuration, fault detection, location, isolation and restoration: a review on LVDC Microgrid protections

Low voltage direct current (LVDC) distribution has gained the significant interest of research due to the advancements in power conversion technologies. However, the use of converters has given rise to several technical issues regarding their protections and controls of such devices under faulty conditions. Post-fault behaviour of converter-fed LVDC system involves both active converter control and passive circuit transient of similar time scale, which makes the protection for LVDC distribution significantly different and more challenging than low voltage AC. These protection and operational issues have handicapped the practical applications of DC distribution. This paper presents state-of-the-art protection schemes developed for DC Microgrids. With a close look at practical limitations such as the dependency on modelling accuracy, requirement on communications and so forth, a comprehensive evaluation is carried out on those system approaches in terms of system configurations， fault detection, location, isolation and restoration

Distributed MPC for coordinated energy efficiency utilization in microgrid systems

To improve the renewable energy utilization of distributed microgrid systems, this paper presents an optimal distributed model predictive control strategy to coordinate energy management among microgrid systems. In particular, through information exchange among systems, each microgrid in the network, which includes renewable generation, storage systems, and some controllable loads, can maintain its own systemwide supply and demand balance. With our mechanism, the closed-loop stability of the distributed microgrid systems can be guaranteed. In addition, we provide evaluation criteria of renewable energy utilization to validate our proposed method. Simulations show that the supply demand balance in each microgrid is achieved while, at the same time, the system operation cost is reduced, which demonstrates the effectiveness and efficiency of our proposed policy.Accepted manuscrip

Evaluating the robustness of an active network management function in an operational environment

This paper presents the integration process of a distribution network Active Network Management (ANM) function within an operational environment in the form of a Micro-Grid Laboratory. This enables emulation of a real power network and enables investigation into the effects of data uncertainty on an online and automatic ANM algorithm's control decisions. The algorithm implemented within the operational environment is a Power Flow Management (PFM) approach based around the Constraint Satisfaction Problem (CSP). This paper show the impact of increasing uncertainty, in the input data available for an ANM scheme in terms of the variation in control actions. The inclusion of a State Estimator (SE), with known tolerances is shown to improve the ANM performance