740 research outputs found

    Impact of Si nanocrystals in a-SiOx<Er> in C-Band emission for applications in resonators structures

    Full text link
    Si nanocrystals (Si-NC) in a-SiOx were created by high temperature annealing. Si-NC samples have large emission in a broadband region, 700nm to 1000nm. Annealing temperature, annealing time, substrate type, and erbium concentration is studied to allow emission at 1550 nm forsamples with erbium. Emission in the C-Band region is largely reduced by the presence of Si-NC. This reduction may be due to less efficient energy transfer processes from the nanocrystals than from the amorphous matrix to the Er3+ ions, perhaps due to the formation of more centro-symmetric Er3+ sites at the nanocrystal surfaces or to very different optimal erbium concentrations between amorphous and crystallized samples.Comment: 3 pages, 4 figure

    Resonant structures based on amorphous silicon sub-oxide doped with Er3+ with silicon nanoclusters for an efficient emission at 1550 nm

    Full text link
    We present a resonant approach to enhance 1550nm emission efficiency of amorphous silicon sub-oxide doped with Er3+ (a-SiOx) layers with silicon nanoclusters (Si-NC). Two distinct techniques were combined to provide a structure that allowed increasing approximately 12x the 1550nm emission. First, layers of SiO2 were obtained by conventional wet oxidation and a-SiOx matrix was deposited by reactive RF co-sputtering. Secondly, an extra pump channel (4I15/2 to 4I9/2) of Er3+ was created due to Si-NC formation on the same a-SiOx matrix via a hard annealing at 1150 C. The SiO2 and the a-SiOx thicknesses were designed to support resonances near the pumping wavelength (~500nm), near the Si-NC emission (~800nm) and near the a-SiOx emission (~1550nm) enhancing the optical pumping process.Comment: 14 pages, 4 figures, in submissio

    Correlated theory of triplet photoinduced absorption in phenylene-vinylene chains

    Full text link
    In this paper we present results of large-scale correlated calculations of triplet photoinduced absorption (PA) spectrum of oligomers of poly-(para)phenylenevinylene (PPV) containing up to five phenyl rings. In particular, the high-energy features in the triplet PA spectrum of oligo-PPVs are the focus of this study, which, so far, have not been investigated theoretically, or experimentally. The calculations were performed using the Pariser-Parr-Pople (PPP) model Hamiltonian, and many-body effects were taken into account by means of multi-reference singles-doubles configuration interaction procedure (MRSDCI), without neglecting any molecular orbitals. The computed triplet PA spectrum of oligo-PPVs exhibits rich structure consisting of alternating peaks of high and low intensities. The predicted higher energy features of the triplet spectrum can be tested in future experiments. Additionally, theoretical estimates of exciton binding energy are also presented.Comment: To appear in Phys. Rev.

    Size dependent tunneling and optical spectroscopy of CdSe quantum rods

    Full text link
    Photoluminescence excitation spectroscopy and scanning tunneling spectroscopy are used to study the electronic states in CdSe quantum rods that manifest a transition from a zero dimensional to a one dimensional quantum confined structure. Both optical and tunneling spectra show that the level structure depends primarily on the rod diameter and not on length. With increasing diameter, the band-gap and the excited state level spacings shift to the red. The level structure was assigned using a multi-band effective-mass model, showing a similar dependence on rod dimensions.Comment: Accepted to PRL (nearly final version). 4 pages in revtex, 4 figure

    Illumination Driven Energy Level Realignment at Buried Interfaces between Organic Charge Transport Layers and a Lead Halide Perovskite

    Get PDF
    Tremendous progress in employing metal halide perovskites MHPs in a variety of applications, especially in photovoltaics, has been made in the past decade. To unlock the full potential of MHP materials in optoelectronic devices, an improved understanding of the electronic energy level alignment at perovskite based interfaces is required. This particularly pertains to such interfaces under device operation conditions, e.g. under illumination with visible light such as in a solar cell. Herein, it is revealed that the energy level alignment at the buried interface between a double cation lead halide perovskite film and charge selective organic transport layers changes upon white light illumination. This is found from photoemission experiments performed with the samples in dark and under illumination, and the interfacial energy level shift is reversible. The underlying mechanism is attributed to the accumulation of one charge carrier type within the perovskite film at the interface under illumination, as a result of the charge selective nature of the organic layer. The fact that the interfacial energy level alignment at MHP based junctions under illumination can differ from that in dark is to be taken into account to fully rationalize device characteristic

    Stellar 36,38^{36,38}Ar(n,γ)37,39(n,\gamma)^{37,39}Ar reactions and their effect on light neutron-rich nuclide synthesis

    Full text link
    The 36^{36}Ar(n,γ)37(n,\gamma)^{37}Ar (t1/2t_{1/2} = 35 d) and 38^{38}Ar(n,γ)39(n,\gamma)^{39}Ar (269 y) reactions were studied for the first time with a quasi-Maxwellian (kT47kT \sim 47 keV) neutron flux for Maxwellian Average Cross Section (MACS) measurements at stellar energies. Gas samples were irradiated at the high-intensity Soreq applied research accelerator facility-liquid-lithium target neutron source and the 37^{37}Ar/36^{36}Ar and 39^{39}Ar/38^{38}Ar ratios in the activated samples were determined by accelerator mass spectrometry at the ATLAS facility (Argonne National Laboratory). The 37^{37}Ar activity was also measured by low-level counting at the University of Bern. Experimental MACS of 36^{36}Ar and 38^{38}Ar, corrected to the standard 30 keV thermal energy, are 1.9(3) mb and 1.3(2) mb, respectively, differing from the theoretical and evaluated values published to date by up to an order of magnitude. The neutron capture cross sections of 36,38^{36,38}Ar are relevant to the stellar nucleosynthesis of light neutron-rich nuclides; the two experimental values are shown to affect the calculated mass fraction of nuclides in the region A=36-48 during the weak ss-process. The new production cross sections have implications also for the use of 37^{37}Ar and 39^{39}Ar as environmental tracers in the atmosphere and hydrosphere.Comment: 18 pages + Supp. Mat. (13 pages) Accepted for publication in Phys. Rev. Let

    Prediction of infrared light emission from pi-conjugated polymers: a diagrammatic exciton basis valence bond theory

    Full text link
    There is currently a great need for solid state lasers that emit in the infrared, as this is the operating wavelength regime for applications in telecommunications. Existing π\pi--conjugated polymers all emit in the visible or ultraviolet, and whether or not π\pi--conjugated polymers that emit in the infrared can be designed is an interesting challenge. On the one hand, the excited state ordering in trans-polyacetylene, the π\pi--conjugated polymer with relatively small optical gap, is not conducive to light emission because of electron-electron interaction effects. On the other hand, excited state ordering opposite to that in trans-polyacetylene is usually obtained by chemical modification that increases the effective bond-alternation, which in turn increases the optical gap. We develop a theory of electron correlation effects in a model π\pi-conjugated polymer that is obtained by replacing the hydrogen atoms of trans-polyacetylene with transverse conjugated groups, and show that the effective on-site correlation in this system is smaller than the bare correlation in the unsubstituted system. An optical gap in the infrared as well as excited state ordering conducive to light emission is thereby predicted upon similar structural modifications.Comment: 15 pages, 15 figures, 1 tabl

    Isoperimetric Inequalities in Simplicial Complexes

    Full text link
    In graph theory there are intimate connections between the expansion properties of a graph and the spectrum of its Laplacian. In this paper we define a notion of combinatorial expansion for simplicial complexes of general dimension, and prove that similar connections exist between the combinatorial expansion of a complex, and the spectrum of the high dimensional Laplacian defined by Eckmann. In particular, we present a Cheeger-type inequality, and a high-dimensional Expander Mixing Lemma. As a corollary, using the work of Pach, we obtain a connection between spectral properties of complexes and Gromov's notion of geometric overlap. Using the work of Gunder and Wagner, we give an estimate for the combinatorial expansion and geometric overlap of random Linial-Meshulam complexes

    Relationship between photonic band structure and emission characteristics of a polymer distributed feedback laser

    Get PDF
    G. A. Turnbull, P. Andrew, M. J. Jory, William L. Barnes, and I. D. W. Samuel, Physical Review B, Vol. 64, article 125122 (2001). "Copyright © 2001 by the American Physical Society."We present an experimental study of the emission characteristics and photonic band structure of a distributed feedback polymer laser, based on the material poly[2-methoxy-5-(2′-ethylhexyloxy)-1,4-phenylene vinylene]. We use measurements of the photonic band dispersion to explain how the substrate microstructure modifies both spontaneous and stimulated emission. The lasing structure exhibits a one-dimensional photonic band gap around 610 nm, with lasing occurring at one of the two associated band edges. The band edge (frequency) selection mechanism is found to be a difference in the level of output coupling of the modes associated with the two band edges. This is a feature of the second-order distributed feedback mechanism we have employed and is clearly evident in the measured photonic band structur
    corecore