Probing the Ginzburg-Landau potential for lasers using higher-order photon correlations

Lasing transition is known to be analogous to the second-order phase transition. Furthermore, for some cases, it is possible to define the Ginzburg-Landau (GL) potential, and the GL theory predicts the photon statistical properties of lasers. However, the GL potential for lasers is surprising, because lasers are operating in far-from-equilibrium . In this paper, we theoretically examine the validity of the GL theory for lasers in terms of various parameters, particularly, the ratio between photon and carrier lifetimes. For this purpose, we use stochastic rate equations and higher-order photon correlation functions. With higher-order photon correlation measurements, we can check whether or not laser dynamics are described by the GL theory. We demonstrate that, for low-$\beta$ lasers, the GL theory is applicable even when the photon lifetime is comparable to the carrier lifetime. Furthermore, this can be understand in the framework of center manifold reduction

A 43-Gbps Lithium Niobate Modulator Driver Module

This paper describes the realization of a 43-Gbps Lithium Niobate modulator driver module. The NRZ driver module utilizes four stages of GaAs p-HEMT MMIC amplifiers integrated with an output level detector and feedback loop to provide thermal stability and external control of the output swing. The bias and loop control circuitry are contained in the housing on a PC board external to the sealed MIC section. The integrated module (50.8 x 73.4 x 9.5 mm 3) provides 6.0 Vp-p controllable single-ended output voltage while dissipating only 4 watt

Efficient light coupling into a photonic crystal waveguide with flatband slow mode

We design an efficient coupler to transmit light from a strip waveguide into the flatband slow mode of a photonic crystal waveguide with ring-shaped holes. The coupler is a section of a photonic crystal waveguide with a higher group velocity, obtained by different ring dimensions. We demonstrate coupling efficiency in excess of 95% over the 8 nm wavelength range where the photonic crystal waveguide exhibits a quasi constant group velocity vg = c/37. An analysis based on the small Fabry-P\'erot resonances in the simulated transmission spectra is introduced and used for studying the effect of the coupler length and for evaluating the coupling efficiency in different parts of the coupler. The mode conversion efficiency within the coupler is more than 99.7% over the wavelength range of interest. The parasitic reflectance in the coupler, which depends on the propagation constant mismatch between the slow mode and the coupler mode, is lower than 0.6% within this wavelength range.Comment: 11 pages, 7 figures, submitted to Photonics and Nanostructures - Fundamentals and Application

Radiation induced force between two planar waveguides

We study the electromagnetic force exerted on a pair of parallel slab waveguides by the light propagating through them. We have calculated the dependence of the force on the slab separation by means of the Maxwell--Stress tensor formalism and we have discussed its main features for the different propagation modes: spatially symmetric (antisymmetric) modes give rise to an attractive (repulsive) interaction. We have derived the asymptotic behaviors of the force at small and large separation and we have quantitatively estimated the mechanical deflection induced on a realistic air-bridge structure.Comment: 10 pages, 6 figure

Absolute negative refraction and imaging of unpolarized electromagnetic waves by two-dimensional photonic crystals

Absolute negative refraction regions for both polarizations of electromagnetic wave in two-dimensional photonic crystal have been found through both the analysis and the exact numerical simulation. Especially, absolute all-angle negative refraction for both polarizations has also been demonstrated. Thus, the focusing and image of unpolarized light can be realized by a microsuperlens consisting of the two-dimensional photonic crystals. The absorption and compensation for the losses by introducing optical gain in these systems have also been discussed

Surface nanoscale axial photonics: Robust fabrication of high quality factor microresonators

Recently introduced Surface Nanoscale Axial Photonics (SNAP) makes it possible to fabricate high Q-factor microresonators and other photonic microdevices by dramatically small deformation of the optical fiber surface. To become a practical and robust technology, the SNAP platform requires methods enabling reproducible modification of the optical fiber radius at nanoscale. In this Letter, we demonstrate super-accurate fabrication of high Q-factor microresonators by nanoscale modification of the optical fiber radius and refractive index using the CO2 laser and the UV excimer laser beam exposures. The achieved fabrication accuracy is better than 2 angstroms in variation of the effective fiber radius