High quality GaMnAs films grown with As dimers

We demonstrate that GaMnAs films grown with As2 have excellent structural, electrical and magnetic properties, comparable or better than similar films grown with As4. Using As2, a Curie temperature of 112K has been achieved, which is slightly higher than the best reported to date. More significantly, films showing metallic conduction have been obtained over a much wider range of Mn concentrations (from 1.5% to 8%) than has been reported for films grown with As4. The improved properties of the films grown with As2 are related to the lower concentration of antisite defects at the low growth temperatures employed.Comment: 8 pages, accepted for publication in J. Crystal Growt

Measurements of Cabibbo Suppressed Hadronic Decay Fractions of Charmed D0 and D+ Mesons

Using data collected with the BESII detector at $e^{+}e^{-}$ storage ring Beijing Electron Positron Collider, the measurements of relative branching fractions for seven Cabibbo suppressed hadronic weak decays $D^0 \to K^- K^+$, $\pi^+ \pi^-$, $K^- K^+ \pi^+ \pi^-$ and $\pi^+ \pi^+ \pi^- \pi^-$, $D^+ \to \bar{K^0} K^+$, $K^- K^+ \pi^+$ and $\pi^- \pi^+ \pi^+$ are presented.Comment: 11 pages, 5 figure

Measurements of J/psi Decays into 2(pi+pi-)eta and 3(pi+pi-)eta

Based on a sample of 5.8X 10^7 J/psi events taken with the BESII detector, the branching fractions of J/psi--> 2(pi+pi-)eta and J/psi-->3(pi+pi-)eta are measured for the first time to be (2.26+-0.08+-0.27)X10^{-3} and (7.24+-0.96+-1.11)X10^{-4}, respectively.Comment: 11 pages, 6 figure

BESII Detector Simulation

A Monte Carlo program based on Geant3 has been developed for BESII detector simulation. The organization of the program is outlined, and the digitization procedure for simulating the response of various sub-detectors is described. Comparisons with data show that the performance of the program is generally satisfactory.Comment: 17 pages, 14 figures, uses elsart.cls, to be submitted to NIM

Measurement of branching fractions for the inclusive Cabibbo-favored ~K*0(892) and Cabibbo-suppressed K*0(892) decays of neutral and charged D mesons

The branching fractions for the inclusive Cabibbo-favored ~K*0 and Cabibbo-suppressed K*0 decays of D mesons are measured based on a data sample of 33 pb-1 collected at and around the center-of-mass energy of 3.773 GeV with the BES-II detector at the BEPC collider. The branching fractions for the decays D+(0) -> ~K*0(892)X and D0 -> K*0(892)X are determined to be BF(D0 -> \~K*0X) = (8.7 +/- 4.0 +/- 1.2)%, BF(D+ -> ~K*0X) = (23.2 +/- 4.5 +/- 3.0)% and BF(D0 -> K*0X) = (2.8 +/- 1.2 +/- 0.4)%. An upper limit on the branching fraction at 90% C.L. for the decay D+ -> K*0(892)X is set to be BF(D+ -> K*0X) < 6.6%

Temperature stable K0.5(Nd1−xBix)0.5MoO4 microwave dielectrics ceramics with ultra-low sintering temperature

K 0.5 (Nd 1-x Bi x ) 0.5 MoO 4 (0.2 ≤ x ≤ 0.7) ceramics were prepared via the solid-state reaction method. All ceramics densified below 720°C with a uniform microstructure. As x increased from 0.2 to 0.7, relative permittivity (e(open) r ) increased from 13.6 to 26.2 commensurate with an increase in temperature coefficient of resonant frequency (TCF) from - 31 ppm/°C to + 60 ppm/°C and a decrease in Qf value (Q = quality factor; f = resonant frequency) from 23 400 to 8620 GHz. Optimum TCF was obtained for x = 0.3 (-15 ppm/°C) and 0.4 (+4 ppm/°C) sintered at 660 and 620°C with e(open) r ~15.4, Q f ~19 650 GHz, and e(open) r ~17.3, Q f ~13 050 GHz, respectively. Ceramics in this novel solid solution are a candidate for ultra low temperature co-fired ceramic (ULTCC) technology

jFuzzyLogic: a Java Library to Design Fuzzy Logic Controllers According to the Standard for Fuzzy Control Programming

Fuzzy Logic Controllers are a specific model of Fuzzy Rule Based Systems suitable for engineering applications for which classic control strategies do not achieve good results or for when it is too difficult to obtain a mathematical model. Recently, the International Electrotechnical Commission has published a standard for fuzzy control programming in part 7 of the IEC 61131 norm in order to offer a well defined common understanding of the basic means with which to integrate fuzzy control applications in control systems. In this paper, we introduce an open source Java library called jFuzzyLogic which offers a fully functional and complete implementation of a fuzzy inference system according to this standard, providing a programming interface and Eclipse plugin to easily write and test code for fuzzy control applications. A case study is given to illustrate the use of jFuzzyLogic.McGill Uninversity, Genome QuebecSpanish Government TIN2011-28488Andalusian Government P10-TIC-685