3,770 research outputs found
A comparison of landing maneuver piloting technique based on measurements made in an airline training simulator and in actual flight
An emphasis is placed on developing a mathematical model in order to identify useful metrics, quantify piloting technique, and define simulator fidelity. On the basis of DC-10 flight measurements recorded for 32 pilots, 13 flight-trained and the remainder simulator trained, a revised model of the landing flare is hypothesized which accounts for reduction of sink rate and perference for touchdown point along the runway. The flare maneuver and touchdown point adjustment can be described by a pitch attitude command pilot guidance law consisting of altitude and vertical velocity feedbacks. In flight pilots exhibit a significant vertical velocity feedback which is essential for well controlled sink rate reduction at the desired level of response (bandwidth). In the simulator, however, the vertical velocity feedback appears ineffectual and leads to substantially inferior landing performance
Transport mechanism through metal-cobaltite interfaces
The resistive switching (RS) properties as a function of temperature were
studied for Ag/LaSrCoO (LSCO) interfaces. The LSCO is a
fully-relaxed 100 nm film grown by metal organic deposition on a LaAlO
substrate. Both low and a high resistance states were set at room temperature
and the temperature dependence of their current-voltage (IV) characteristics
was mea- sured taking care to avoid a significant change of the resistance
state. The obtained non-trivial IV curves of each state were well reproduced by
a circuit model which includes a Poole-Frenkel element and two ohmic
resistances. A microscopic description of the changes produced by the RS is
given, which enables to envision a picture of the interface as an area where
conductive and insulating phases are mixed, producing Maxwell-Wagner
contributions to the dielectric properties.Comment: 13 pages, 5 figures, to be published in APL. Corresponding author: C.
Acha ([email protected]
Stability of quantum breathers
Using two methods we show that a quantized discrete breather in a 1-D lattice
is stable. One method uses path integrals and compares correlations for a
(linear) local mode with those of the quantum breather. The other takes a local
mode as the zeroth order system relative to which numerical, cutoff-insensitive
diagonalization of the Hamiltonian is performed.Comment: 4 pages, 3 figure
An analysis of airline landing flare data based on flight and training simulator measurements
Landings by experienced airline pilots transitioning to the DC-10, performed in flight and on a simulator, were analyzed and compared using a pilot-in-the-loop model of the landing maneuver. By solving for the effective feedback gains and pilot compensation which described landing technique, it was possible to discern fundamental differences in pilot behavior between the actual aircraft and the simulator. These differences were then used to infer simulator fidelity in terms of specific deficiencies and to quantify the effectiveness of training on the simulator as compared to training in flight. While training on the simulator, pilots exhibited larger effective lag in commanding the flare. The inability to compensate adequately for this lag was associated with hard or inconsistent landings. To some degree this deficiency was carried into flight, thus resulting in a slightly different and inferior landing technique than exhibited by pilots trained exclusively on the actual aircraft
Roughening transition, surface tension and equilibrium droplet shapes in a two-dimensional Ising system
The exact surface tension for all angles and temperatures is given for the two-dimensional square Ising system with anisotropic nearest-neighbour interactions. Using this in the Wulff construction, droplet shapes are computed and illustrated. Letting temperature approach zero allows explicit study of the roughening transition in this model. Results are compared with those of the solid-on-solid approximation
The eclipsing X-ray pulsar X-7 in M33
Using our extensive ROSAT X-ray observations of M33, we confirm a 3.45 day
eclipse period for the Einstein source X-7 (Larson & Schulman, 1997) and
discover evidence for a 0.31-s pulse period. The orbital period, pulse period
and observed X-ray luminosity are remarkably similar to SMC X-1. We therefore
suggest M33 X-7 is a neutron star high mass X-ray binary with a 15-40 Msol O/B
companion and a binary separation of 25-33 Rsol if the companion is almost
filling its Roche lobe.Comment: accepted for publication in MNRA
Semiclassical Electron Correlation in Density-Matrix Time-Propagation
Lack of memory (locality in time) is a major limitation of almost all present
time-dependent density functional approximations. By using semiclassical
dynamics to compute correlation effects within a density-matrix functional
approach, we incorporate memory, including initial-state dependence, as well as
changing occupation numbers, and predict more observables in strong-field
applications.Comment: 4.5 pages, 1 figur
The analysis of delays in simulator digital computing systems. Volume 1: Formulation of an analysis approach using a central example simulator model
The effects of spurious delays in real time digital computing systems are examined. Various sources of spurious delays are defined and analyzed using an extant simulator system as an example. A specific analysis procedure is set forth and four cases are viewed in terms of their time and frequency domain characteristics. Numerical solutions are obtained for three single rate one- and two-computer examples, and the analysis problem is formulated for a two-rate, two-computer example
Feynman's Path Integrals and Bohm's Particle Paths
Both Bohmian mechanics, a version of quantum mechanics with trajectories, and
Feynman's path integral formalism have something to do with particle paths in
space and time. The question thus arises how the two ideas relate to each
other. In short, the answer is, path integrals provide a re-formulation of
Schroedinger's equation, which is half of the defining equations of Bohmian
mechanics. I try to give a clear and concise description of the various aspects
of the situation.Comment: 4 pages LaTeX, no figures; v2 shortened a bi
Slow relaxation, confinement, and solitons
Millisecond crystal relaxation has been used to explain anomalous decay in
doped alkali halides. We attribute this slowness to Fermi-Pasta-Ulam solitons.
Our model exhibits confinement of mechanical energy released by excitation.
Extending the model to long times is justified by its relation to solitons,
excitations previously proposed to occur in alkali halides. Soliton damping and
observation are also discussed
- …