Fortran 4 program for two-impulse rendezvous analysis

Program determines if rendezvous in near space is possible, and performs an analysis to determine the approximate required values of the magnitude and direction of two thrust applications of the upper stage of a rocket firing. The analysis is performed by using ordinary Keplerian mechanics

Welded Titanium Case for Space-Probe Rocket Motor

Early in 1958, the Jet Propulsion Laboratory of the California Institute of Technology was requested to participate in a lunar-probe mission code-named Juno II which would place a 15-lb Instrumented payload (Pioneer IV) in the vicinity of the moon. The vehicle was to use the same high-speed upper-stage assembly as flown on the successful Jupiter-C configuration; however, the first-stage booster was to be a Jupiter rather than a Redstone. An analysis of the intended flight and payload configuration Indicated that the feasibility of accomplishing the mission was questionable and that additional performance would have to be obtained if the mission was to be feasible. Since the most efficient way of Increasing the performance of a staged vehicle is to increase the performance of the last stage, a study of possible ways of doing this was made.. Because of the time schedule placed on this effort It was decided to reduce the weight of the fourth-stage rocket-motor case by substituting the annealed 6Al--4V titanium alloy for the Type 410 stainless steel. Although this introduced an unfamiliar material, It reduced the changes in design and fabrication techniques. This particular titanium alloy was chosen on the basis of previous tests which proved the suitability of the alloy as a pressure-vessel material when used at an annealed yield strength of about 120, 000 psi. The titanium-case fourth stage of Juno U is shown with the payload and on the missile in Fig. 1; the stainless-steel motor cases used in the Jupiter-C vehicle are shown in Fig. 2. The fourth-stage motor case has a diameter of 6 in., a length of approximately 38 in. center dot and a nominal cylindrical wall thickness of 0.025 in. As shown in Fig. 1, the case serves as the structural support of the payload and is aligned to the upper stage assembly through an alignment ring. The nozzle is threaded into the end of the motor case, and is of the ceramic-coated steel design. Figure 3 shows a comparison of the components used to make the stainless steel and the 6A1--4V titanium alloy cases. The forward dome and aft fitting for the stainless steel assembly were fabricated from a combination of forged, spun and machined parts.. In order to facilitate the fabrication of the titanium alloy motor ) these components were machined from a large-diameter billet

Welded Titanium Case for Space-Probe Rocket Motor

The high strength-to-weight ratio of titanium alloys suggests their use for solid-propellant rocket-motor cases for high-performance orbiting or space-probe vehicles. The paper describes the fabrication of a 6-in.-diam., 0.025-in.-wall rocket-motor from the 6A1-4V titanium alloy. The rocket-motor case, used in the fourth stage of a successful JPL-NASA lunar-probe flight, was constructed using a design previously proven satisfactory for Type 410 stainless steel. The nature and scope of the problems peculiar to the use of the titanium alloy, which effected an average weight saving of 34%, are described

Seabird Bycatch in Pelagic Longline Fisheries Is Grossly Underestimated when Using Only Haul Data

Hundreds of thousands of seabirds are killed each year as bycatch in longline fisheries. Seabirds are predominantly caught during line setting but bycatch is generally recorded during line hauling, many hours after birds are caught. Bird loss during this interval may lead to inaccurate bycatch information. In this 15 year study, seabird bycatch was recorded during both line setting and line hauling from four fishing regions: Indian Ocean, Southern Ocean, Coral Sea and central Pacific Ocean. Over 43,000 albatrosses, petrels and skuas representing over 25 species were counted during line setting of which almost 6,000 seabirds attempted to take the bait. Bait-taking interactions were placed into one of four categories. (i) The majority (57%) of bait-taking attempts were “unsuccessful” involving seabirds that did not take the bait nor get caught or hooked. (ii) One-third of attempts were “successful” with seabirds removing the bait while not getting caught. (iii) One-hundred and seventy-six seabirds (3% of attempts) were observed being “caught” during line setting, with three albatross species – Laysan (Phoebastria immutabilis), black-footed (P. nigripes) and black-browed (Thalassarche melanophrys)– dominating this category. However, of these, only 85 (48%) seabird carcasses were retrieved during line hauling. Most caught seabirds were hooked through the bill. (iv) The remainder of seabird-bait interactions (7%) was not clearly observed, but likely involved more “caught” seabirds. Bait taking attempts and percentage outcome (e.g. successful, caught) varied between seabird species and was not always related to species abundance around fishing vessels. Using only haul data to calculate seabird bycatch grossly underestimates actual bycatch levels, with the level of seabird bycatch from pelagic longline fishing possibly double what was previously thought

A feedback loop links brownification to anoxia in a temperate, shallow lake

This study examines a natural, rapid, fivefold increase in dissolved organic carbon (DOC) concentrations in a temperate shallow lake, describing the processes by which increased DOC resulted in anoxic conditions and altered existing carbon cycling pathways. High precipitation for two consecutive years led to rising water levels and the flooding of adjacent degraded peatlands. Leaching from the flooded soils provided an initial increase in DOC concentrations (from a 2010 mean of 12 ± 1 mg L−1 to a maximum concentration of 53 mg L−1 by June 2012). Increasing water levels, DOC, and phytoplankton concentrations reduced light reaching the sediment surface, eliminating most benthic primary production and promoting anoxia in the hypolimnion. From January to June 2012 there was a sudden increase in total phosphorus (from 57 µg L−1 to 216 µg L−1), DOC (from 24.6 mg L−1 to 53 mg L−1), and iron (from 0.12 mg L−1 to 1.07 mg L−1) concentrations, without any further large fluxes in water levels. We suggest that anoxic conditions at the sediment surface and flooded soils produced a dramatic release of these chemicals that exacerbated brownification and eutrophication, creating anoxic conditions that persisted roughly 6 months below a water depth of 1 m and extended periodically to the water surface. This brownification-anoxia feedback loop resulted in a near-complete loss of macroinvertebrate and fish populations, and increased surface carbon dioxide (CO2) emissions by an order of magnitude relative to previous years

Defining and assessing spiritual health : a comparative study among 13- to 15-year-old pupils attending secular schools, Anglican schools, and private Christian schools in England and Wales

This article argues that the nation's commitment to young people involves proper concern for their physical health, their psychological health, and their spiritual health. In this context the notion of spiritual health is clarified by a critique of John Fisher's model of spiritual health. Fisher developed a relational model of spiritual health, which defines good spiritual health in terms of an individual's relationship to four domains: the personal, the communal, the environmental, and the transcendental. In the present analysis, we make comparisons between pupils educated in three types of schools: publicly funded schools without religious foundation, publicly funded schools with an Anglican foundation, and new independent Christian schools (not publicly funded). Our findings draw attention to significant differences in the levels of spiritual health experienced by pupils within these three types of schools

A common neural system mediating two different forms of social judgement

Background: A wide range of neuropsychiatric conditions, including schizophrenia and autistic spectrum disorder (ASD), are associated with impairments in social function. Previous studies have shown that individuals with schizophrenia and ASD have deficits in making a wide range of social judgements from faces, including decisions related to threat (such as judgements of approachability) and decisions not related to physical threat (such as judgements of intelligence). We have investigated healthy control participants to see whether there is a common neural system activated during such social decisions, on the basis that deficits in this system may contribute to the impairments seen in these disorders. Method: We investigated the neural basis of social decision making during judgements of approachability and intelligence from faces in 24 healthy participants using functional magnetic resonance imaging (fMRI). We used conjunction analysis to identify common brain regions activated during both tasks. Results: Activation of the amygdala, medial prefrontal cortex, inferior prefrontal cortex and cerebellum was seen during performance of both social tasks, compared to simple gender judgements from the same stimuli. Task-specific activations were present in the dorsolateral prefrontal cortex in the intelligence task and in the inferior and middle temporal cortex in the approachability task. Conclusions: The present study identified a common network of brain regions activated during the performance of two different forms of social judgement from faces. Dysfunction of this network is likely to contribute to the broad-ranging deficits in social function seen in psychiatric disorders such as schizophrenia and ASD

Determining the Role of IL-4 Induced Neuroinflammation in Microglial Activity and Amyloid-ß Using BV2 Microglial Cells and APP/PS1 Transgenic Mice

Background Microglia are considered the resident immune cells of the central nervous system (CNS). In response to harmful stimuli, an inflammatory reaction ensues in which microglia are activated in a sequenced spectrum of pro- and antiinflammatory phenotypes that are akin to the well-characterized polarization states of peripheral macrophages. A “classically” activated M1 phenotype is known to eradicate toxicity. The transition to an “alternatively” activated M2 phenotype encompasses neuroprotection and repair. In recent years, inflammation has been considered an accompanying pathology in response to the accumulation of extracellular amyloid-β (Aβ) in Alzheimer’s disease (AD). This study aimed to drive an M2a-biased immune phenotype with IL-4 in vitro and in vivo and to determine the subsequent effects on microglial activation and Aβ pathology. Methods In vitro, exogenous IL-4 was applied to BV2 microglial cell cultures to evaluate the temporal progression of microglial responses. In vivo, intracranial injections of an adeno-associate-virus (AAV) viral vector were performed to assess long-term expression of IL-4 in the frontal cortex and hippocampus of Aβ-depositing, APP/PS1 transgenic mice. Quantitative real-time PCR was used to assess the fold change in expression of biomarkers representing each of the microglial phenotypes in both the animal tissue and the BV2 cells. ELISAs quantified IL-4 expression and Aβ levels. Histological staining permitted quantification of microglial and astrocytic activity. Results Both in vitro and in vivo models showed an enhanced M2a phenotype, and the in vivo model revealed a trend toward a decreased trend in Aβ deposition. Conclusions In summary, this study offers insight into the therapeutic potential of microglial immune response in AD