206 research outputs found
Single Event Effects Testing of a Commercial-Off-The-Shelf Analog-to-Digital Converter in a Camera Application
Single event effect data is presented on the Analog Devices AD7984. The recent heavy-ion test results showcase application-specific results for the commercial part in its intended application
Development of the analog ASIC for multi-channel readout X-ray CCD camera
We report on the performance of an analog application-specific integrated
circuit (ASIC) developed aiming for the front-end electronics of the X-ray
CCDcamera system onboard the next X-ray astronomical satellite, ASTRO-H. It has
four identical channels that simultaneously process the CCD signals.
Distinctive capability of analog-to-digital conversion enables us to construct
a CCD camera body that outputs only digital signals. As the result of the
front-end electronics test, it works properly with low input noise of =<30 uV
at the pixel rate below 100 kHz. The power consumption is sufficiently low of
about 150 mW/chip. The input signal range of 720 mV covers the effective energy
range of the typical X-ray photon counting CCD (up to 20 keV). The integrated
non-linearity is 0.2% that is similar as those of the conventional CCDs in
orbit. We also performed a radiation tolerance test against the total ionizing
dose (TID) effect and the single event effect. The irradiation test using 60Co
and proton beam showed that the ASIC has the sufficient tolerance against TID
up to 200 krad, which absolutely exceeds the expected amount of dose during the
period of operating in a low-inclination low-earth orbit. The irradiation of Fe
ions with the fluence of 5.2x10^8 Ion/cm2 resulted in no single event latchup
(SEL), although there were some possible single event upsets. The threshold
against SEL is higher than 1.68 MeV cm^2/mg, which is sufficiently high enough
that the SEL event should not be one of major causes of instrument downtime in
orbit.Comment: 16 pages, 6 figure
Event-driven charge-coupled device design and applications therefor
An event-driven X-ray CCD imager device uses a floating-gate amplifier or other non-destructive readout device to non-destructively sense a charge level in a charge packet associated with a pixel. The output of the floating-gate amplifier is used to identify each pixel that has a charge level above a predetermined threshold. If the charge level is above a predetermined threshold the charge in the triggering charge packet and in the charge packets from neighboring pixels need to be measured accurately. A charge delay register is included in the event-driven X-ray CCD imager device to enable recovery of the charge packets from neighboring pixels for accurate measurement. When a charge packet reaches the end of the charge delay register, control logic either dumps the charge packet, or steers the charge packet to a charge FIFO to preserve it if the charge packet is determined to be a packet that needs accurate measurement. A floating-diffusion amplifier or other low-noise output stage device, which converts charge level to a voltage level with high precision, provides final measurement of the charge packets. The voltage level is eventually digitized by a high linearity ADC
Large-area submillimeter resolution CdZnTe strip detector for astronomy
We report the first performance measurements of a sub-millimeter CdZnTe strip detector developed as a prototype for space-borne astronomical instruments. Strip detector arrays can be used to provide two-dimensional position resolution with fewer electronic channels than pixellated arrays. Arrays of this type and other candidate technologies are under investigation for the position-sensitive backplane detector for a coded-aperture telescope operating in the range of 30 - 300 keV. The prototype is a 1.4 mm thick, 64 multiplied by 64 stripe CdZnTe array of 0.375 mm pitch in both dimensions, approximately one square inch of sensitive area. Pulse height spectra in both single and orthogonal stripe coincidence mode were recorded at several energies. The results are compared to slab- and pixel-geometry detector spectra. The room-temperature energy resolution is less than 10 keV (FWHM) for 122 keV photons with a peak-to-valley ratio greater than 5:1. The response to photons with energies up to 662 keV appears to be considerably improved relative to that of previously reported slab and pixel detectors. We also show that strip detectors can yield spatial and energy resolutions similar to those of pixellated arrays with the same dimensions. Electrostatic effects on the pulse heights, read-out circuit complexity, and issues related to design of space borne instruments are also discussed
Development of an orthogonal-stripe CdZnTe gamma radiation imaging spectrometer
We report performance measurements of a sub-millimeter resolution CdZnTe strip detector developed as a prototype for astronomical instruments operating with good efficiency in the 30-300 keV photon energy range. The prototype is a 1.4 mm thick, 64×64 contact stripe CdZnTe array of 0.375 mm pitch in both dimensions. Pulse height spectra were recorded in orthogonal-stripe coincidence mode which demonstrate room-temperature energy resolution \u3c10 keV (FWHM) for 122 keV photons with a peak-to-valley ratio \u3e5:1. Good response is also demonstrated at higher energies using a coplanar grid readout configuration. Spatial resolution capabilities finer than the stripe pitch are demonstrated. We present the image of a 133Ba source viewed through a collimator slit produced by a 4×4 stripe detector segment. Charge signals from electron and hole collecting contacts are also discussed
TESS Data Release Notes: Sector 16, DR22
This release note discusses the science data products produced by the Science Processing Operations Center at Ames Research Center from Sector 16 observations made with the TESS spacecraft and cameras as a means to document instrument performance and data characteristics
TESS Data Release Notes: Sector 20, DR27
This release note discusses the science data products produced by the Science Processing Operations Center at Ames Research Center from Sector 20 observations made with the TESS spacecraft and cameras as a means to document instrument performance and data characteristics
CdZnTe strip detectors as sub-millimeter resolution imaging gamma radiation spectrometers
We report γ-ray detection performance measurements and computer simulations of a sub-millimeter pitch CdZnTe strip detector. The detector is a prototype for γ-ray measurements in the range of 20-600 keV. The prototype is a 1.5 mm thick, 64×64 orthogonal stripe CdZnTe detector of 0.375 mm pitch in both dimensions, with approximately one square inch of sensitive area. Using discrete laboratory electronics to process signals from an 8×8 stripe region of the prototype we measured good spectroscopic uniformity and sub-pitch (~0.2 mm) spatial resolution in both x and y dimensions. We present below measurements of the spatial uniformity, relative timing and pulse height of the anode and cathode signals. We simulated the photon interactions and signal generation in the strip detector and the test electronics and we compare these results with the data. The data indicate that cathode signal-as well as the anode signal-arises more strongly from the conduction electrons rather than the holes
Performance of CdZnTe strip detectors as sub-millimeter resolution imaging gamma radiation spectrometers
We report & gamma;-ray detection performance measurements and computer simulations of a sub-millimeter pitch CdZnTe strip detector. The detector is a prototype for & gamma;-ray astronomy measurements in the range of 20-200 keV. The prototype is a 1.5 mm thick, 64×64 orthogonal stripeCdZnTe detector of 0.375 mm pitch in both dimensions, with approximately one square inch of sensitive area. Using discrete laboratory electronics to process signals from an 8×8 stripe region of the prototype we measured good spectroscopic uniformity and sub-pitch (~0.2 mm) spatial resolution in both x and y dimensions. We present below measurements of the spatial uniformity, relative timing and pulse height of the anode and cathode signals, and the photon detection efficiency. We also present a technique for determining the location of the event in the third dimension (depth). We simulated the photon interactions and signal generation in the strip detector and the test electronics and we compare these results with the data. The data indicate that the cathode signal-as well as the anode signal-arises more strongly from the conduction electrons rather than the holes
- …