8,808 research outputs found
Measurement and analysis of cryogenic sapphire dielectric resonators and DROs
Presented are the experimental and computational results of a study on a new kind of dielectric resonator oscillator (DRO). It consists of a cooled, cylindrically symmetric sapphire resonator surrounded by a metallic shield and is capable of higher Q's than any other dielectric resonator. Isolation of fields to the sapphire by the special nature of the electromagnetic mode allows the very low loss of the sapphire itself to be expressed. Calculations show that the plethora of modes in such resonators can be effectively reduced through the use of a ring resonator with appropriate dimensions. Experimental results show Q's ranging from 3 x 10 to the 8th at 77 K to 10 to the 9th at 4.2 K. Performance is estimated for several types of DROs incorporating these resonators. Phase noise reductions in X-band sources are indicated at values substantially lower than those previously available
Efficient calculation of the worst-case error and (fast) component-by-component construction of higher order polynomial lattice rules
We show how to obtain a fast component-by-component construction algorithm
for higher order polynomial lattice rules. Such rules are useful for
multivariate quadrature of high-dimensional smooth functions over the unit cube
as they achieve the near optimal order of convergence. The main problem
addressed in this paper is to find an efficient way of computing the worst-case
error. A general algorithm is presented and explicit expressions for base~2 are
given. To obtain an efficient component-by-component construction algorithm we
exploit the structure of the underlying cyclic group.
We compare our new higher order multivariate quadrature rules to existing
quadrature rules based on higher order digital nets by computing their
worst-case error. These numerical results show that the higher order polynomial
lattice rules improve upon the known constructions of quasi-Monte Carlo rules
based on higher order digital nets
Microwave oscillator with reduced phase noise by negative feedback incorporating microwave signals with suppressed carrier
Oscillator configurations which reduce the effect of 1/f noise sources for both direct feedback and stabilized local oscillator (STALO) circuits are developed and analyzed. By appropriate use of carrier suppression, a small signal is generated which suffers no loss of loop phase information or signal-to-noise ratio. This small signal can be amplified without degradation by multiplicative amplifier noise, and can be detected without saturation of the detector. Together with recent advances in microwave resonator Qs, these circuit improvements will make possible lower phase noise than can be presently achieved without the use of cryogenic devices
Fast autotuning of a hydrogen maser by cavity Q modulation
A new fast autotuner for the hydrogen maser was implemented. By modulating the cavity, a phase shift in the maser output signal is induced which is proportional to the cavity tuning error. The phase shift is detected and fed back to a varactor tuner to stabilize the cavity against long-term drifts. Also, a PIN-diode cavity modulator which gives no incidental frequency shift over a very wide range of operation was developed. Modulated at over 200 Hz, it allows variations in maser cavity frequency to be compensated with a loop gain greater than 1000. Compensation of incidental amplitude modulation of the output was demonstrated
New ion trap for atomic frequency standard applications
A novel linear ion trap that permits storage of a large number of ions with reduced susceptibility to the second-order Doppler effect caused by the radio frequency (RF) confining fields has been designed and built. This new trap should store about 20 times the number of ions a conventional RF trap stores with no corresponding increase in second-order Doppler shift from the confining field. In addition, the sensitivity of this shift to trapping parameters, i.e., RF voltage, RF frequency, and trap size, is greatly reduced
Atomic frequency standards for ultra-high-frequency stability
The general features of the Hg-199(+) trapped-ion frequency standard are outlined and compared to other atomic frequency standards, especially the hydrogen maser. The points discussed are those which make the trapped Hg-199(+) standard attractive: high line Q, reduced sensitivity to external magnetic fields, and simplicity of state selection, among others
The JPL trapped mercury ion frequency standard
In order to provide frequency standards for the Deep Space Network (DSN) which are more stable than present-day hydrogen masers, a research task was established under the Advanced Systems Program of the TDA to develop a Hg-199(+) trapped ion frequency standard. The first closed-loop operation of this kind is described. Mercury-199 ions are confined in an RF trap and are state-selected through the use of optical pumping with 194 nm UV light from a Hg-202 discharge lamp. Absorption of microwave radiation at the hyperfine frequency (40.5 GHz) is signaled by atomic fluorescence of the UV light. The frequency of a 40.5 GHz oscillator is locked to a 1.6 Hz wide atomic absorption line of the trapped ions. The measured Allan variance of this locked oscillator is currently gamma sub y (pi) = 4.4 x 10 to the minus 12th/square root of pi for 20 is less than pi is less than 320 seconds, which is better stability than the best commercial cesium standards by almost a factor of 2. This initial result was achieved without magnetic shielding and without regulation of ion number
Comparison of Standard Length, Fork Length, and Total Length for Measuring West Coast Marine Fishes
Measurements of adult marine fishes on the U.S. west coast are usually made using one of three methods: standard
length, fork length, or total length. Each method has advantages and disadvantages. In this paper we attempt to determine whether one method is faster and/or more reliable than the other methods.
We found that all three methods were comparable. There was no appreciable difference in the time it took to measure fish using the different methods. Fork length had the most reproducible results; however, it had the highest level of bias between researchers. We therefore suggest that
selection of measurement type be based on what other researchers have used for the species under study. The best improvement in measurement reliability probably occurs
by adequate training of personnel and not type of measurement used
A superconducting microwave engine
In this paper a new technique of electromechanical energy conversion is proposed. This technique would make use of the high Q's attainable in superconducting resonators to achieve direct mechanical to microwave energy conversion with a net efficiency greater than 90% a value which is far higher than that obtained by conventional techniques. In addition, if surface magnetic and electric field levels are limited by the critical fields obtained in fixed resonators, power densities would be achieved which are large enough to make such a machine a practical means both for generating microwave energy and for re-converting the microwave again to mechanical energy for power transmission purposes
Statistical evaluation of control inputs and eye movements in the use of instruments clusters during aircraft landing
Two different types of analyses were done on data from a study in which eye movements and other variables were recorded while four pilots executed landing sequences in a Boeing 737 simulation. Various conditions were manupulated, including changes in turbulence, starting position, and instrumentation. Control inputs were analyzed in the context of the various conditions and compared against ratings of workload obtained using the Cooper-Harper scale. A number of eye-scanning measures including mean dwell time and transition from one instrument to another were entered into a principal components factor analysis. The results show a differentiation between control inputs and eye-scanning behavior. This shows the need for improved definition of workload and experiments to uncover the important differences among control inputs, eye-scanning and cognitive processes of the pilot
- …