Determination of the Aspect-ratio Distribution of Gold Nanorods in a Colloidal Solution using UV-visible absorption spectroscopy

Knowledge of the distribution of the aspect ratios (ARs) in a chemically-synthesized colloidal solution of Gold Nano Rods (GNRs) is an important measure in determining the quality of synthesis, and consequently the performance of the GNRs generated for various applications. In this work, an algorithm has been developed based on the Bellman Principle of Optimality to readily determine the AR distribution of synthesized GNRs in colloidal solutions. This is achieved by theoretically fitting the longitudinal plasmon resonance of GNRs obtained by UV-visible spectroscopy. The AR distribution obtained from the use of the algorithm developed have shown good agreement with those theoretically generated one as well as with the previously reported results. After bench-marking, the algorithm has been applied to determine the mean and standard deviation of the AR distribution of two GNRs solutions synthesized and examined in this work. The comparison with experimentally derived results from the use of expensive Transmission Electron Microscopic images and Dynamic Light Scattering technique shows that the algorithm developed offers a fast and thus potentially cost-effective solution to determine the quality of the synthesized GNRs specifically needed for many potential applications for the advanced sensor systems

Key Success Factors and Future Perspective of Silicon-Based Solar Cells

Today, after more than 70 years of continued progress on silicon technology, about 85% of cumulative installed photovolatic (PV) modules are based on crystalline silicon (c-Si). PV devices based on silicon are the most common solar cells currently being produced, and it is mainly due to silicon technology that the PV has grown by 40% per year over the last decade. An additional step in the silicon solar cell development is ongoing, and it is related to a further efficiency improvement through defect control, device optimization, surface modification, and nanotechnology approaches. This paper attempts to briefly review the most important advances and current technologies used to produce crystalline silicon solar devices and in the meantime the most challenging and promising strategies acting to increase the efficiency to cost/ratio of silicon solar cells. Eventually, the impact and the potentiality of using a nanotechnology approach in a silicon-based solar cell are also described

Isotope and Quantum Effects in Vibrational State Distributions of Photodesorbed Ammonia

A marked quantum effect has been observed in the vibrational state distribution of photodesorbed ammonia. Namely, for quantum numbers larger than zero, symmetric and antisymmetric levels in the ν2 mode of the desorbed ammonia molecule are unequally populated. A strong propensity for symmetric levels is observed for NH3, whereas the reverse is found for ND3. Model calculations reproduce this effect. Moreover, it is found that the actual ratios probe the binding energy in the energetically less favorable inverted geometry with the H atoms pointing towards the surface

Assessment of the composition of Silicon-Rich Oxide films for photovoltaic applications by optical techniques

Abstract The deposition of sub-stoichiometric silicon rich oxide (SRO) is the first step to obtain well ordered silicon Quantum Dots (QDs) in a dielectric matrix. This structure is used also for third generation photovoltaic devices operating in a tandem architecture. A precise control and assessment of the stoichiometry of these films is crucial to tune the electrical and optical properties of the device. In this paper we discuss two optical techniques to assess the composition of such films and we compare their results

Physical determinants of Division 1 Collegiate basketball, Women’s National Basketball League and Women’s National Basketball Association athletes: with reference to lower body sidedness

In female basketball the assumed components of success include power, agility, and the proficiency at executing movements using each limb. However, the importance of these attributes in discriminating between playing levels in female basketball have yet to be determined. The purpose of this study was to compare lower body power, change of direction (COD) speed, agility, and lower-body sidedness between basketball athletes participating in Division 1 Collegiate basketball (United States), Women\u27s National Basketball League (WNBL) (Australia), and Women\u27s National Basketball Association (WNBA) (United States). Fifteen female athletes from each league (N = 45) completed a double and single leg counter-movement jump, static jump, drop jump, 5-0-5 COD Test, and an offensive and defensive Agility Test. One-way analysis of variance with post-hoc comparisons, were conducted to compare differences in physical characteristics (height, body mass, age) and performance outcomes (jump, COD, agility assessments) between playing levels. Separate dependent t-tests were performed to compare lower body sidedness (left vs. right lower-limbs) during the single-leg CMJ jumps (vertical jump height) and 5-0-5 COD test for each limb within each playing level. WNBA athletes displayed significantly greater lower body power (P = 0.01 - 0.03) compared to WNBL athletes, significantly faster COD speed (P = 0.02 - 0.03), and offensive and defensive agility performance (P = 0.02 - 0.03) compared to WNBL and Collegiate athletes. WNBL athletes also produced faster defensive agility performance compared to Collegiate athletes (P = 0.02). Further, WNBA and WNBL athletes exhibited reduced lower body sidedness compared to Collegiate athletes. These findings indicate the importance of lower body power, agility, and reduced lower body imbalances to execute more proficient on court movements, required to compete at higher playing levels. Copyright (C) 2017 by the National Strength & Conditioning Association

Effect of P‐induced gettering on extended defects in n‐type multicrystalline silicon

AbstractThe electrical properties and the minority charge carrier recombination behaviour of grain boundaries (GBs) and intragrain dislocations in different n‐type multicrystalline silicon (mc‐Si) ingots were systematically studied through microwave‐detected PhotoConductance Decay (µW‐PCD), Electron Beam Induced Current (EBIC) and PhotoLuminescence (PL) spectroscopy on as‐grown samples and on samples submitted to P‐diffusion step. It was confirmed that the overall quality of n‐type mc‐Si is high, indicating that n‐type‐Si is a valid source for photovoltaic applications. As expected, the average lifetime increases after the P‐diffusion process, which induces impurity gettering effects at the external surfaces, like in the case of p‐type samples, but an evident local increase of electrical activity of some GBs after that process was also observed using the EBIC mapping technique. Apparently, a redistribution of impurities occurs at the processing temperature and impurities are captured at the deepest sinks. In fact, while all GBs act as heterogeneous segregation/precipitation sites, some of them will compete with the external surfaces sinks, partly vanishing the effect of P‐gettering. Last but not least, it was experimentally demonstrated that the average lifetime values measured with the µW‐PCD technique well correlate with the recombination activity of GBs measured with the EBIC technique, showing the extreme importance of GBs on the effective lifetime of this material. Copyright © 2007 John Wiley & Sons, Ltd

Growth and Characterization of Cu2Zn1-xFexSnS4 Thin Films for Photovoltaic Applications.

Photovoltaics is a promising technology to produce sustainable energy, thanks to the high amount of energy emitted by the sun. One way of having solar cells with low production costs is to apply thin-film technology and with earth-abundant raw materials. A keen interest is arising in kesterite compounds, which are chalcogenides composed of abundant and non-toxic elements. They have already achieved excellent performance at the laboratory level. Here, we report the synthesis and characterization of mixed chalcogenides based on copper, zinc, iron, and tin. Solutions have been studied with different zinc and iron ratios. The distortion of the elementary cell of kesterite increases with the addition of iron until a phase transition to stannite occurs. The process of synthesis and deposition proposed herein is cheap and straightforward, based on the sol-gel technique. These thin films are particularly attractive for use in cheap and easily processable solar cells. The synthesized layers have been characterized by X-ray diffraction, UV-Vis absorption, and Raman, X-ray photoelectron, and energy-dispersive X-ray spectroscopy measurements

Hybrid sputtering/evaporation deposition of Cu(In,Ga)Se2 thin film solar cells

n/

Indium phosphide based membrane photodetector for optical interconnects on silicon

We have designed, fabricated and characterized an InP-based membrane photodetector on an SOI wafer containing a Si-wiring photonic circuit. New results on RF characterization up to 20 GHz are presented. The detector fabrication is compatible with wafer scale processing steps, guaranteeing compatibility towards future generation electronic IC processing