Electrical characterization of top-gated molybdenum disulfide field-effect-transistors with high-k dielectrics

High quality HfO2 and Al2O3 substrates are fabricated in order to study their impact on top-gate MoS2 transistors. Compared with top-gate MoS2 FETs on a SiO2 substrate, the field effect mobility decreased for devices on HfO2 substrates but substantially increased for devices on Al2O3 substrates, possibly due to substrate surface roughness. A forming gas anneal is found to enhance device performance due to a reduction in charge trap density of the high-k substrates. The major improvements in device performance are ascribed to the forming gas anneal. Top-gate devices built upon Al2O3 substrates exhibit a near-ideal subthreshold swing (SS) of ~ 69 mV/dec and a ~ 10 × increase in field effect mobility, indicating a positive influence on top-gate device performance even without any backside bias

Probing interface defects in top-gated MoS2 transistors with impedance spectroscopy

The electronic properties of the HfO2/MoS2 interface were investigated using multifrequency capacitance–voltage (C–V) and current–voltage characterization of top-gated MoS2 metal–oxide–semiconductor field effect transistors (MOSFETs). The analysis was performed on few layer (5–10) MoS2 MOSFETs fabricated using photolithographic patterning with 13 and 8 nm HfO2 gate oxide layers formed by atomic layer deposition after in-situ UV-O3 surface functionalization. The impedance response of the HfO2/MoS2 gate stack indicates the existence of specific defects at the interface, which exhibited either a frequency-dependent distortion similar to conventional Si MOSFETs with unpassivated silicon dangling bonds or a frequency dispersion over the entire voltage range corresponding to depletion of the HfO2/MoS2 surface, consistent with interface traps distributed over a range of energy levels. The interface defects density (Dit) was extracted from the C–V responses by the high–low frequency and the multiple-frequency extraction methods, where a Dit peak value of 1.2 × 1013 cm–2 eV–1 was extracted for a device (7-layer MoS2 and 13 nm HfO2) exhibiting a behavior approximating to a single trap response. The MoS2 MOSFET with 4-layer MoS2 and 8 nm HfO2 gave Dit values ranging from 2 × 1011 to 2 × 1013 cm–2 eV–1 across the energy range corresponding to depletion near the HfO2/MoS2 interface. The gate current was below 10–7 A/cm2 across the full bias sweep for both samples indicating continuous HfO2 films resulting from the combined UV ozone and HfO2 deposition process. The results demonstrated that impedance spectroscopy applied to relatively simple top-gated transistor test structures provides an approach to investigate electrically active defects at the HfO2/MoS2 interface and should be applicable to alternative TMD materials, surface treatments, and gate oxides as an interface defect metrology tool in the development of TMD-based MOSFETs

Evaluation of border traps and interface traps in HfO2/MoS2 gate stacks by capacitance - voltage analysis

Abstract Border traps and interface traps in HfO2/few-layer MoS2 top-gate stacks are investigated by C-V characterization. Frequency dependent C-V data shows dispersion in both the depletion and accumulation regions for the MoS2 devices.The border trap density is extracted with a distributed model, and interface traps are analyzed using the high-low frequency and multi-frequency methods. The physical origins of interface traps appear to be caused by impurities/defects in the MoS2 layers, performing as band tail states, while the border traps are associated with the dielectric, likely a consequence of the low-temperature deposition. This work provides a method of using multiple C-V measurements and analysis techniques to analyze the behavior of high-k/TMD gate stacks and deconvolute border traps from interface traps

Al2O3 on WSe2 by ozone based atomic layer deposition: Nucleation and interface study

In this work, the atomic layer deposition process using ozone and trimethylaluminum (TMA) for the deposition of Al2O3 films on WSe2 was investigated. It was found that the ozone-based atomic layer deposition enhanced the nucleation of Al2O3 in comparison to the water/TMA process. In addition, the chemistry at the Al2O3/WSe2 interface and the surface morphology of the Al2O3 films exhibited a dependence on the deposition temperature. A non-covalent functionalizing effect of ozone on WSe2 at low deposition temperatures 30 °C was identified which prevented the formation of pinholes in the Al2O3 films. These findings aim to provide an approach to obtain high-quality gate dielectrics on WSe2 for two-dimensional transistor applications