71 research outputs found

    Application of Computer Simulation to Study the Features of the Austenite Isothermal Transformation in Steels

    Get PDF
    An algorithm was developed for the simulation of a phase transition in solid state which makes it possible to obtain the kinetic curves of transformation under different initial conditions (the number and arrangement of new phase nuclei, the distance between the nearest nuclei). The simulation results were analyzed using the KolmogorovJohnson-Mehl-Avrami equation and the corresponding coefficients were determined. The correlation between the simulation results and the experimental kinetics of the austenite isothermal transformation in alloyed steels was shown.     Keywords: computer simulation; modeling; phase transformation; kinetics; KJMA equation; logistic function; steel

    Measurement of ϕ\phi(1020) meson leptonic width with CMD-2 detector at VEPP-2M Collider

    Full text link
    The ϕ\phi(1020) meson leptonic width has been determined from the combined analysis of 4 major decay modes of the resonance (ϕK+K,KL0KS0,π+ππ0,ηγ\phi\to K^+ K^-,K^0_LK^0_S,\pi^+\pi^-\pi^0,\eta\gamma) studied with the CMD-2 detector at the VEPP-2M e+ee^+e^- collider. The following value has been obtained: Γ(ϕe+e)=1.235±0.006±0.022\Gamma(\phi\to e^+e^-) = 1.235\pm 0.006\pm 0.022 keV. The ϕ(1020)\phi(1020) meson parameters in four main decay channels have been also recalculated: B(ϕK+K)=0.493±0.003±0.007B(\phi\to K^+K^-) = 0.493\pm 0.003\pm 0.007, B(ϕKLKS)=0.336±0.002±0.006B(\phi\to K_LK_S) = 0.336\pm 0.002\pm 0.006, B(ϕπ+ππ0)=0.155±0.002±0.005B(\phi\to\pi^+\pi^-\pi^0) = 0.155\pm 0.002\pm 0.005, B(ϕηγ)=0.0138±0.0002±0.0002B(\phi\to\eta\gamma) = 0.0138\pm 0.0002\pm 0.0002.Comment: 14 pages, 3 figure

    Study of the radiative decay ϕηγ\phi \to \eta \gamma with CMD-2 detector

    Full text link
    Using the 1.9pb11.9 pb^{-1} of data collected with the CMD-2 detector at VEPP-2M the decay mode ϕηγ\phi \to \eta \gamma, ηπ+ππ0\eta \to \pi^+\pi^-\pi^0 has been studied. The obtained branching ratio is B(ϕηγ)=(1.18±0.03±0.06)\phi \to \eta \gamma) = (1.18 \pm 0.03 \pm 0.06) %.Comment: 13 pages, 5 figures, LaTex2e, to be published in Phys. Lett.

    Observation of KS0K_S^0 semileptonic decays with CMD-2 detector

    Full text link
    The decay KS0πeνK_S^0 \to \pi e \nu has been observed by the CMD-2 detector at the e^+e^- collider VEPP-2M at Novosibirsk. Of 6 million produced KL0KS0K_L^0K_S^0 pairs, 75±1375 \pm 13 events of the KS0πeνK_S^0 \to \pi e \nu decay were selected. The corresponding branching ratio is B(KS0πeν)=(7.2±1.4)×104B(K_S^0 \to \pi e \nu)=(7.2 \pm 1.4)\times10^{-4}. This result is consistent with the evaluation of B(KS0πeν)B(K_S^0 \to \pi e \nu) from the KL0K_L^0 semileptonic rate and KS0K_S^0 lifetime assuming ΔS=ΔQ\Delta S=\Delta Q .Comment: 7 pages, 6 figures, LaTex2e. Submitted to Phys.Lett.

    Measurement of omega meson parameters in pi^+pi^-pi^0 decay mode with CMD-2

    Full text link
    About 11 200 e^+e^- -> omega -> pi^+pi^-pi^0 events selected in the center of mass energy range from 760 to 810 MeV were used for the measurement of the \omega meson parameters. The following results have been obtained: sigma _{0}=(1457 \pm 23 \pm 19)nb, m_{\omega}=(782.71 \pm 0.07 \pm 0.04) MeV/c^{2}, \Gamma_{\omega}=(8.68 \pm 0.23 \pm 0.10) MeV, \Gamma_{e^+e^-}\cdot Br (\omega -> pi^+pi^-pi^0)= (0.528 \pm 0.012 \pm 0.007) \cdot 10^{-3} MeV.Comment: 8 pages, 4 figure

    Study of the Process e+eKL0KS0e^+e^- \to K^0_L K^0_S in the C.M.Energy Range 1.05-1.38 GeV with CMD-2

    Full text link
    The process e+eKL0KS0e^+e^- \to K^0_L K^0_S has been studied with the CMD-2 detector using about 950 events detected in the center-of-mass energy range from 1.05 to 1.38 GeV. The cross section exceeds the expectation based on the contributions of the rho(770), omega(782) and phi(1020) mesons only.Comment: 12 pages, 3 figures, uses elsart.cls, submitted to Physics Letters
    corecore