An experimental investigation of leading-edge vortex augmentation by blowing

A wind tunnel test was conducted to determine the effects of over-the-wing blowing as a means of augmenting the leading-edge vortex flow of several pointed-tip, sharp-edged planforms. Arrow, delta, and diamond wings with leading-edge sweeps of 30 and 45 degrees were mounted on a body-of-revolution fuselage and tested in a low-speed wind tunnel at a Mach number of 0.2. Nozzle location data, pitch data, and flow-visualization pictures were obtained for a range of blowing rates. Results show pronounced increases in vortex lift due to the blowing

Reduced-order modelling of thick inertial flows around rotating cylinders

A new model for the behaviour of a thick, two-dimensional layer of fluid on the surface of a rotating cylinder is presented, incorporating the effects of inertia, rotation, viscosity, gravity and capillarity. Comparisons against direct numerical simulations (DNS) show good accuracy for fluid layers of thickness of the same order as the cylinder radius, even for Reynolds numbers up to Re∼10. A rich and complex parameter space is revealed, and is elucidated via a variety of analytical and numerical techniques. At moderate rotation rates and fluid masses, the system exhibits either periodic behaviour or converges to a steady state, with the latter generally being favoured by greater masses and lower rotation rates. These behaviours, and the bifurcation structure of the transitions between them, are examined using a combination of both the low-order model and DNS. Specific attention is dedicated to newly accessible regions of parameter space, including the multiple steady state solutions observed for the same parameter values by Lopes et al.(2018), where the corresponding triple limit point bifurcation structure is recovered by the new low-order model. We also inspect states in which the interface becomes multivalued - and thus outside the reach of the reduced-order model - via DNS.This leads to highly nonlinear multivalued periodic structures appearing at moderate thicknesses and relatively large rotation rates. Even much thicker films may eventually reach steady states (following complex early evolution), provided these are maintained by a combination of forces sufficiently large to counteract gravity

Total ownership cost reduction case study : AEGIS radar phase shifters

MBA Professional ReportThe goal of this research is to provide a case study that captures the production and design processes and program management solutions used to reduce total ownership costs of AEGIS Radar Phase Shifters. Specifically, it will focus on the design and redesign of the SPY-1 radar phase shifter; a redesign that dramatically improved performance without increasing Average Procurement Unit Costs (APUC). The researchers will analyze various process-improvement projects (PIP) used to reduce touch-labor and improve production process yield (percentage of manufactured items that are defect-free) of SPY-1B/D phase shifters, and will review programs that improved phase shifter production either directly or indirectly, i.e., consolidated purchasing, lean and six sigma, productivity improvement projects, etc. This case study was conducted with the sponsorship and assistance of the Acquisition Research Program, Graduate School of Business & Public Policy, Naval Postgraduate School, Monterey, CA.http://archive.org/details/totalownershipco1094534231Lieutenant Commander, United States NavyCaptain, United States Air ForceApproved for public release; distribution is unlimited

Ensemble averaged dynamic modeling

The possibility of using the information from simultaneous equivalent Large Eddy Simulations (LAS) for improving the subgrid scale modeling is investigated. An ensemble average dynamic model is proposed as an alternative to the usual spatial average versions. It is shown to be suitable independently of the existence of any homogeneity directions, and its formulation is thus universal. The ensemble average dynamic model is shown to give very encouraging results for as few as 16 simultaneous LES's

Does Cognitive Functioning Mediate the Well-Documented Link between Education and Functional Disability in Middle-Aged Adults?

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/73928/1/j.1749-6632.1999.tb08175.x.pd

The Mid-IR Spectral Effects of Darkening Agents and Porosity on the Silicate Surface Features of Airless Bodies

We systematically measured the mid-IR spectra of different mixtures of three silicates (antigorite, lizardite, and pure silica) with varying effective porosities and amounts of darkening agent (iron oxide and carbon). These spectra have broad implications for interpretation of current and future mission data for airless bodies, as well as for testing the capabilities of new instruments. Serpentines, such as antigorite and lizardite, are common to airless surfaces, and their mid-IR spectra in the presence of darkening agents and different surface porosities would be typical for those measured by spacecraft. Silica has only been measured in the plumes of Enceladus and presents exciting possibilities for other Saturn-system surfaces due to long range transport of E-ring material. Results show that the addition of the IR-transparent salt, KBr, to simulate surface porosity affected silicate spectra in ways that were not predictable from linear mixing models. The strengthening of silicate bands with increasing pore space, even when only trace amounts of KBr were added, indicates that spectral features of porous surfaces are more detectable in the mid-IR. Combining iron oxide with the pure silicates seemed to flatten most of the silicate features, but strengthened the reststrahlen band of the silica. Incorporating carbon with the silicates weakened all silicate features, but the silica bands were more resistant to being diminished, indicating silica may be more detectable in the mid-IR than the serpentines. We show how incorporating darkening agents and porosity provides a more complete explanation of the mid-IR spectral features previously reported on worlds such as Iapetus

Electrostatic control of the Navier-Stokes equations for thin films

A robust control scheme is derived and tested for the Navier--Stokes equations for two-dimensional multiphase flow of a thin film underneath an inclined solid surface. Control is exerted via the use of an electrode parallel to the substrate, which induces an electric field in the gas phase, and a resultant Maxwell stress at the liquid-gas interface. The imposed potential at the second electrode is derived using a Model Predictive Control loop, together with optimal control of a high-fidelity reduced-order model. In this implementation the interfacial shape of the fluid is successfully controlled, however the algorithm is sufficiently general to control any other quantity of interest.Comment: 8 pages, 5 figure

Fatalities due to intestinal obstruction following the ingestion of foreign bodies

Two fatalities due to an occlusive ileus following the ingestion of foreign bodies in patients with psychiatric disorders are described. A severely mentally handicapped young man developed a temperature and died 1 h after admission to a surgical ward. At autopsy, not, vert, similar 2000 cm3 of foreign material, including broken glass and porcelain, branches, buttons, parts of clothing and other material were found in the gastrointestinal tract, leading to a complete obstruction of the distal intestine and colon with resulting faecal vomiting. The other case was even more unusual as a hair fetishist had swallowed a thick strand of his own hair, 50 cm long, also resulting in mechanical obstruction of the distal intestine