95 research outputs found

    Biosorption of phenolic compounds from aqueous solutions using pine (Pinus densiflora Sieb) bark powder

    Get PDF
    The present study describes the development of a new bioadsorbent from lignocellulosic wastes of agricultural origin. The biosorption capacity of an agricultural solid waste, pine bark (Pinus densiflora Sieb.), to remove phenolic compounds (phenol, 2-chlorophenol (2-CPh), and 4- chlorophenol (4-CPh)) from aqueous solutions under batch equilibrium conditions was investigated. The morphological characteristics of the biosorbent were evaluated by BET surface area analysis, Fourier transform infrared spectroscopy (FTIR), elemental analysis, an X-ray diffractometer (XRD), and a scanning electron microscope (SEM). Batch experiments were conducted to investigate the effect of initial pH (2 to 10), contact time, initial concentration of adsorbate (50 to 200 mg/L), and biosorbent dosage. The biosorption of phenolic compounds decreased with increasing pH, and the highest biosorption capacity was achieved at a pH of 6.0. Biosorption equilibrium was established in 120 min. The biosorption equilibrium data were fitted and analyzed with Langmuir, Freundlich, and Dubinin-Radushkevich isotherm equations, as well as four adsorption kinetic models. The kinetics data fitted well into the pseudo-second-order kinetic model, with a correlation coefficient greater than 0.993. The maximum monolayer biosorption capacity of pine bark for phenol, 2-CPh, and 4-CPh was found to be 142.85, 204.08, and 263.15 mg/g, respectively, as calculated by the Langmuir model at 30 ± 1 °C. Pine bark could be used as a new effective, low-cost biosorbent material with good uptake capacity and rapid kinetics for the removal of phenolic compounds from aqueous media

    Optimization of the Contrast Mixture Ratio for Simultaneous Direct MR and CT Arthrography: an in Vitro Study

    Get PDF
    OBJECTIVE: This study was designed to determine the optimal mixture ratio of gadolinium and iodinated contrast agent for simultaneous direct MR arthrography and CT arthrography. MATERIALS AND METHODS: An in vitro study was performed utilizing mixtures of gadolinium at six different concentrations (0.625, 1.25, 2.5, 5.0, 10 and 20 mmol/L) and iodinated contrast agent at seven different concentrations (0, 12.5, 25, 37.5, 50, 75 and 92-99.9%). These mixtures were placed in tissue culture plates, and were then imaged with CT and MR (with T1-weighted sequences, proton-density sequences and T2-weighted sequences). CT numbers and signal intensities were measured. Pearson's correlation coefficients were used to assess the correlations between the gadolinium/iodinated contrast agent mixtures and the CT numbers/MR signal intensities. Scatter diagrams were plotted for all gadolinium/iodinated contrast agent combinations and two radiologists in consensus identified the mixtures that yielded the optimal CT numbers and MR signal intensities. RESULTS: The CT numbers showed significant correlation with iodinated contrast concentrations (r = 0.976, p < 0.001), whereas the signal intensities as measured on MR images showed a significant correlation with both gadolinium and iodinated contrast agent concentrations (r = -484 to -0.719, p < 0.001). A review of the CT and MR images, graphs, and scatter diagram of 42 combinations of the contrast agent showed that a concentration of 1.25 mmol/L gadolinium and 25% iodinated contrast agent was the best combination for simultaneous CT and MR imaging. CONCLUSION: A mixture of 1.25 mmol/L gadolinium and 25% iodinated contrast agent was found to be optimal for simultaneous direct MR arthrography and CT arthrography

    Analgesic effect of highly reversible ω-conotoxin FVIA on N type Ca2+ channels

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>N-type Ca<sup>2+ </sup>channels (Ca<sub>v</sub>2.2) play an important role in the transmission of pain signals to the central nervous system. ω-Conotoxin (CTx)-MVIIA, also called ziconotide (Prialt<sup>®</sup>), effectively alleviates pain, without causing addiction, by blocking the pores of these channels. Unfortunately, CTx-MVIIA has a narrow therapeutic window and produces serious side effects due to the poor reversibility of its binding to the channel. It would thus be desirable to identify new analgesic blockers with binding characteristics that lead to fewer adverse side effects.</p> <p>Results</p> <p>Here we identify a new CTx, FVIA, from the Korean <it>Conus Fulmen </it>and describe its effects on pain responses and blood pressure. The inhibitory effect of CTx-FVIA on N-type Ca<sup>2+ </sup>channel currents was dose-dependent and similar to that of CTx-MVIIA. However, the two conopeptides exhibited markedly different degrees of reversibility after block. CTx-FVIA effectively and dose-dependently reduced nociceptive behavior in the formalin test and in neuropathic pain models, and reduced mechanical and thermal allodynia in the tail nerve injury rat model. CTx-FVIA (10 ng) also showed significant analgesic effects on writhing in mouse neurotransmitter- and cytokine-induced pain models, though it had no effect on acute thermal pain and interferon-γ induced pain. Interestingly, although both CTx-FVIA and CTx-MVIIA depressed arterial blood pressure immediately after administration, pressure recovered faster and to a greater degree after CTx-FVIA administration.</p> <p>Conclusions</p> <p>The analgesic potency of CTx-FVIA and its greater reversibility could represent advantages over CTx-MVIIA for the treatment of refractory pain and contribute to the design of an analgesic with high potency and low side effects.</p

    Transforaminal Epidural Steroid Injection for Lumbosacral Radiculopathy: Preganglionic versus Conventional Approach

    Get PDF
    OBJECTIVE: The present study was undertaken to evaluate the effectiveness of transforaminal epidural steroid injection (TFESI) with using a preganglionic approach for treating lumbar radiculopathy when the nerve root compression was located at the level of the supra-adjacent intervertebral disc. MATERIALS AND METHODS: The medical records of the patients who received conventional TFESI at our department from June 2003 to May 2004 were retrospectively reviewed. TFESI was performed in a total of 13 cases at the level of the exiting nerve root, in which the nerve root compression was at the level of the supra-adjacent intervertebral disc (the conventional TFESI group). Since June 2004, we have performed TFESI with using a preganglionic approach at the level of the supra-adjacent intervertebral disc (for example, at the neural foramen of L4-5 for the L5 nerve root) if the nerve root compression was at the level of the supra-adjacent intervertebral disc. Using the inclusion criteria described above, 20 of these patients were also consecutively enrolled in our study (the preganglionic TFESI group). The treatment outcome was assessed using a 5-point patient satisfaction scale and by using a VAS (visual assessment scale). A successful outcome required a patient satisfaction scale score of 3 (very good) or 4 (excellent), and a reduction on the VAS score of > 50% two weeks after performing TFESI. Logistic regression analysis was also performed. RESULTS: Of the 13 patients in the conventional TFESI group, nine showed satisfactory improvement two weeks after TFESI (69.2%). However, in the preganglionic TFESI group, 18 of the 20 patients (90%) showed satisfactory improvement. The difference between the two approaches in terms of TFESI effectiveness was of borderline significance (p = 0.056; odds ratio: 10.483). CONCLUSION: We conclude that preganglionic TFESI has the better therapeutic effect on radiculopathy caused by nerve root compression at the level of the supra-adjacent disc than does conventional TFESI, and the difference between the two treatments had borderline statistical significance

    Grading Anterior Cruciate Ligament Graft Injury after Ligament Reconstruction Surgery: Diagnostic Efficacy of Oblique Coronal MR Imaging of the Knee

    Get PDF
    OBJECTIVE: The purpose of this study was to evaluate the diagnostic efficacy of using additional oblique coronal MRI of the knee for grading anterior cruciate ligament (ACL) graft injury after ligament reconstruction surgery. MATERIALS AND METHODS: We retrospectively reviewed 51 consecutive MR knee examinations of 48 patients who underwent both ACL reconstruction and follow-up arthroscopy. The MR examinations included the orthogonal axial, sagittal, coronal images and the oblique coronal T2-weighted images, which were oriented in parallel with the course of the femoral intercondylar roof. Two radiologists independently evaluated the status of the ACL grafts with using the routine knee MRI and then with adding the oblique coronal imaging. The severity of ACL graft injury was graded using a 3-point system from MR images as intact, partial tear or complete tear, and the results were compared with the arthroscopic results. Weighted kappa statistics were used to analyze the diagnostic accuracies of the knee MRI with and without the additional oblique coronal imaging. For each evaluation, the observers reported a confidence level for grading the ACL graft injuries in the two imaging groups. RESULTS: The weighted kappa values according to the routine knee MRI were 0.555 (reader 1) and 0.515 (reader 2). The inclusion of additional oblique coronal imaging increased the weighted kappa values to 0.666 (reader 1) and 0.611 (reader 2). The mean confidence levels by each reader were significantly higher (p < 0.01, paired t-test) with the additional oblique coronal imaging than by using the routine knee MRI alone. CONCLUSION: The additional use of oblique coronal MRI of the knee improves both the diagnostic accuracy and confidence for grading ACL graft injury

    Biosorption of Phenolic Compounds from Aqueous Solutions using Pine (Pinus densiflora Sieb) Bark Powder

    No full text
    The present study describes the development of a new bioadsorbent from lignocellulosic wastes of agricultural origin. The biosorption capacity of an agricultural solid waste, pine bark (Pinus densiflora Sieb.), to remove phenolic compounds (phenol, 2-chlorophenol (2-CPh), and 4- chlorophenol (4-CPh)) from aqueous solutions under batch equilibrium conditions was investigated. The morphological characteristics of the biosorbent were evaluated by BET surface area analysis, Fourier transform infrared spectroscopy (FTIR), elemental analysis, an X-ray diffractometer (XRD), and a scanning electron microscope (SEM). Batch experiments were conducted to investigate the effect of initial pH (2 to 10), contact time, initial concentration of adsorbate (50 to 200 mg/L), and biosorbent dosage. The biosorption of phenolic compounds decreased with increasing pH, and the highest biosorption capacity was achieved at a pH of 6.0. Biosorption equilibrium was established in 120 min. The biosorption equilibrium data were fitted and analyzed with Langmuir, Freundlich, and Dubinin-Radushkevich isotherm equations, as well as four adsorption kinetic models. The kinetics data fitted well into the pseudo-second-order kinetic model, with a correlation coefficient greater than 0.993. The maximum monolayer biosorption capacity of pine bark for phenol, 2-CPh, and 4-CPh was found to be 142.85, 204.08, and 263.15 mg/g, respectively, as calculated by the Langmuir model at 30 ± 1 °C. Pine bark could be used as a new effective, low-cost biosorbent material with good uptake capacity and rapid kinetics for the removal of phenolic compounds from aqueous media
    corecore