3,094 research outputs found
Reconfigurable mobile communications: compelling needs and technologies to support reconfigurable terminals
The effects of sower and bed density on bareroot loblolly pine seedling morphology and early height growth
Precision sowing is commonly used at forest tree nurseries in order to improve the growing space uniformity of seedlings in the beds. Temple-Inland Forest Products Corporation recently purchased a vacuum sower and requested a study be conducted comparing their new sower with a drill sower on the morphological characteristics of loblolly pine (Pinus taeda L.) at lifting. The study was conducted in 2000 and repeated in 2001. The seed were sown using the two sower types to achieve four densities of 161, 215, 269, and 323 seedlings/m2. Two half-sibling families were tested in 2000, and one halfsibling family was tested in 2001. For both studies, the experimental design was a randomized complete block with four replications. Cultural practices used to grow the seedlings were typical for the nursery. The seedlings were hand-lifted mid-winter for measurements of stem height, root-collar diameter, and oven-dry biomass. For the 2001 study, seedlings were handplanted 1 week after lifting in a clearcut near Etoile, TX. The mean morphology of the seedlings was similar when comparing the two sowers. hen averaged for all densities, more seedlings with small root-collar diameters (≤ 3 mm) were sampled in the 2000 study from the drill sower plots than from the vacuum sower plots. For the 2001 study, slightly more seedlings with small diameters were sampled from the vacuum sower plots. At typical operational densities of 215 and 269 seedlings/m2, the use of the vacuum sower resulted in more seedlings at lifting, fewer small-diameter seedlings, and more large-diameter seedlings (≥ 5 mm). As seedbed density was reduced, mean seedling root-collar diameter and oven-dry biomass increased. Seedlings grown in the nursery at 161 seedlings/m2 were taller after the first and second growing season following planting
Inconsistency of threat level in soft armour standards, correlation of experimental tests to bullet X-ray 3D images
Fundamental to any ballistic armour standard is the reference projectile that is to be defeated. Typically, for certification, consistency of bullet geometry is assumed. Therefore, practical variations in bullet jacket dimensions can have far reaching consequences. Traditionally, internal dimensions have been analysed by physically sectioning bullets – an approach which rules out any subsequent ballistic assessment. The use of a non-destructive X-ray Computed Tomography (CT) method was demonstrated in [1]. Now, the authors apply this technique to correlate bullet impact response to jacket thickness variations. A set of 20 bullets (9 mm DM 11) was selected to analyse both intra and inter bullet variations using an image based analysis method to map the jacket thickness and measure the centre of gravity. Thickness variations of the order of 200μm were found commonly across all the bullets along the length and an angular variation of up to 50μm was found in a few bullets. The bullets were subsequently impacted against a rigid flat plate and re-scanned. The results of the experiments are shown and compared to the un-deformed bullet jacket thickness variations. The conclusions are relevant for future soft armour standards and provide important data for numerical model correlation and development
Linear models for control of cavity flow oscillations
Models for understanding and controlling oscillations in the flow past a rectangular cavity are developed. These models may be used to guide control designs, to understand performance limits of feedback, and to interpret experimental results. Traditionally, cavity oscillations are assumed to be self-sustained: no external disturbances are necessary to maintain the oscillations, and amplitudes are limited by nonlinearities. We present experimental data which suggests that in some regimes, the oscillations may not be self-sustained, but lightly damped: oscillations are sustained by external forcing, such as boundary-layer turbulence. In these regimes, linear models suffice to describe the behaviour, and the final amplitude of oscillations depends on the characteristics of the external disturbances. These linear models are particularly appropriate for describing cavities in which feedback has been used for noise suppression, as the oscillations are small and nonlinearities are less likely to be important. It is shown that increasing the gain too much in such feedback control experiments can lead to a peak-splitting phenomenon, which is explained by the linear models. Fundamental performance limits indicate that peak splitting is likely to occur for narrow-bandwidth actuators and controllers
Pediatric Psychologists’ Career Satisfaction: 2015 Society of Pediatric Psychology Workforce Survey Results.
Little is known about the career satisfaction of pediatric psychologists, who specialize in psychological research, teaching, and clinical service in the context of pediatric health care. As part of the larger Society of Pediatric Psychology Workforce Survey and in collaboration with the American Psychological Association Center for Workforce Studies, this study aimed to (1) describe the career domains which pediatric psychologists perceive to be important and their satisfaction in each domain, and (2) compare satisfaction of pediatric psychologists across work settings, number of positions, appointment duration, professional roles, career stage, academic rank, and gender. Responses from 336 pediatric psychologists demonstrated high career satisfaction. Domains of career satisfaction that received mean scores indicating high importance include balance of work and personal lives, peer/collegial support, and flexibility and choice in the workplace, but on average respondents reported being only somewhat satisfied in these domains. Total satisfaction scores were significantly higher among pediatric psychologists in 9–10-month appointments, primarily research careers, and at higher academic ranks, but scores were similar across employment settings and genders. To enhance career satisfaction and retention, pediatric psychologists may seek additional mentorship or explore new employment roles, and administrators and managers may consider adopting workplace policies or making environmental changes that could address specific areas of need
Isolation of Unknown Genes from Human Bone Marrow by Differental Screening and Single-Pass cDNA Sequences Determination
A cDNA sequencing project was initiated to characterize gene expression in human bone marrow and develop strategies to isolate novel genes. Forty-eight random cDNAs from total human bone marrow were subjected to single-pass DNA sequence analysis to determine a limited complexity of mRNAs expressed in the bone marrow. Overall, 8 cDNAs (17%) showed no similarity to known sequences. Information from DNA sequence analysis was used to develop a differential prescreen to subtract unwanted cDNAs and to enrich for unknown cDNAs. Forty-eight cDNAs that were negative with a complex probe were subject to single-pass DNA sequence determination. Of these prescreened cDNAs, the number of unknown sequences increased to 23 (48%). Unknown cDNAs were also characterized by RNA expression analysis using 25 different human leukemic cell lines. Of 13 unknown cDNAs tested, 10 were expressed in all cell types tested and 3 revealed a hematopoietic lineage-restricted expression pattern. Interestingly, while a total of only 96 bone marrow cDNAs were sequenced, 31 of these cDNAs represent sequences from unknown genes and 12 showed significant similarities to sequences in the data bases. One cDNA revealed a significant similarity to a serine/threonine-protein kinase at the amino acid level (56% identity for 123 amino acids) and may represent a previously unknown kinase. Differential screening techniques coupled with single-pass cDNA sequence analysis may prove to be a powerful and simple technique to examine developmental gene expression
Distinguishing micro-businesses from SMEs: a systematic review of growth constraints
Purpose – Micro-businesses account for a large majority of Small and Medium Enterprises (SMEs). However, they remain comparatively under-researched. This paper seeks to take stock of the extant literature on growth challenges, and to distinguish the growth constraints facing micro-business as a specific subset of SMEs from those facing larger SMEs. Design/methodology/approach – The study consists of a systematic review of 59 peer-reviewed articles on SME growth. Findings – Micro-businesses distinguish themselves from larger SMEs by being owner-manager entrepreneur (OME) centric and are constrained by a tendency to be growth-averse, underdeveloped capabilities in key business areas, underdeveloped OME capabilities, and often inadequate business support provision. Research limitations/implications – The use of keywords, search strings, and specific databases may have limited the number of papers identified as relevant by the review. However, the findings are valuable for understanding micro-businesses as a subset of SMEs, providing directions for future research and generating implications for policy to support the scaling up of micro-businesses. Originality/value – The review provides a renewed foundation for academic analysis of micro-business growth, highlighting how micro-businesses are distinct from larger SMEs. At present, no systematic literature review on this topic has previously been published and the study develops a number of theoretical and policy implications
A Solidarity Machine? Hong Kong Labour NGOs in Guangdong
Although the literature on labour NGOs (LNGOs) in China has significantly expanded, few scholars have attempted to subject the work of these organizations to a Marxist perspective. This article draws on a recently developed Marxian theoretical framework on social movements to analyse the pioneering work of Hong Kong LNGOs and their partners in the province of Guangdong, China. Over the past 15 years, the Hong Kong groups, as they are known collectively, have been ideally placed to develop specific interventions in response to migrant workers’ pursuance of wage claims and improved working conditions during a time of increased rights awareness and widespread labour shortages. While consistently careful to remain the right side of China’s restrictive laws on freedom of association and demonstrations, the Hong Kong LNGOs were able to contribute to a narrative of class-based collective solidarity that has yielded significant gains for workers
A common and unstable copy number variant is associated with differences in Glo1 expression and anxiety-like behavior
Glyoxalase 1 (Glo1) has been implicated in anxiety-like behavior in mice and in multiple psychiatric diseases in humans. We used mouse Affymetrix exon arrays to detect copy number variants (CNV) among inbred mouse strains and thereby identified a approximately 475 kb tandem duplication on chromosome 17 that includes Glo1 (30,174,390-30,651,226 Mb; mouse genome build 36). We developed a PCR-based strategy and used it to detect this duplication in 23 of 71 inbred strains tested, and in various outbred and wild-caught mice. Presence of the duplication is associated with a cis-acting expression QTL for Glo1 (LOD>30) in BXD recombinant inbred strains. However, evidence for an eQTL for Glo1 was not obtained when we analyzed single SNPs or 3-SNP haplotypes in a panel of 27 inbred strains. We conclude that association analysis in the inbred strain panel failed to detect an eQTL because the duplication was present on multiple highly divergent haplotypes. Furthermore, we suggest that non-allelic homologous recombination has led to multiple reversions to the non-duplicated state among inbred strains. We show associations between multiple duplication-containing haplotypes, Glo1 expression and anxiety-like behavior in both inbred strain panels and outbred CD-1 mice. Our findings provide a molecular basis for differential expression of Glo1 and further implicate Glo1 in anxiety-like behavior. More broadly, these results identify problems with commonly employed tests for association in inbred strains when CNVs are present. Finally, these data provide an example of biologically significant phenotypic variability in model organisms that can be attributed to CNVs.These studies were funded by MH070933, MH79103 and MH020065
- …