63,497 research outputs found
The linear polarization of lunar thermal emission at 3.1 mm wavelength
Several observations of the distribution of linearly polarized lunar thermal emission were made at a wavelength of 3.1 mm with 4.88 m parabolic reflector from February to March 1971. A shadow corrected rough surface thermal emission model was least squares fitted to the data. Results indicate an effective lunar dielectric constant of 1.34 + or -.08 with surface roughness characterized by a standard deviation of surface slopes of 18 deg + or - 2 deg. A comparison of these results with previously published values at other wavelengths suggests that the effective lunar dielectric constant decreases with decreasing wavelength
A Renormalization Group Method for Quasi One-dimensional Quantum Hamiltonians
A density-matrix renormalization group (DMRG) method for highly anisotropic
two-dimensional systems is presented. The method consists in applying the usual
DMRG in two steps. In the first step, a pure one dimensional calculation along
the longitudinal direction is made in order to generate a low energy
Hamiltonian. In the second step, the anisotropic 2D lattice is obtained by
coupling in the transverse direction the 1D Hamiltonians. The method is applied
to the anisotropic quantum spin half Heisenberg model on a square lattice.Comment: 4 pages, 4 figure
Ground State Properties of the Doped 3-Leg t-J Ladder
Results for a doped 3-leg t-J ladder obtained using the density matrix
renormalization group are reported. At low hole doping, the holes form a dilute
gas with a uniform density. The momentum occupation of the odd band shows a
sharp decrease at a large value of k_F similar to the behavior of a lightly
doped t-J chain, while the even modes appear gapped. The spin-spin correlations
decay as a power law consistent with the absence of a spin gap, but the pair
field correlations are negligible. At larger doping we find evidence for a spin
gap and as x increases further we find 3-hole diagonal domain walls. In this
regime there are pair field correlations and the internal pair orbital has
d_x^2-y^2 - like symmetry. However, the pair field correlations appear to fall
exponentially at large distances.Comment: 14 pages, 11 postscript figure
Preliminary measurements of aircraft airframe noise with the NASA CV-990 aircraft
Flight tests were conducted in a CV-990 jet transport with engines at idle power to investigate aircraft airframe noise. Test results showed that airframe noise was measured for the aircraft in the landing configuration. The results agreed well with the expected variation with the fifth power of velocity. For the aircraft in the clean configuraton, it was concluded that airframe noise was measured only at higher airspeeds with engine idle noise present at lower speeds. The data show that landing gear and flaps make a significant contribution to airframe noise
Nanoscale Molecular Dynamics Simulaton of Shock Compression of Silicon
We report results of molecular dynamics simulation of shock wave propagation
in silicon in [100], [110], and [111] directions obtained using a classical
environment-dependent interatomic potential (EDIP). Several regimes of
materials response are classified as a function of shock wave intensity using
the calculated shock Hugoniot. Shock wave structure in [100] and [111]
directions exhibit usual evolution as a function of piston velocity. At piston
velocities km/s the shock wave consists of a fast elastic precursor followed by
a slower plastic front. At larger piston velocities the single overdriven
plastic wave propagates through the crystal causing amorphitization of Si.
However, the [110] shock wave exhibits an anomalous materials response at
intermediate piston velocities around km/s which is characterized by the
absence of plastic deformations
Impact of external sources of infection on the dynamics of bovine tuberculosis in modelled badger populations
Background The persistence of bovine TB (bTB) in various countries throughout the world is enhanced by the existence of wildlife hosts for the infection. In Britain and Ireland, the principal wildlife host for bTB is the badger (Meles meles). The objective of our study was to examine the dynamics of bTB in badgers in relation to both badger-derived infection from within the population and externally-derived, trickle-type, infection, such as could occur from other species or environmental sources, using a spatial stochastic simulation model. Results The presence of external sources of infection can increase mean prevalence and reduce the threshold group size for disease persistence. Above the threshold equilibrium group size of 6–8 individuals predicted by the model for bTB persistence in badgers based on internal infection alone, external sources of infection have relatively little impact on the persistence or level of disease. However, within a critical range of group sizes just below this threshold level, external infection becomes much more important in determining disease dynamics. Within this critical range, external infection increases the ratio of intra- to inter-group infections due to the greater probability of external infections entering fully-susceptible groups. The effect is to enable bTB persistence and increase bTB prevalence in badger populations which would not be able to maintain bTB based on internal infection alone. Conclusions External sources of bTB infection can contribute to the persistence of bTB in badger populations. In high-density badger populations, internal badger-derived infections occur at a sufficient rate that the additional effect of external sources in exacerbating disease is minimal. However, in lower-density populations, external sources of infection are much more important in enhancing bTB prevalence and persistence. In such circumstances, it is particularly important that control strategies to reduce bTB in badgers include efforts to minimise such external sources of infection
The effect of Mach number on unstable disturbances in shock/boundary-layer interactions
The effect of Mach number on the growth of unstable disturbances in a boundary layer undergoing a strong interaction with an impinging oblique shock wave is studied by direct numerical simulation and linear stability theory (LST). To reduce the number of independent parameters, test cases are arranged so that both the interaction location Reynolds number (based on the distance from the plate leading edge to the shock impingement location for a corresponding inviscid flow) and the separation bubble length Reynolds number are held fixed. Small-amplitude disturbances are introduced via both white-noise and harmonic forcing and, after verification that the disturbances are convective in nature, linear growth rates are extracted from the simulations for comparison with parallel flow LST and solutions of the parabolized stability equations (PSE). At Mach 2.0, the oblique modes are dominant and consistent results are obtained from simulation and theory. At Mach 4.5 and Mach 6.85, the linear Navier-Stokes results show large reductions in disturbance energy at the point where the shock impinges on the top of the separated shear layer. The most unstable second mode has only weak growth over the bubble region, which instead shows significant growth of streamwise structures. The two higher Mach number cases are not well predicted by parallel flow LST, which gives frequencies and spanwise wave numbers that are significantly different from the simulations. The PSE approach leads to good qualitative predictions of the dominant frequency and wavenumber at Mach 2.0 and 4.5, but suffers from reduced accuracy in the region immediately after the shock impingement. Three-dimensional Navier-Stokes simulations are used to demonstrate that at finite amplitudes the flow structures undergo a nonlinear breakdown to turbulence. This breakdown is enhanced when the oblique-mode disturbances are supplemented with unstable Mack modes
Spinon-holon interactions in an anisotropic t-J chain: a comprehensive study
We consider a generalization of the one-dimensional t-J model with
anisotropic spin-spin interactions. We show that the anisotropy leads to an
effective attractive interaction between the spinon and holon excitations,
resulting in a localized bound state. Detailed quantitative analytic
predictions for the dependence of the binding energy on the anisotropy are
presented, and verified by precise numerical simulations. The binding energy is
found to interpolate smoothly between a finite value in the t-Jz limit and zero
in the isotropic limit, going to zero exponentially in the vicinity of the
latter. We identify changes in spinon dispersion as the primary factor for this
non-trivial behavior.Comment: 12 pages, 13 figures, long story. The short story is
cond-mat/0702213. Published versio
- …