Thermal stress cycling of GaAs solar cells

A thermal cycling experiment was performed on GaAs solar cells to establish the electrical and structural integrity of these cells under the temperature conditions of a simulated low-Earth orbit of 3-year duration. Thirty single junction GaAs cells were obtained and tests were performed to establish the beginning-of-life characteristics of these cells. The tests consisted of cell I-V power output curves, from which were obtained short-circuit current, open circuit voltage, fill factor, and cell efficiency, and optical micrographs, spectral response, and ion microprobe mass analysis (IMMA) depth profiles on both the front surfaces and the front metallic contacts of the cells. Following 5,000 thermal cycles, the performance of the cells was reexamined in addition to any factors which might contribute to performance degradation. It is established that, after 5,000 thermal cycles, the cells retain their power output with no loss of structural integrity or change in physical appearance

High Resolution BPM Upgrade for the ATF Damping Ring at KEK

A beam position monitor (BPM) upgrade at the KEK Accelerator Test Facility (ATF) damping ring has been accomplished, carried out by a KEK/FNAL/SLAC collaboration under the umbrella of the global ILC R&D effort. The upgrade consists of a high resolution, high reproducibility read-out system, based on analog and processing, and also implements a new automatic gain error correction schema. The technical concept and realization as well as results of beam studies are presented.Comment: 3 pp. 10th European Workshop on Beam Diagnostics and Instrumentation for Particle Accelerators DIPAC 2011, 16-18 May 2011. Hamburg, German

Preliminary calibration of a generic scramjet combustor

The results of a preliminary investigation of the combustion of hydrogen fuel at hypersonic flow conditions are provided. The tests were performed in a generic, constant-area combustor model with test gas supplied by a free-piston-driven reflected-shock tunnel. Static pressure measurements along the combustor wall indicated that burning did occur for combustor inlet conditions of P(static) approximately equal to 19kPa, T(static) approximately equal to 1080 K, and U approximately equal to 3630 m/s with a fuel equivalence ratio approximately equal to 0.9. These inlet conditions were obtained by operating the tunnel with stagnation enthalpy approximately equal to 8.1 MJ/kg, stagnation pressure approximately equal to 52 MPa, and a contoured nozzle with a nominal exit Mach number of 5.5

Shock tunnel studies of scramjet phenomena, supplement 5

A series of reports are presented on SCRAMjet studies, shock tunnel studies, and expansion tube studies. The SCRAMjet studies include: (1) Investigation of a Supersonic Combustion Layer; (2) Wall Injected SCRAMjet Experiments; (3) Supersonic Combustion with Transvers, Circular, Wall Jets; (4) Dissociated Test Gas Effects on SCRAMjet Combustors; (5) Use of Silane as a Fuel Additive for Hypersonic Thrust Production, (6) Pressure-length Correlations in Supersonic Combustion; (7) Hot Hydrogen Injection Technique for Shock Tunnels; (8) Heat Release - Wave Interaction Phenomena in Hypersonic Flows; (9) A Study of the Wave Drag in Hypersonic SCRAMjets; (10) Parametric Study of Thrust Production in the Two Dimensional SCRAMjet; (11) The Design of a Mass Spectrometer for use in Hypersonic Impulse Facilities; and (12) Development of a Skin Friction Gauge for use in an Impulse Facility. The shock tunnel studies include: (1) Hypervelocity flow in Axisymmetric Nozzles; (2) Shock Tunnel Development; and (3) Real Gas Efects in Hypervelocity Flows over an Inclined Cone. The expansion tube studies include: (1) Investigation of Flow Characteristics in TQ Expansion Tube; and (2) Disturbances in the Driver Gas of a Shock Tube

Discrepancy between experimental and theoretical β\beta-decay rates resolved from first principles

$\beta$-decay, a process that changes a neutron into a proton (and vice versa), is the dominant decay mode of atomic nuclei. This decay offers a unique window to physics beyond the standard model, and is at the heart of microphysical processes in stellar explosions and the synthesis of the elements in the Universe. For 50 years, a central puzzle has been that observed $\beta$-decay rates are systematically smaller than theoretical predictions. This was attributed to an apparent quenching of the fundamental coupling constant $g_A \simeq$ 1.27 in the nucleus by a factor of about 0.75 compared to the $\beta$-decay of a free neutron. The origin of this quenching is controversial and has so far eluded a first-principles theoretical understanding. Here we address this puzzle and show that this quenching arises to a large extent from the coupling of the weak force to two nucleons as well as from strong correlations in the nucleus. We present state-of-the-art computations of $\beta$-decays from light to heavy nuclei. Our results are consistent with experimental data, including the pioneering measurement for $^{100}$Sn. These theoretical advances are enabled by systematic effective field theories of the strong and weak interactions combined with powerful quantum many-body techniques. This work paves the way for systematic theoretical predictions for fundamental physics problems. These include the synthesis of heavy elements in neutron star mergers and the search for neutrino-less double-$\beta$-decay, where an analogous quenching puzzle is a major source of uncertainty in extracting the neutrino mass scale.Comment: 20 pages, 18 figure

Giant microwave photoresistance of two-dimensional electron gas

We measure microwave frequency (4-40 GHz) photoresistance at low magnetic field B, in high mobility 2D electron gas samples, excited by signals applied to a transmission line fabricated on the sample surface. Oscillatory photoresistance vs B is observed. For excitation at the cyclotron resonance frequency, we find an unprecedented, giant relative photoresistance (\Delta R)/R of up to 250 percent. The photoresistance is apparently proportional to the square root of applied power, and disappears as the temperature is increased.Comment: 4 pages, 3 figure

The UVES Large Program for testing fundamental physics - III. Constraints on the fine-structure constant from 3 telescopes

Large statistical samples of quasar spectra have previously indicated possible cosmological variations in the fine-structure constant, $\alpha$. A smaller sample of higher signal-to-noise ratio spectra, with dedicated calibration, would allow a detailed test of this evidence. Towards that end, we observed equatorial quasar HS 1549$+$1919 with three telescopes: the Very Large Telescope, Keck and, for the first time in such analyses, Subaru. By directly comparing these spectra to each other, and by `supercalibrating' them using asteroid and iodine-cell tests, we detected and removed long-range distortions of the quasar spectra's wavelength scales which would have caused significant systematic errors in our $\alpha$ measurements. For each telescope we measure the relative deviation in $\alpha$ from the current laboratory value, $\Delta\alpha/\alpha$, in 3 absorption systems at redshifts $z_{\mathrm{abs}}=1.143$, 1.342, and 1.802. The nine measurements of $\Delta\alpha/\alpha$ are all consistent with zero at the 2-$\sigma$ level, with 1-$\sigma$ statistical (systematic) uncertainties 5.6--24 (1.8--7.0) parts per million (ppm). They are also consistent with each other at the 1-$\sigma$ level, allowing us to form a combined value for each telescope and, finally, a single value for this line of sight: $\Delta\alpha/\alpha=-5.4 \pm 3.3_{\mathrm{stat}} \pm 1.5_{\mathrm{sys}}$ ppm, consistent with both zero and previous, large samples. We also average all Large Programme results measuring $\Delta\alpha/\alpha=-0.6 \pm 1.9_{\mathrm{stat}} \pm 0.9_{\mathrm{sys}}$ ppm. Our results demonstrate the robustness and reliability at the 3 ppm level afforded by supercalibration techniques and direct comparison of spectra from different telescopes.Comment: 24 pages, 11 figures, 9 table

An HST/COS legacy survey of high-velocity ultraviolet absorption in the Milky Way's circumgalactic medium and the Local Group

To characterize the absorption properties of this circumgalactic medium (CGM) and its relation to the LG we present the so-far largest survey of metal absorption in Galactic high-velocity clouds (HVCs) using archival ultraviolet (UV) spectra of extragalactic background sources. The UV data are obtained with the Cosmic Origins Spectrograph (COS) onboard the Hubble Space Telescope (HST) and are supplemented by 21 cm radio observations of neutral hydrogen. Along 270 sightlines we measure metal absorption in the lines of SiII, SiIII, CII, and CIV and associated HI 21 cm emission in HVCs in the velocity range |v_LSR|=100-500 km s^-1. With this unprecedented large HVC sample we were able to improve the statistics on HVC covering fractions, ionization conditions, small-scale structure, CGM mass, and inflow rate. For the first time, we determine robustly the angular two point correlation function of the high-velocity absorbers, systematically analyze antipodal sightlines on the celestial sphere, and compare the absorption characteristics with that of Damped Lyman alpha absorbers (DLAs) and constrained cosmological simulations of the LG. Our study demonstrates that the Milky Way CGM contains sufficient gaseous material to maintain the Galactic star-formation rate at its current level. We show that the CGM is composed of discrete gaseous structures that exhibit a large-scale kinematics together with small-scale variations in physical conditions. The Magellanic Stream clearly dominates both the cross section and mass flow of high-velocity gas in the Milky Way's CGM. The possible presence of high-velocity LG gas underlines the important role of the local cosmological environment in the large-scale gas-circulation processes in and around the Milky Way (abridged).Comment: 37 pages, 25 figures, 8 tables, accepted for publication in A&

Double quantum dot with tunable coupling in an enhancement-mode silicon metal-oxide semiconductor device with lateral geometry

We present transport measurements of a tunable silicon metal-oxide-semiconductor double quantum dot device with lateral geometry. Experimentally extracted gate-to-dot capacitances show that the device is largely symmetric under the gate voltages applied. Intriguingly, these gate voltages themselves are not symmetric. Comparison with numerical simulations indicates that the applied gate voltages serve to offset an intrinsic asymmetry in the physical device. We also show a transition from a large single dot to two well isolated coupled dots, where the central gate of the device is used to controllably tune the interdot coupling.Comment: 4 pages, 3 figures, to be published in Applied Physics Letter