Reservoir scale reactive-transport modeling of a buoyancy-controlled CO2 plume with impurities (SO2, NO2, O2)

A demonstration project for the geological storage of CO2 is currently being considered in the deep Precipice Sandstone formation of the Surat Basin, Queensland, Australia. Because of the presence of potential fresh water resources in this formation, a reservoir-scale two-dimensional reactive-transport model was developed to assess temporal and spatial changes in water quality imposed by co-injecting CO2 with SO2, NO2, and O2 at this location. The model shows that because the injection rate is relatively low (60,000 tons/year), flow is buoyancy-dominated and under these conditions the predicted CO2 flow pattern is quite sensitive to fine-scale heterogeneities and the resolution of the numerical mesh. The model also shows that SO2 and NO2 readily partition into the aqueous phase in close vicinity of their injection point, lowering pH somewhat beyond the acidification from CO2 dissolution. Only O2 under redox disequilibrium conditions is modeled to persist in the CO2 plume away from the injection point, however at sub-ppm levels. This modeling effort demonstrates acidification near the wellbore due to the preferential stripping of gas impurities, and accumulation of CO2 around a lithostratigraphic boundary above the target formation, where relatively rapid mineral dissolution (muscovite, chlorite and calcite) and precipitation (ankerite, kaolinite and chalcedony) occur

Synergistic effect of dual flocculation between inorganic salts and chitosan on harvesting microalgae Chlorella vulgaris

© 2020 Elsevier B.V. The flocculation efficiency of microalgae Chlorella vulgaris for subsequent harvesting was investigated using single flocculants of inorganic salts, synthetic polymer, chitosan and dual flocculants of inorganic salts and chitosan. Synthetic polymer (FlopamTM) could achieve over 90% optical density removal (OD680removal) at a low flocculant dose (20 to 40 mg polymer per litre of algal suspension) through the bridging mechanism and charge neutralisation. Inorganic salts (i.e. ferric chloride and aluminium sulphate) and chitosan individually resulted in low flocculation efficiency (80% flocculation efficiency, significantly higher than the sum of each individual flocculation. The improvement in flocculation efficiency was 57 and 24% respectively for ferric chloride/chitosan and aluminium sulphate/chitosan. Charge neutralisation of microalgal cells by ferric chloride or aluminium sulphate combined with bridging by chitosan produced the synergy

Joint exploration model based light field image coding: A comparative study

© 2017 IEEE. The recent light field imaging technology has been attracting a lot of interests due to its potential applications in a large number of areas including Virtual Reality, Augmented Reality (VR/AR), Teleconferencing, and E-learning. Light Field (LF) data is able to provide rich visual information such as scene rendering with changes in depth of field, viewpoint, and focal length. However, Light Field data usually associates to a critical problem - the massive data. Therefore, compressing LF data is one of the main challenges in LF research. In this context, we present in this paper a comparative study for compressing LF data with not only the widely used image/video coding standards, such as JPEG-2000, H.264/AVC, HEVC and Google/VP9 but also with the most recent image/video coding solution, the Joint Exploration Model. In addition, this paper also proposes a LF image coding flow, which can be used as a benchmark for future LF compression evaluation. Finally, the compression efficiency of these coding solutions is thoroughly compared throughout a rich set of test conditions

Factors governing microalgae harvesting efficiency by flocculation using cationic polymers.

This study aims to elucidate the mechanisms governing the harvesting efficiency of Chlorella vulgaris by flocculation using a cationic polymer. Flocculation efficiency increased as microalgae culture matured (i.e. 35-45, 75, and > 97% efficiency at early, late exponential, and stationary phase, respectively. Unlike the negative impact of phosphate on flocculation in traditional wastewater treatment; here, phosphorous residue did not influence the flocculation efficiency of C. vulgaris. The observed dependency of flocculation efficiency on growth phase was driven by changes in microalgal cell properties. Microalgal extracellular polymeric substances (EPS) in both bound and free forms at stationary phase were two and three times higher than those at late and early exponential phase, respectively. Microalgae cells also became more negatively charged as they matured. Negatively charged and high EPS content together with the addition of high molecular weight and positively charged polymer could facilitate effective flocculation via charge neutralisation and bridging

Experimental and simulation results of the adsorption of Mo and V onto ferrihydrite.

This study aims to highlight discrepancies between experimental and simulation linked to the mechanisms of Mo and V adsorption onto ferrihydrite (FHY) nanoparticles. We have measured adsorption capacities and uptake efficiencies and then fitted and compared these with outputs from various geochemical and adsorption models that were run as a function of pH, surface area (SA) and ferrihydrite particles size distributions. Our results revealed that the experimental data for the Mo system could be fitted very well, but this was not the case for the V system, when a model default value for the SA of FHY of 600 m2 g-1 was used. The discrepancy in the results for the V system can be explained by the lack of specific V species and/or associated constants in databases and variation in software versions, which change the outputted chemical species. Our comparative results also confirm that any experimental variables used as modelling inputs need to be checked carefully prior to any modelling exercises

Microalgae-based carbon capture and utilization: A critical review on current system developments and biomass utilization

Carbon capture and utilization (CCU) is an emerging technology with commercial potential to convert atmospheric carbon dioxide (CO2) into net zero or negative emission products. In microalgae-based CCU, microalgae utilize CO2 and sunlight to generate biomass for commercial applications. This paper reviews the current state of microalgal culture development for CCU and highlights its potential contribution to addressing climate change challenges. Current microalgal culture systems have not been designed for high throughput biomass growth and carbon capture. Raceways, high-rate algal ponds, and photobioreactors are the most widely used for microalgal cultivation at a large-scale. The limitations of these systems are related to microalgal growth requirements. Ponds are operated at narrow depth to ensure sufficient light distribution and thus need a large land surface. CO2 gas needs to be in a dissolved form for efficient utilization by microalgae. Innovative system designs to achieve optimized distribution of light, nutrient, and CO2 utilization for enhanced biomass production are crucial to achieve large-scale CO2 capture by microalgae. Data corroborated in this review highlights several innovative techniques to deliver CO2 effectively and enhance light illumination to microalgal cells. Submerged and internal illuminations can enhance light distribution without compromising culture volume and land requirements. CO2 delivery technique selections mainly depend on CO2 sources. The carbonation column appears to be the best option regarding efficiency, easy operation, and simple design. The downstream processes of microalgal culture (i.e. harvesting, biomass utilization, and water reuse) are important to make microalgae-based CCU a significant contribution to global carbon mitigation solutions

The deep-subsurface sulfate reducer Desulfotomaculum kuznetsovii employs two methanol-degrading pathways

Methanol is generally metabolized through a pathway initiated by a cobalamine-containing methanol methyltransferase by anaerobic methylotrophs (such as methanogens and acetogens), or through oxidation to formaldehyde using a methanol dehydrogenase by aerobes. Methanol is an important substrate in deep-subsurface environments, where thermophilic sulfate-reducing bacteria of the genus Desulfotomaculum have key roles. Here, we study the methanol metabolism of Desulfotomaculum kuznetsovii strain 17T, isolated from a 3000-m deep geothermal water reservoir. We use proteomics to analyze cells grown with methanol and sulfate in the presence and absence of cobalt and vitamin B12. The results indicate the presence of two methanol-degrading pathways in D. kuznetsovii, a cobalt-dependent methanol methyltransferase and a cobalt-independent methanol dehydrogenase, which is further confirmed by stable isotope fractionation. This is the first report of a microorganism utilizing two distinct methanol conversion pathways. We hypothesize that this gives D. kuznetsovii a competitive advantage in its natural environment.Research was funded by grants of the Division of Chemical Sciences (CW-TOP 700.55.343) and Earth and Life Sciences (ALW 819.02.014) of The Netherlands Organisation for Scientific Research (NWO), the European Research Council (ERC grant 323009), and the Gravitation grant (024.002.002) of the Netherlands Ministry of Education, Culture and Scienceinfo:eu-repo/semantics/publishedVersio

Genome-Wide Association Study of Plasma Polyunsaturated Fatty Acids in the InCHIANTI Study

Polyunsaturated fatty acids (PUFA) have a role in many physiological processes, including energy production, modulation of inflammation, and maintenance of cell membrane integrity. High plasma PUFA concentrations have been shown to have beneficial effects on cardiovascular disease and mortality. To identify genetic contributors of plasma PUFA concentrations, we conducted a genome-wide association study of plasma levels of six omega-3 and omega-6 fatty acids in 1,075 participants in the InCHIANTI study on aging. The strongest evidence for association was observed in a region of chromosome 11 that encodes three fatty acid desaturases (FADS1, FADS2, FADS3). The SNP with the most significant association was rs174537 near FADS1 in the analysis of arachidonic acid (AA; p = 5.95×10−46). Minor allele homozygotes had lower AA compared to the major allele homozygotes and rs174537 accounted for 18.6% of the additive variance in AA concentrations. This SNP was also associated with levels of eicosadienoic acid (EDA; p = 6.78×10−9) and eicosapentanoic acid (EPA; p = 1.07×10−14). Participants carrying the allele associated with higher AA, EDA, and EPA also had higher low-density lipoprotein (LDL-C) and total cholesterol levels. Outside the FADS gene cluster, the strongest region of association mapped to chromosome 6 in the region encoding an elongase of very long fatty acids 2 (ELOVL2). In this region, association was observed with EPA (rs953413; p = 1.1×10−6). The effects of rs174537 were confirmed in an independent sample of 1,076 subjects participating in the GOLDN study. The ELOVL2 SNP was associated with docosapentanoic and DHA but not with EPA in GOLDN. These findings show that polymorphisms of genes encoding enzymes in the metabolism of PUFA contribute to plasma concentrations of fatty acids