Enzyme profiles during synchronous development

Enzyme profiles during synchronous developmen

Fiber glass loops for rapid manipulation of Neurospora ascospores

Fiber glass loops for rapid manipulation of Neurospora ascospore

Excitation of airborne acoustic surface modes driven by a turbulent flow

This is the author accepted manuscript. The final version is available from AIAA via the DOI in this recordThis experiment demonstrated the generation of trapped acoustic surface waves excited by a turbulent flow source through the coupling of pressure fluctuations at the interface between an acoustic metamaterial and a flow environment. The turbulent flow, which behaves as a stochastic pressure source, was produced using a fully developed turbulent wall jet. The plate in the wall jet was perforated with a single cavity. On the flow-side it was capped by a Kevlar weave to ensure the cavity did not significantly disturb the flow, whilst on the adjacent side the cavity was open to the quiescent (static) environment. The through-cavity opening, on the quiescent side, was flush with an acoustic metasurface waveguide, which, through evanescent diffractive coupling of the pressure field, produced an acoustic surface mode. This acoustic mode was trapped at the plate surface, with its mode dispersion determined by the surface geometry. The results of two different metasurface geometries are discussed; (1) a slotted cavity array, and (2) a meander connected cavity array, each demonstrating a different trapped surface wave dispersion behavior. Fourier transform and correlation analyses of spatially-resolved temporal acoustic signals, measured close to the metamaterial surface, were used to construct the frequency and wave vector-dependent acoustic mode dispersion. Results demonstrated the flow can indeed be used to excite these acoustic modes and that their mode dispersion can be tailored towards realizing novel control of turbulent flow through acoustic-flow interactionsDefence Science and Technology Laboratory (DSTL

Comparative genomics of isolates of a pseudomonas aeruginosa epidemic strain associated with chronic lung infections of cystic fibrosis patients

Pseudomonas aeruginosa is the main cause of fatal chronic lung infections among individuals suffering from cystic fibrosis (CF). During the past 15 years, particularly aggressive strains transmitted among CF patients have been identified, initially in Europe and more recently in Canada. The aim of this study was to generate high-quality genome sequences for 7 isolates of the Liverpool epidemic strain (LES) from the United Kingdom and Canada representing different virulence characteristics in order to: (1) associate comparative genomics results with virulence factor variability and (2) identify genomic and/or phenotypic divergence between the two geographical locations. We performed phenotypic characterization of pyoverdine, pyocyanin, motility, biofilm formation, and proteolytic activity. We also assessed the degree of virulence using the Dictyostelium discoideum amoeba model. Comparative genomics analysis revealed at least one large deletion (40-50 kb) in 6 out of the 7 isolates compared to the reference genome of LESB58. These deletions correspond to prophages, which are known to increase the competitiveness of LESB58 in chronic lung infection. We also identified 308 non-synonymous polymorphisms, of which 28 were associated with virulence determinants and 52 with regulatory proteins. At the phenotypic level, isolates showed extensive variability in production of pyocyanin, pyoverdine, proteases and biofilm as well as in swimming motility, while being predominantly avirulent in the amoeba model. Isolates from the two continents were phylogenetically and phenotypically undistinguishable. Most regulatory mutations were isolate-specific and 29% of them were predicted to have high functional impact. Therefore, polymorphism in regulatory genes is likely to be an important basis for phenotypic diversity among LES isolates, which in turn might contribute to this strain's adaptability to varying conditions in the CF lung

Microstructural evolution in solution heat treatment of gas- atomised Al alloy (7075) powder for cold spray

Cold gas dynamic spray is being explored as a repair technique for high-value metallic components, given its potential to produce pore and oxide-free deposits of between several micrometers and several millimeters thick with good levels of adhesion and mechanical strength. However, feedstock powders for cold spray experience rapid solidification if manufactured by gas atomization and hence can exhibit non-equilibrium microstructures and localized segregation of alloying elements. Here, we used sealed quartz tube solution heat treatment of a precipitation hardenable 7075 aluminum alloy feedstock to yield a consistent and homogeneous powder phase composition and microstructure prior to cold spraying, aiming for a more controllable heat treatment response of the cold spray deposits. It was shown that the dendritic microstructure and solute segregation in the gas-atomized powders were altered, such that the heat-treated powder exhibits a homogeneous distribution of solute atoms. Micro-indentation testing revealed that the heat-treated powder exhibited a mean hardness decrease of nearly 25% compared to the as received powder. Deformation of the powder particles was enhanced by heat treatment, resulting in an improved coating with higher thickness (* 300 lm compared to * 40 um for untreated feedstock). Improved particle–substrate bonding was evidenced by formation of jets at the particle boundaries

A Glycoprotein in Shells of Conspecifics Induces Larval Settlement of the Pacific Oyster Crassostrea gigas

Settlement of larvae of Crassostrea gigas on shell chips (SC) prepared from shells of 11 different species of mollusks was investigated. Furthermore, the settlement inducing compound in the shell of C. gigas was extracted and subjected to various treatments to characterize the chemical cue. C. gigas larvae settled on SC of all species tested except on Patinopecten yessoensis and Atrina pinnata. In SC of species that induced C. gigas larvae to settle, settlement was proportionate to the amount of SC supplied to the larvae. When compared to C. gigas SC, all species except Crassostrea nippona showed lower settlement inducing activities, suggesting that the cue may be more abundant or in a more available form to the larvae in shells of conspecific and C. nippona than in other species. The settlement inducing activity of C. gigas SC remained intact after antibiotic treatment. Extraction of C. gigas SC with diethyl ether (Et2O-ex), ethanol (EtOH-ex), and water (Aq-ex) did not induce larval settlement of C. gigas larvae. However, extraction of C. gigas SC with 2N of hydrochloric acid (HCl-ex) induced larval settlement that was at the same level as the SC. The settlement inducing compound in the HCl-ex was stable at 100°C but was destroyed or degraded after pepsin, trypsin, PNGase F and trifluoromethanesulfonic acid treatments. This chemical cue eluted between the molecular mass range of 45 and 150 kDa after gel filtration and revealed a major band at 55 kDa on the SDS-PAGE gel after staining with Stains-all. Thus, a 55 kDa glycoprotein component in the organic matrix of C. gigas shells is hypothesized to be the chemical basis of larval settlement on conspecifics