Enhanced magnetoresistance by monoatomic roughness in epitaxial Fe/MgO/Fe tunnel junctions

Under the terms of the Creative Commons Attribution License 3.0 (CC-BY).-- et al.Interfacial effects on spin and symmetry filtering in single-crystal Fe(001)/MgO/Fe magnetic tunnel junctions are investigated with the insertion of a Fe monoatomic step at the bottom MgO interface. After annealing, the atomically flat bottom electrode is covered by a fractional part of a Fe monoatomic layer resulting in two-dimensional Fe islands that are separated for low coverages and percolated above around half a monolayer. The magnetotransport properties of the junctions are studied as a function of this Fe sublayer coverage that is varied from 0 to 1 monolayer. Surprisingly, the magnetoresistance ratio exhibits a maximum for a coverage around half a monolayer. Tunneling spectroscopy experiments performed at low temperature allow relating this result to the decrease of the contribution of the interfacial resonance state to the conductance of the junction.C.T. acknowledges the following projects: SPINCHAT (ANR-07-BLAN-341), POS CCE ID.574, code SMIS-CSNR 12467, and the Exploratory Research Project, “SPINTAIL” PN-II-ID-PCE-2012-4-0315, No. 23/29.08.2013.Peer Reviewe

Bending strain-tunable magnetic anisotropy in Co2FeAl Heusler thin film on Kapton

Bending effect on the magnetic anisotropy in 20 nm Co$_{2}$FeAl Heusler thin film grown on Kapton\textregistered{} has been studied by ferromagnetic resonance and glued on curved sample carrier with various radii. The results reported in this letter show that the magnetic anisotropy is drastically changed in this system by bending the thin films. This effect is attributed to the interfacial strain transmission from the substrate to the film and to the magnetoelastic behavior of the Co$_{2}$FeAl film. Moreover two approaches to determine the in-plane magnetostriction coefficient of the film, leading to a value that is close to $\lambda^{CFA}=14\times10^{-6}$, have been proposed.Comment: 4 pages, 4 figure

Controlling shot noise in double-barrier magnetic tunnel junctions

We demonstrate that shot noise in Fe/MgO/Fe/MgO/Fe double-barrier magnetic tunnel junctions is determined by the relative magnetic configuration of the junction and also by the asymmetry of the barriers. The proposed theoretical model, based on sequential tunneling through the system and including spin relaxation, successfully accounts for the experimental observations for bias voltages below 0.5V, where the influence of quantum well states is negligible. A weak enhancement of conductance and shot noise, observed at some voltages (especially above 0.5V), indicates the formation of quantum well states in the middle magnetic layer. The observed results open up new perspectives for a reliable magnetic control of the most fundamental noise in spintronic structures.Comment: 8 pages, 4 figure