Application of multireflection grazing incidence method for stress measurements in polished Al–Mg alloy and CrN coating

Multi-reflection grazing incidence geometry, referred to as MGIXD, characterized by a small and constant incidence angle, was applied to measure low surface stresses in very thin layers of Al–Mg alloy and CrN coating. These two materials were selected in order to deal with the low and high levels of residual stress, respectively. The influence of different mechanical treatments on residual stresses was studied for Al–Mg samples. It was found that both rolling and mechanical polishing influence the distribution and amplitude of residual stress in surface layers. In the case of CrN coating, a very high compressive stress was generated during the deposition process. The stress distributions determined by the MGIXD method is in good agreement with the classic sin2 technique results for all studied samples. In performing stress measurements for a powder sample, it was found that the application of the Göbel mirror in the incident beam strongly reduces statistical and misalignment errors. Additionally, the root mean square values of the third order lattice strain within diffracting grains were determined

Learning and generation of long-range correlated sequences

We study the capability to learn and to generate long-range, power-law correlated sequences by a fully connected asymmetric network. The focus is set on the ability of neural networks to extract statistical features from a sequence. We demonstrate that the average power-law behavior is learnable, namely, the sequence generated by the trained network obeys the same statistical behavior. The interplay between a correlated weight matrix and the sequence generated by such a network is explored. A weight matrix with a power-law correlation function along the vertical direction, gives rise to a sequence with a similar statistical behavior.Comment: 5 pages, 3 figures, accepted for publication in Physical Review

Bilateral double-layered patella in a patient with advanced knee osteoarthritis

Double layered patella (DLP) is a rare anomaly of the patella that may go undiagnosed, especially in patients with progressive knee dysfunction and early degenerative changes. Clinical symptoms such as motion-dependent pain and anterior knee pain most typically occur in adolescents or young adults; however, gradually increasing pain and early generalised degenerative changes have also been seen in patients over 40 years old. Diagnosis of DLP could be difficult, especially in cases with coexisting arthrosis. DLP is considered to be pathognomonic for the diagnosis of multiple epiphyseal dysplasia and usually coexists with other anomalies seen in this syndrome, such as hip dysplasia. In extremely rare cases, DLP can occur as a solitary disorder. The prevalence of such cases, however, is unknown, and they could be easily misdiagnosed. Computed tomography and magnetic resonance imaging are the most sensitive radiological methods used in DLP diagnosis. This case report presents a case of a bilateral DLP incidentally found in a 47-year-old patient with advanced arthritis referred for arthroplasty because of increasing symptoms of knee joint failure with no other abnormalities recorded. An important goal of our case study is to raise the awareness of this abnormality with radiologists and orthopaedic surgeons

Intra-Articular Fms-Like Tyrosine Kinase 3 Ligand Expression Is a Driving Force in Induction and Progression of Arthritis

Background: One of the hallmarks of rheumatoid arthritis (RA) is hyperplasia and inflammation of the synovial tissue being characterized by in situ occurrence of highly differentiated leukocytes. Fms-like tyrosine kinase 3 (Flt3) has a crucial role in hematopoiesis, regulation of cell proliferation, differentiation and apoptosis. Typically, Flt3 is expressed on early myeloid and lymphoid progenitors and is activated by its soluble ligand (Flt3-L). The highly differentiated cellular pattern in the synovium of the RA patients made us hypothesize that Flt3-L, with its ability to induce proliferation and differentiation, could be of importance in induction and/or progression of arthritis. Methodology/Principal Findings: To investigate occurrence of Flt3-L in RA we have measured its levels in matched serum and synovial fluid samples from 130 patients and 107 controls. To analyse the pro-inflammatory role of Flt3-L, we continuously overexpressed this protein locally in healthy mouse joints using homologous B-cell line transfected with Flt3-L gene. Additionally, recombinant Flt3-L was instillated intra-articularly in combination with peptidoglycans, a Toll Like Receptor 2-ligand with stong arthritogenic properties. Our results show significantly higher levels of Flt3-L in the synovial fluid as compared to serum levels in RA subjects (p = 0.0001). In addition, RA synovial fluid levels of Flt-3-L were significantly higher than these obtained from synovial fluids originating from non-inflammatory joint diseases (p = 0.022). Intra-articular administration of B-cell line transfected with Flt3-L gene resulted in highly erosive arthritis while inoculation of the same B-cell line without hyperexpression of Flt3-L did not induce erosivity and only in a minority of cases caused synovial proliferation! Flt3-ligand potentiated peptidoglycan induced arthritis as compared to mice injected with peptidoglycan alone (p<0.05). Conclusions/Significance: Our findings indicate that Flt3-L is strongly expressed at the site of inflammation in human RA. It exerts both pro-inflammatory and tissue destructive properties once in the joint cavity. Owing to these properties, treatment attempts to neutralize this molecule should be considered in RA

Cytostatic factor inactivation is induced by a calcium-dependent mechanism present until the second cell cycle in fertilized but not in parthenogenetically activated mouse eggs

Cytostatic factor (CSF) is an activity responsible for the metaphase II arrest in vertebrate oocytes. This activity maintains a high level of maturation promoting factor (MPF) in the oocyte and both activities are destroyed after fertilization or parthenogenetic activation. To study some of the characteristics of the mechanism involved in MPF and CSF destruction, we constructed hybrid cells between metaphase II arrested oocytes and early embryos obtained after fertilization or artificial activation. We found that the behavior of hybrid cells differed depending upon the type of oocyte activation. Initially, the reaction of both types of hybrid cells was similar, the nuclear envelope broke down and chromatin condensation was induced. However, while metaphase II oocytes fused with parthenogenetic eggs remained arrested in M-phase, the oocytes fused with fertilized eggs underwent activation and passed into interphase. This ability of fertilized eggs to induce oocyte activation was still present at the beginning, but not at the end of the second embryonic cell cycle. Oocyte activation induced by fusion with a fertilized egg could be prevented when calcium was chelated by BAPTA. Thus, element(s) of the mechanism involved in calcium release triggered by a sperm component at fertilization remain(s) active until the second cell cycle and is (are) inactivated before the end of the 2-cell stage

Application of multireflection grazing incidence method for stress measurements in polished Al–Mg alloy and CrN coating

Multi-reflection grazing incidence geometry, referred to as MGIXD, characterized by a small and constant incidence angle, was applied to measure low surface stresses in very thin layers of Al–Mg alloy and CrN coating. These two materials were selected in order to deal with the low and high levels of residual stress, respectively. The influence of different mechanical treatments on residual stresses was studied for Al–Mg samples. It was found that both rolling and mechanical polishing influence the distribution and amplitude of residual stress in surface layers. In the case of CrN coating, a very high compressive stress was generated during the deposition process. The stress distributions determined by the MGIXD method is in good agreement with the classic sin2 technique results for all studied samples. In performing stress measurements for a powder sample, it was found that the application of the Göbel mirror in the incident beam strongly reduces statistical and misalignment errors. Additionally, the root mean square values of the third order lattice strain within diffracting grains were determined

Generalizing with perceptrons in case of structured phase- and pattern-spaces

We investigate the influence of different kinds of structure on the learning behaviour of a perceptron performing a classification task defined by a teacher rule. The underlying pattern distribution is permitted to have spatial correlations. The prior distribution for the teacher coupling vectors itself is assumed to be nonuniform. Thus classification tasks of quite different difficulty are included. As learning algorithms we discuss Hebbian learning, Gibbs learning, and Bayesian learning with different priors, using methods from statistics and the replica formalism. We find that the Hebb rule is quite sensitive to the structure of the actual learning problem, failing asymptotically in most cases. Contrarily, the behaviour of the more sophisticated methods of Gibbs and Bayes learning is influenced by the spatial correlations only in an intermediate regime of $\alpha$, where $\alpha$ specifies the size of the training set. Concerning the Bayesian case we show, how enhanced prior knowledge improves the performance.Comment: LaTeX, 32 pages with eps-figs, accepted by J Phys