128,292 research outputs found
High-Order Adiabatic Approximation for Non-Hermitian Quantum System and Complexization of Berry's Phase
In this paper the evolution of a quantum system drived by a non-Hermitian
Hamiltonian depending on slowly-changing parameters is studied by building an
universal high-order adiabatic approximation(HOAA) method with Berry's phase
,which is valid for either the Hermitian or the non-Hermitian cases. This
method can be regarded as a non-trivial generalization of the HOAA method for
closed quantum system presented by this author before. In a general situation,
the probabilities of adiabatic decay and non-adiabatic transitions are
explicitly obtained for the evolution of the non-Hermitian quantum system. It
is also shown that the non-Hermitian analog of the Berry's phase factor for the
non-Hermitian case just enjoys the holonomy structure of the dual linear bundle
over the parameter manifold. The non-Hermitian evolution of the generalized
forced harmonic oscillator is discussed as an illustrative examples.Comment: ITP.SB-93-22,17 page
Calculation of turbulent shear stress in supersonic boundary layer flows
An analysis of turbulent boundary layer flow characteristics and the computational procedure used are discussed. The integrated mass and momentum flux profiles and differentials of the integral quantities are used in the computations so that local evaluation of the streamwise velocity gradient is not necessary. The computed results are compared with measured shear stress data obtained by using hot wire anemometer and laser velocimeter techniques. The flow measurements were made upstream and downstream of an adiabatic unseparated interaction of an oblique shock wave with the turbulent boundary layer on the flat wall of a two dimensional wind tunnel. A comparison of the numerical analysis and actual measurements is made and the effects of small differences in mean flow profiles on the computed shear stress distributions are discussed
Flowfield analysis for successive oblique shock wave-turbulent boundary layer interactions
A computation procedure is described for predicting the flowfields which develop when successive interactions between oblique shock waves and a turbulent boundary layer occur. Such interactions may occur, for example, in engine inlets for supersonic aircraft. Computations are carried out for axisymmetric internal flows at M 3.82 and 2.82. The effect of boundary layer bleed is considered for the M 2.82 flow. A control volume analysis is used to predict changes in the flow field across the interactions. Two bleed flow models have been considered. A turbulent boundary layer program is used to compute changes in the boundary layer between the interactions. The results given are for flows with two shock wave interactions and for bleed at the second interaction site. In principle the method described may be extended to account for additional interactions. The predicted results are compared with measured results and are shown to be in good agreement when the bleed flow rate is low (on the order of 3% of the boundary layer mass flow), or when there is no bleed. As the bleed flow rate is increased, differences between the predicted and measured results become larger. Shortcomings of the bleed flow models at higher bleed flow rates are discussed
A wall-wake velocity profile for turbulent compressible boundary layers with heat transfer
A modified form of the wall-wake profile which is applicable to flows with heat transfer is presented. The modified profile takes into account the effect of a turbulent Prandtl number; it was found to provide a good representation of the experimental data from several sources. The C sub f values which are determined by a least squares fit of the profile to the data agree well with values which were measured by the floating element technique
Calculation of turbulent shear stress in supersonic boundary layer flows
Turbulent shear stress distributions for supersonic boundary layer flows have been computed from experimental mean boundary layer data. The computations have been made by numerically integrating the time averaged continuity and streamwise momentum equations. Distributions have been obtained for flows upstream and downstream of shock-wave-boundary layer interactions and for both two-dimensional and axisymmetric flows. The computed results are compared with recently reported shear stress measurements which were obtained by hot wire anemometer and laser velocimeter techniques
Phonon anomalies in pure and underdoped R{1-x}K{x}Fe{2}As{2} (R = Ba, Sr) investigated by Raman light scattering
We present a detailed temperature dependent Raman light scattering study of
optical phonons in Ba{1-x}K{x}Fe{2}As{2} (x ~ 0.28, superconducting Tc ~ 29 K),
Sr{1-x}K{x}Fe{2}As{2} (x ~ 0.15, Tc ~ 29 K) and non-superconducting
BaFe{2}As{2} single crystals. In all samples we observe a strong continuous
narrowing of the Raman-active Fe and As vibrations upon cooling below the
spin-density-wave transition Ts. We attribute this effect to the opening of the
spin-density-wave gap. The electron-phonon linewidths inferred from these data
greatly exceed the predictions of ab-initio density functional calculations
without spin polarization, which may imply that local magnetic moments survive
well above Ts. A first-order structural transition accompanying the
spin-density-wave transition induces discontinuous jumps in the phonon
frequencies. These anomalies are increasingly suppressed for higher potassium
concentrations. We also observe subtle phonon anomalies at the superconducting
transition temperature Tc, with a behavior qualitatively similar to that in the
cuprate superconductors.Comment: 5 pages, 6 figures, accepted versio
Quantum Dynamical Model for Wave Function Reduction in Classical and Macroscopic Limits
In this papper, a quantum dynamical model describing the quantum measurement
process is presented as an extensive generalization of the Coleman-Hepp model.
In both the classical limit with very large quantum number and macroscopic
limit with very large particle number in measuring instrument, this model
generally realizes the wave packet collapse in quantum measurement as a
consequence of the Schrodinger time evolution in either the exactly-solvable
case or the non-(exactly-)solvable case.
For the latter, its quasi-adiabatic case is explicitly analysed by making use
of the high-order adiabatic approximation method and then manifests the wave
packet collapse as well as the exactly-solvable case. By highlighting these
analysis, it is finally found that an essence of the dynamical model of wave
packet collapse is the factorization of the Schrodinger evolution other than
the exact solvability. So many dynamical models including the well-known ones
before, which are exactly-solvable or not, can be shown only to be the concrete
realizations of this factorizabilityComment: ITP.SB-93-14,19 page
Quantum decoherence of excitons in a leaky cavity with quasimode
For the excitons in the quantum well placed within a leaky cavity, the
quantum decoherence of a mesoscopically superposed states is investigated based
on the factorization theory for quantum dissipation. It is found that the
coherence of the exciton superposition states will decrease in an oscillating
form when the cavity field interacting with the exciton is of the form of
quasimode. The effect of the thermal cavity fields on the quantum decoherence
of the superposition states of the exciton is studied and it is observed that
the higher the temperature of the environment is, the shorter the decoherence
characteristic time is.Comment: 1 figure, 7 page
Data quality: Some comments on the NASA software defect datasets
Background-Self-evidently empirical analyses rely upon the quality of their data. Likewise, replications rely upon accurate reporting and using the same rather than similar versions of datasets. In recent years, there has been much interest in using machine learners to classify software modules into defect-prone and not defect-prone categories. The publicly available NASA datasets have been extensively used as part of this research. Objective-This short note investigates the extent to which published analyses based on the NASA defect datasets are meaningful and comparable. Method-We analyze the five studies published in the IEEE Transactions on Software Engineering since 2007 that have utilized these datasets and compare the two versions of the datasets currently in use. Results-We find important differences between the two versions of the datasets, implausible values in one dataset and generally insufficient detail documented on dataset preprocessing. Conclusions-It is recommended that researchers 1) indicate the provenance of the datasets they use, 2) report any preprocessing in sufficient detail to enable meaningful replication, and 3) invest effort in understanding the data prior to applying machine learners
Wave propagation in graphite/epoxy laminates due to impact
The low velocity impact response of graphite-epoxy laminates is investigated theoretically and experimentally. A nine-node isoparametric finite element in conjunction with an empirical contact law was used for the theoretical investigation. Flat laminates subjected to pendulum impact were used for the experimental investigation. Theoretical results are in good agreement with strain gage experimental data. The collective results of the investigation indicate that the theoretical procedure describes the impact response of the laminate up to about 150 in/sec. impact velocity
- …