304 research outputs found
Study of the costs and benefits of composite materials in advanced turbofan engines
Composite component designs were developed for a number of applicable engine parts and functions. The cost and weight of each detail component was determined and its effect on the total engine cost to the aircraft manufacturer was ascertained. The economic benefits of engine or nacelle composite or eutectic turbine alloy substitutions was then calculated. Two time periods of engine certification were considered for this investigation, namely 1979 and 1985. Two methods of applying composites to these engines were employed. The first method just considered replacing an existing metal part with a composite part with no other change to the engine. The other method involved major engine redesign so that more efficient composite designs could be employed. Utilization of polymeric composites wherever payoffs were available indicated that a total improvement in Direct Operating Cost (DOC) of 2.82 to 4.64 percent, depending on the engine considered, could be attained. In addition, the percent fuel saving ranged from 1.91 to 3.53 percent. The advantages of using advanced materials in the turbine are more difficult to quantify but could go as high as an improvement in DOC of 2.33 percent and a fuel savings of 2.62 percent. Typically, based on a fleet of one hundred aircraft, a percent savings in DOC represents a savings of four million dollars per year and a percent of fuel savings equals 23,000 cu m (7,000,000 gallons) per year
Energy efficient engine ICLS Nacelle detail design report
The results of the detail design of the Nacelle for the General Electric Energy Efficient Engine (E3) Integrated Core Low Spool (ICLS) test vehicles are presented. A slave nacelle is designed for the ICLS test. Cost and reliability are the important factors considered. The slave nacelle simulates the internal flow lines of the actual Flight Propulsion System (FPS) but has no external fairing. The aerodynamic differences between the ICLS and FPS nacelles are presented, followed by the structural description and analysis of the various nacelle components
Burst statistics in Alcator C-Mod SOL turbulence
Bursty fluctuations in the scrape-off layer (SOL) of Alcator C-Mod have been
analyzed using gas puff imaging data. This reveals many of the same fluctuation
properties as Langmuir probe measurements, including normal distributed
fluctuations in the near SOL region while the far SOL plasma is dominated by
large amplitude bursts due to radial motion of blob-like structures.
Conditional averaging reveals burst wave forms with a fast rise and slow decay
and exponentially distributed waiting times. Based on this, a stochastic model
of burst dynamics is constructed. The model predicts that fluctuation
amplitudes should follow a Gamma distribution. This is shown to be a good
description of the gas puff imaging data, validating this aspect of the model.Comment: 8 pages, 6 figure
Modification Of The Electron Energy Distribution Function During Lithium Experiments On The National Spherical Torus Experiment
The National Spherical Torus Experiment (NSTX) has recently studied the use of a liquid lithium divertor (LLD). Divertor Langmuir probes have also been installed for making measurements of the local plasma conditions. A non-local probe interpretation method is used to supplement the classical probe interpretation and obtain measurements of the electron energy distribution function (EEDF) which show the occurrence of a hot-electron component. Analysis is made of two discharges within a sequence that exhibited changes in plasma fueling efficiency. It is found that the local electron temperature increases and that this increase is most strongly correlated with the energy contained within the hot-electron population. Preliminary interpretative modeling indicates that kinetic effects are likely in the NSTX
Isotopic Composition of the Ogallala-high Plains Aquifer Andvadose Zone
AbstractThe Ogallala-High Plains aquifer is an important resource for irrigated agriculture in a semi-arid region of the United States. Steep declines in groundwater levels are putting increasing strain on the viability of the aquifer for irrigation, necessitating improved estimates of recharge rates and sources to the aquifer. This study uses a combined approach to obtain high resolution geochemical and isotopic composition of the vadose zone and aquifer pore fluids to better understand recharge dynamics to the aquifer. Significant differences between the shallow, intermediate and deep vadose zone and shallow and deep aquifer indicate modern precipitation is not providing a significant source of recharge to the aquifer across a large area (diffuse recharge). Rather, recharge to the aquifer is a result of either focused recharge or long-term, delayed drainage from the portion of the vadose zone which was saturated before irrigation development
Validation in Fusion Research: Towards Guidelines and Best Practices
Because experiment/model comparisons in magnetic confinement fusion have not
yet satisfied the requirements for validation as understood broadly, a set of
approaches to validating mathematical models and numerical algorithms are
recommended as good practices. Previously identified procedures, such as
verification, qualification, and analysis of error and uncertainty, remain
important. However, particular challenges intrinsic to fusion plasmas and
physical measurement therein lead to identification of new or less familiar
concepts that are also critical in validation. These include the primacy
hierarchy, which tracks the integration of measurable quantities, and
sensitivity analysis, which assesses how model output is apportioned to
different sources of variation. The use of validation metrics for individual
measurements is extended to multiple measurements, with provisions for the
primacy hierarchy and sensitivity. This composite validation metric is
essential for quantitatively evaluating comparisons with experiments. To mount
successful and credible validation in magnetic fusion, a new culture of
validation is envisaged.Comment: 27 pages, 1 table, 6 figure
Seasonal patterns and controls on net ecosystem CO2 exchange in a boreal peatland complex
We measured seasonal patterns of net ecosystem exchange (NEE) of CO2 in a diverse peatland complex underlain by discontinuous permafrost in northern Manitoba, Canada, as part of the Boreal Ecosystems Atmosphere Study (BOREAS). Study sites spanned the full range of peatland trophic and moisture gradients found in boreal environments from bog (pH 3.9) to rich fen (pH 7.2). During midseason (JulyāAugust, 1996), highest rates of NEE and respiration followed the trophic sequence of bog (5.4 to ā3.9 Ī¼mol CO2 mā2 sā1) \u3c poor fen (6.3 to ā6.5 Ī¼mol CO2 mā2 sā1) \u3c intermediate fen (10.5 to ā7.8 Ī¼mol CO2 mā2 sā1) \u3c rich fen (14.9 to ā8.7 Ī¼mol CO2mā2 sā1). The sequence changed during spring (MayāJune) and fall (SeptemberāOctober) when ericaceous shrub (e.g., Chamaedaphne calyculata) bogs and sedge (Carex spp.) communities in poor to intermediate fens had higher maximum CO2 fixation rates than deciduous shrubādominated (Salix spp. and Betula spp.) rich fens. Timing of snowmelt and differential rates of peat surface thaw in microtopographic hummocks and hollows controlled the onset of carbon uptake in spring. Maximum photosynthesis and respiration were closely correlated throughout the growing season with a ratio of approximately 1/3 ecosystem respiration to maximum carbon uptake at all sites across the trophic gradient. Soil temperatures above the water table and timing of surface thaw and freezeāup in the spring and fall were more important to net CO2 exchange than deep soil warming. This close coupling of maximum CO2 uptake and respiration to easily measurable variables, such as trophic status, peat temperature, and water table, will improve models of wetland carbon exchange. Although trophic status, aboveground net primary productivity, and surface temperatures were more important than water level in predicting respiration on a daily basis, the mean position of the water table was a good predictor (r2 = 0.63) of mean respiration rates across the range of plant community and moisture gradients. Q10 values ranged from 3.0 to 4.1 from bog to rich fen, but when normalized by above ground vascular plant biomass, the Q10 for all sites was 3.3
Performance projections for the lithium tokamak experiment (LTX)
Use of a large-area liquid lithium limiter in the CDX-U tokamak produced the largest relative increase (an enhancement factor of 5-10) in Ohmic tokamak confinement ever observed. The confinement results from CDX-U do not agree with existing scaling laws, and cannot easily be projected to the new lithium tokamak experiment (LTX). Numerical simulations of CDX-U low recycling discharges have now been performed with the ASTRA-ESC code with a special reference transport model suitable for a diffusion-based confinement regime, incorporating boundary conditions for nonrecycling walls, with fuelling via edge gas puffing. This model has been successful at reproducing the experimental values of the energy confinement (4-6 ms), loop voltage (<0.5 V), and density for a typical CDX-U lithium discharge. The same transport model has also been used to project the performance of the LTX, in Ohmic operation, or with modest neutral beam injection (NBI). NBI in LTX, with a low recycling wall of liquid lithium, is predicted to result in core electron and ion temperatures of 1-2 keV, and energy confinement times in excess of 50 ms. Finally, the unique design features of LTX are summarized
Toward a first-principles integrated simulation of tokamak edge plasmas
Performance of the ITER is anticipated to be highly sensitive to the edge plasma condition. The edge pedestal in ITER needs to be predicted from an integrated simulation of the necessary first-principles, multi-scale physics codes. The mission of the SciDAC Fusion Simulation Project (FSP) Prototype Center for Plasma Edge Simulation (CPES) is to deliver such a code integration framework by (1) building new kinetic codes XGC0 and XGC1, which can simulate the edge pedestal buildup; (2) using and improving the existing MHD codes ELITE, M3D-OMP, M3D-MPP and NIMROD, for study of large-scale edge instabilities called Edge Localized Modes (ELMs); and (3) integrating the codes into a framework using cutting-edge computer science technology. Collaborative effort among physics, computer science, and applied mathematics within CPES has created the first working version of the End-to-end Framework for Fusion Integrated Simulation (EFFIS), which can be used to study the pedestal-ELM cycles
Challenges for Coring Deep Permafrost on Earth and Mars
This is the published version. Final publication is available from Mary Ann Liebert, Inc., publishers http://www.dx.doi.org/10.1089/ast.2007.0159.A scientific drilling expedition to the High Lake region of Nunavut, Canada, was recently completed with the goals of collecting samples and delineating gradients in salinity, gas composition, pH, pe, and microbial abundance in a 400 m thick permafrost zone and accessing the underlying pristine subpermafrost brine. With a triple-barrel wireline tool and the use of stringent quality assurance and quality control (QA/QC) protocols, 200 m of frozen, Archean, mafic volcanic rock was collected from the lower boundary that separates the permafrost layer and subpermafrost saline water. Hot water was used to remove cuttings and prevent the drill rods from freezing in place. No cryopegs were detected during penetration through the permafrost. Coring stopped at the 535 m depth, and the drill water was bailed from the hole while saline water replaced it. Within 24 hours, the borehole iced closed at 125 m depth due to vapor condensation from atmospheric moisture and, initially, warm water leaking through the casing, which blocked further access. Preliminary data suggest that the recovered cores contain viable anaerobic microorganisms that are not contaminants even though isotopic analyses of the saline borehole water suggests that it is a residue of the drilling brine used to remove the ice from the upper, older portion of the borehole. Any proposed coring mission to Mars that seeks to access subpermafrost brine will not only require borehole stability but also a means by which to generate substantial heating along the borehole string to prevent closure of the borehole from condensation of water vapor generated by drilling. Astrobiology 8, 623ā638
- ā¦