Continuous production of KNO3 nanosalts for the fertilization of soil by means of a Spinning Disk Reactor

In this study the production of high soluble material nanoparticles was successfully performed by means of a spinning disk reactor (SDR). This result was possible due to the use of a potassium nitrate saturated solution, which was continuously recycled back to the reactor after removal of the produced solid nanoparticles. Several process configurations were checked. It appears to be mandatory that the recycled saturated solution must be free of residual nanoparticles since their presence would lead to heterogeneous nucleation. In this respect, a small amount of nitric acid was added to the stream to permit the residual nanoparticle dissolution. Moreover, a spiral wounded piping system was developed in order to increase both the contact time and the mixing condition of the saturated solution with the added acid before entering the SD

About the limits of microfiltration for the purification of wastewaters

In the past, microfiltration was widely used as a pretreatment step for wastewater stream purification purposes. Experiences performed during the last years shows that microfiltration fails to maintain its performances for longer period of times. Many case studies demonstrate that the adoption of microfiltration leads to the failure of the overall process; the severe fouling of the microfiltration membranes leads to high operating costs with the consequence to make the treatment of the wastewater economically unfeasible. The boundary flux concept is a profitable tool to analyze fouling issues in membrane processes. The boundary flux value separates an operating region characterized by reversible fouling formation from irreversible one. Boundary flux values are not content, but function of time, as calculated by the subboundary fouling rate value. The knowledge of both parameters may fully describe the membrane performances in sub-boundary operating regimes. Many times, for wastewater purification purposes, ultrafiltration membranes appear to be suits better to the needs, even they exhibit lower permeate fluxes compared to microfiltration. Key to this choice is that ultrafiltration appears to resist better to fouling issues, with a limited reduction of the performances as a function of time. In other words, it appears that ultrafiltration exhibit higher boundary flux values and lower sub-boundary fouling rates. In this work, after a brief introduction to the boundary flux concept, for many different wastewater streams (more than 20, produced by the most relevant industries in food, agriculture, manufacture, pharmaceutics), the boundary flux and sub-boundary fouling rate values of different microfiltration and ultrafiltration membranes will be discussed and compared. The possibility to successfully use microfiltration as a pretreatment step strongly depends on the feedstock characteristics and, in detail, on the particle size of the suspended matter. In most cases, microfiltration demonstrates to be technically unsuitable for pretreatment purposes of many wastewater streams; as a consequence, the adoption of microfiltration pushes operators to exceed boundary flux conditions, therefore triggering severe fouling, that leads to economic unfeasibility of the process in long terms

Chromium recovery by membranes for process reuse in the tannery industry

Leather tanning is a wide common industry all over the world. In leather processing, water is one of the most important medium, almost 40-45 L water kg-1 raw-hide or skin is used by tanneries for processing finished leathers. The composition of tannery wastewater presents considerable dissimilarities in the concentration range of pollutants both of inorganic (chlorides, with concentration ranging from several hundred to over 10,000 mg L-1 Cl–; sulphate (VI), ammonium ions and sulphide ions, exhibiting concentration that ranges from tens to several hundred mg L-1) and organic (the COD value is usually several thousand mg L-1 O2). Throughout the years, many conventional processes have been carried out to treat wastewater from tannery industry: unfortunately, in this case, biological treatment methods give rise to an excessive production of sludge, whereas physical and chemical methods are too expensive in terms of energy and reagent costs. In this work, a membrane process based on NF membrane modules was adopted to treat the tannery feedstock after primary conventional treatment. In a first step, the determination of all boundary flux parameters, in order to inhibit severe fouling formation during operation, were performed. After this, experimental work was carried out to validate the approach. The target of water purification was reached, that is the legal discharge to municipal sewer system in Italy of 90% of the initial wastewater stream volume. This allows having an immediate cost saving of 21%. Moreover, the developed process leads to a second benefit, that is the production of 5% of the initial volume as a highly chromium-rich concentrate at no cost suitable to tannery process recycle and reuse. In this case, cost saving rates exceeds 40%. At the end, scale-up of the investigated process will be discussed from technical and economic point of view

Perturbed Fourier uniqueness and interpolation results in higher dimensions

We obtain new Fourier interpolation and -uniqueness results in all dimensions, extending methods and results by the first author and M. Sousa, and by the second author. We show that the only Schwartz function which, together with its Fourier transform, vanishes on surfaces close to the origin-centered spheres whose radius are square roots of integers, is the zero function. In the radial case, these surfaces are spheres with perturbed radii, while in the non-radial case, they can be graphs of continuous functions over the sphere. As an application, we translate our perturbed Fourier uniqueness results to perturbed Heisenberg uniqueness for the hyperbola, using the interrelation between these fields introduced and studied by Bakan, Hedenmalm, Montes-Rodriguez, Radchenko and Viazovska.Comment: 22 page

Recurring Sacral Stress Fractures in the Male Distance Runner

Reccurring Sacral Stress Fractures in the Male Distance Runner Waugh TJ, Stoller GL, Brooks EK, Dailey SW: Miami University Oxford, Ohio Background: A twenty year old male collegiate distance runner (170 cm and 62 kg) complained of low back pain in March 2015. The patient reported right sided low back tightness that felt like a bad spasm traveling from the lower back down into the lower leg. History of this runner revealed a non-displaced stress fracture in the left sacral ala with a stress reaction on the right sacral ala in November 2013. In April 2014, the distance runner possessed yet another sacral stress fracture. In March 2015, an assessment was made that the patient presented an acute case of piriformis syndrome due to lack of athletic participation. As two weeks went by with no positive results through rehabilitation, worsening pain, and given the pre-existing conditions of the patient, the Team Physician ordered an MRI. Differential Diagnosis: It is possible that the runner could have had an acute disc herniation, muscle strain, degenerative disc disease, or spondylolisthesis. A vertebral compression fracture, sacroiliac joint dysfunction, lumbar facet arthropathy, and sciatica are all differential diagnoses that the clinicians in this case needed to be aware of. It is also important to assess the possibilities of a lumbosacral strain and a sacroiliac joint sprain. Treatment: The MRI report revealed a high grade stress reaction in the right sacral ala. A non-displaced stress fracture in the right superior portion of the left sacral ala was also discovered. The patient was told to rest without any exercise for four to six weeks. After the stress fracture was resolved, the athlete has been encouraged not to participate in any repeated load-bearing types of activities until the source of the problem has been identified. Uniqueness: There is an uncommon nature of sacral stress fractures in males. It is important to realize that individuals who are constantly participating in repeating load-bearing activities are more prone to sacral stress fractures. Sacral stress fractures normally present themselves in women who have the female athlete triad. Research has shown that the influence of energy balance and hormonal fluctuations are significant factors associated with injuries in amenorrheic female athletes. The testosterone levels in young men normally lead to healthy and strong bones. This case report is a prime example that has the potential to teach clinicians all over to always look at the big picture and keep in mind all of the possible differential diagnoses. Conclusions: Physician's have hypothesized that the calcium level in this patient is too high which is causing parathyroid levels to decrease, resulting in low bone density. Since calcium and the parathyroid hormone have an inverse relationship, moderation between the two is essential. However, if one is too high, the other is too low decreasing bone density. Another hypothesis is that low testosterone levels in the patient are causing low bone density. This rare case is far from over as there is numerous investigative work to still be done. Clinical Application: Correctly diagnosing a sacral stress fracture is very difficult due to the wide range of differential diagnoses that its symptoms can present. Clinicians should never rule out the possibility of a sacral stress fracture when clients present low back pain, diffuse buttocks pain, and a history of repetitive loading actively. Although the clinicians in this case did not originally think this injury was another sacral stress fracture, they never ruled out the possibility due to the patient's described pain and pre-existing conditions. The clinicians in this report considered all possible diagnoses before making an assessment. Further research still needs to be performed in order to provide the most effective treatment and outcomes for future patients. Word Count: 59

Tree Buffers

In runtime verification, the central problem is to decide if a given program execution violates a given property. In online runtime verification, a monitor observes a program’s execution as it happens. If the program being observed has hard real-time constraints, then the monitor inherits them. In the presence of hard real-time constraints it becomes a challenge to maintain enough information to produce error traces, should a property violation be observed. In this paper we introduce a data structure, called tree buffer, that solves this problem in the context of automata-based monitors: If the monitor itself respects hard real-time constraints, then enriching it by tree buffers makes it possible to provide error traces, which are essential for diagnosing defects. We show that tree buffers are also useful in other application domains. For example, they can be used to implement functionality of capturing groups in regular expressions. We prove optimal asymptotic bounds for our data structure, and validate them using empirical data from two sources: regular expression searching through Wikipedia, and runtime verification of execution traces obtained from the DaCapo test suite

Large regional variation in cardiac closure procedures to prevent ischemic stroke in Switzerland a population-based small area analysis.

BACKGROUND Percutaneous closure of a patent foramen ovale (PFO) or the left atrial appendage (LAA) are controversial procedures to prevent stroke but often used in clinical practice. We assessed the regional variation of these interventions and explored potential determinants of such a variation. METHODS We conducted a population-based analysis using patient discharge data from all Swiss hospitals from 2013-2018. We derived hospital service areas (HSAs) using patient flows for PFO and LAA closure. We calculated age-standardized mean procedure rates and variation indices (extremal quotient [EQ] and systematic component of variation [SCV]). SCV values >5.4 indicate a high and >10 a very high variation. Because the evidence on the efficacy of PFO closure may differ in patients aged <60 years and ≥60 years, age-stratified analyses were performed. We assessed the influence of potential determinants of variation using multilevel regression models with incremental adjustment for demographics, cultural/socioeconomic, health, and supply factors. RESULTS Overall, 2574 PFO and 2081 LAA closures from 10 HSAs were analyzed. The fully adjusted PFO and LAA closure rates varied from 3 to 8 and from 1 to 9 procedures per 100,000 persons per year across HSAs, respectively. The regional variation was high with respect to overall PFO closures (EQ 3.0, SCV 8.3) and very high in patients aged ≥60 years (EQ 4.0, SCV 12.3). The variation in LAA closures was very high (EQ 16.2, SCV 32.1). In multivariate analysis, women had a 28% lower PFO and a 59% lower LAA closure rate than men. French/Italian language areas had a 63% lower LAA closure rate than Swiss German speaking regions and areas with a higher proportion of privately insured patients had a 86% higher LAA closure rate. After full adjustment, 44.2% of the variance in PFO closure and 30.3% in LAA closure remained unexplained. CONCLUSIONS We found a high to very high regional variation in PFO closure and LAA closure rates within Switzerland. Several factors, including sex, language area, and insurance status, were associated with procedure rates. Overall, 30-45% of the regional procedure variation remained unexplained and most probably represents differing physician practices

The influence of transition metal solutes on dislocation core structure and values of Peierls stress and barrier in tungsten

Several transition metals were examined to evaluate their potential for improving the ductility of tungsten. The dislocation core structure and Peierls stress and barrier of $1/2$ screw dislocations in binary tungsten-transition metal alloys (W$_{1-x}$TM$_{x}$) were investigated using first principles electronic structure calculations. The periodic quadrupole approach was applied to model the structure of $1/2$ dislocation. Alloying with transition metals was modeled using the virtual crystal approximation and the applicability of this approach was assessed by calculating the equilibrium lattice parameter and elastic constants of the tungsten alloys. Reasonable agreement was obtained with experimental data and with results obtained from the conventional supercell approach. Increasing the concentration of a transition metal from the VIIIA group, i.e. the elements in columns headed by Fe, Co and Ni, leads to reduction of the $C^\prime$ elastic constant and increase of elastic anisotropy A=$C_{44}/C^\prime$. Alloying W with a group VIIIA transition metal changes the structure of the dislocation core from symmetric to asymmetric, similar to results obtained for W$_{1-x}$Re$_{x}$ alloys in the earlier work of Romaner {\it et al} (Phys. Rev. Lett. 104, 195503 (2010))\comments{\cite{WRECORE}}. In addition to a change in the core symmetry, the values of the Peierls stress and barrier are reduced. The latter effect could lead to increased ductility in a tungsten-based alloy\comments{\cite{WRECORE}}. Our results demonstrate that alloying with any of the transition metals from the VIIIA group should have similar effect as alloying with Re.Comment: 12 pages, 8 figures, 3 table

α1-Antitrypsin deficiency.

α1-Antitrypsin deficiency (A1ATD) is an inherited disorder caused by mutations in SERPINA1, leading to liver and lung disease. It is not a rare disorder but frequently goes underdiagnosed or misdiagnosed as asthma, chronic obstructive pulmonary disease (COPD) or cryptogenic liver disease. The most frequent disease-associated mutations include the S allele and the Z allele of SERPINA1, which lead to the accumulation of misfolded α1-antitrypsin in hepatocytes, endoplasmic reticulum stress, low circulating levels of α1-antitrypsin and liver disease. Currently, there is no cure for severe liver disease and the only management option is liver transplantation when liver failure is life-threatening. A1ATD-associated lung disease predominately occurs in adults and is caused principally by inadequate protease inhibition. Treatment of A1ATD-associated lung disease includes standard therapies that are also used for the treatment of COPD, in addition to the use of augmentation therapy (that is, infusions of human plasma-derived, purified α1-antitrypsin). New therapies that target the misfolded α1-antitrypsin or attempt to correct the underlying genetic mutation are currently under development