651 research outputs found

    Si microwire-array solar cells

    Get PDF
    Si microwire-array solar cells with Air Mass 1.5 Global conversion efficiencies of up to 7.9% have been fabricated using an active volume of Si equivalent to a 4 ÎŒm thick Si wafer. These solar cells exhibited open-circuit voltages of 500 mV, short-circuit current densities (J_(sc)) of up to 24 mA cm^(-2), and fill factors >65% and employed Al_2O_3 dielectric particles that scattered light incident in the space between the wires, a Ag back reflector that prevented the escape of incident illumination from the back surface of the solar cell, and an a-SiN_x:H passivation/anti-reflection layer. Wire-array solar cells without some or all of these design features were also fabricated to demonstrate the importance of the light-trapping elements in achieving a high J_(sc). Scanning photocurrent microscopy images of the microwire-array solar cells revealed that the higher J_(sc) of the most advanced cell design resulted from an increased absorption of light incident in the space between the wires. Spectral response measurements further revealed that solar cells with light-trapping elements exhibited improved red and infrared response, as compared to solar cells without light-trapping elements

    AmpliTaq DNA polymerase, FS dye-terminator sequencing: Analysis of peak height patterns

    Get PDF
    Taq DNA polymerases in which the phenylalanine is substituted by a tyrosine at position 667 (Taq F667Y) are members of a new class of DNA polymerases that incorporate chain-terminating dideoxyribonucleoside triphosphates (ddNTPs) much more efficiently than the wild-type Taq DNA polymerase. Improved incorporation of ddNTPs into DNA during cycle sequencing using AmpliTaq DNA polymerase, FS (Taq-FS, a member of the Taq F667Y family), and dye-labeled primers results in nearly uniform peak heights in the sequencing trace. This is not the case when dye-labeled ddNTPs are used in Taq-FS cycle sequencing reactions. While the rate of dye-terminator incorporation is more efficient with Taq-FS, the peak pattern is still highly variable and different from that produced by the wild-type enzyme. We have systematically examined pairs of sequence-tagged sites that vary at only a single nucleotide to determine how base changes influence the peak heights of neighboring bases in sequencing traces generated by the Taq-FS dye-terminator chemistry. In 31 of 64 possible 3-base windows (48%), we find that the peak height of a particular base can be predicted by knowing just one or two bases 5\u27 to the base in question. We have also compared and contrasted the peak patterns produced by the Taq-FS enzyme with those previously identified for the wild-type enzyme. Establishing the patterns in peak heights within local sequence contexts can improve the accuracy of base-calling and the identification of polymorphisms/mutations when using the Taq-FS dye-terminator cycle-sequencing chemistry

    Continuous Uniform Finite Time Stabilization of Planar Controllable Systems

    Get PDF
    Continuous homogeneous controllers are utilized in a full state feedback setting for the uniform finite time stabilization of a perturbed double integrator in the presence of uniformly decaying piecewise continuous disturbances. Semiglobal strong C1\mathcal{C}^1 Lyapunov functions are identified to establish uniform asymptotic stability of the closed-loop planar system. Uniform finite time stability is then proved by extending the homogeneity principle of discontinuous systems to the continuous case with uniformly decaying piecewise continuous nonhomogeneous disturbances. A finite upper bound on the settling time is also computed. The results extend the existing literature on homogeneity and finite time stability by both presenting uniform finite time stabilization and dealing with a broader class of nonhomogeneous disturbances for planar controllable systems while also proposing a new class of homogeneous continuous controllers

    Acute hypertriglyceridemia induces platelet hyperactivity that is not attenuated by insulin in polycystic ovary syndrome.

    Get PDF
    Atherothrombosis is associated with platelet hyperactivity. Hypertriglyceridemia and insulin resistance (IR) are features of polycystic ovary syndrome (PCOS). The effect of induced hypertriglyceridemia on IR and platelet function was examined in young women with PCOS. Following overnight fasting, 13 PCOS and 12 healthy women were infused with saline or 20% intralipid for 5 hours on separate days. Insulin sensitivity was measured using a hyperinsulinemic euglycaemic clamp in the final 2 hours of each infusion. Platelet responses to adenosine diphosphate (ADP) and prostacyclin (PGI2) were measured by flow cytometric analysis of platelet fibrinogen binding and P-selectin expression using whole blood taken during each infusion (at 2 hours) and at the end of each clamp. Lipid infusion increased triglycerides and reduced insulin sensitivity in both controls (median, interquartile range ) (5.25 [3.3, 6.48] versus 2.60 [0.88, 3.88] mg kg(-1) min(-1), P<0.001) and PCOS (3.15 [2.94, 3.85] versus 1.06 [0.72, 1.43] mg kg(-1) min(-1), P<0.001). Platelet activation by ADP was enhanced and ability to suppress platelet activation by PGI2 diminished during lipid infusion in both groups when compared to saline. Importantly, insulin infusion decreased lipid-induced platelet hyperactivity by decreasing their response to 1 ÎŒmol/L ADP (78.7% [67.9, 82.3] versus 62.8% [51.8, 73.3], P=0.02) and increasing sensitivity to 0.01 ÎŒmol/L PGI2 (67.6% [39.5, 83.8] versus 40.9% [23.8, 60.9], P=0.01) in controls, but not in PCOS. Acute hypertriglyceridemia induced IR, and increased platelet activation in both groups that was not reversed by insulin in PCOS subjects compared to controls. This suggests that platelet hyperactivity induced by acute hypertriglyceridemia and IR could contribute athero-thrombotic risk. www.isrctn.org. Unique Identifier: ISRCTN42448814

    Ionic Tuning of Cobaltites at the Nanoscale

    Full text link
    Control of materials through custom design of ionic distributions represents a powerful new approach to develop future technologies ranging from spintronic logic and memory devices to energy storage. Perovskites have shown particular promise for ionic devices due to their high ion mobility and sensitivity to chemical stoichiometry. In this work, we demonstrate a solid-state approach to control of ionic distributions in (La,Sr)CoO3_{3} thin films. Depositing a Gd capping layer on the perovskite film, oxygen is controllably extracted from the structure, up-to 0.5 O/u.c. throughout the entire 36 nm thickness. Commensurate with the oxygen extraction, the Co valence state and saturation magnetization show a smooth continuous variation. In contrast, magnetoresistance measurements show no-change in the magnetic anisotropy and a rapid increase in the resistivity over the same range of oxygen stoichiometry. These results suggest significant phase separation, with metallic ferromagnetic regions and oxygen-deficient, insulating, non-ferromagnetic regions, forming percolated networks. Indeed, X-ray diffraction identifies oxygen-vacancy ordering, including transformation to a brownmillerite crystal structure. The unexpected transformation to the brownmillerite phase at ambient temperature is further confirmed by high-resolution scanning transmission electron microscopy which shows significant structural - and correspondingly chemical - phase separation. This work demonstrates room-temperature ionic control of magnetism, electrical resistivity, and crystalline structure in a 36 nm thick film, presenting new opportunities for ionic devices that leverage multiple material functionalities

    Energy-Conversion Properties of Vapor-Liquid-Solid–Grown Silicon Wire-Array Photocathodes

    Get PDF
    Silicon wire arrays, though attractive materials for use in photovoltaics and as photocathodes for hydrogen generation, have to date exhibited poor performance. Using a copper-catalyzed, vapor-liquid-solid–growth process, SiCl_4 and BCl_3 were used to grow ordered arrays of crystalline p-type silicon (p-Si) microwires on p^+-Si(111) substrates. When these wire arrays were used as photocathodes in contact with an aqueous methyl viologen^(2+/+) electrolyte, energy-conversion efficiencies of up to 3% were observed for monochromatic 808-nanometer light at fluxes comparable to solar illumination, despite an external quantum yield at short circuit of only 0.2. Internal quantum yields were at least 0.7, demonstrating that the measured photocurrents were limited by light absorption in the wire arrays, which filled only 4% of the incident optical plane in our test devices. The inherent performance of these wires thus conceptually allows the development of efficient photovoltaic and photoelectrochemical energy-conversion devices based on a radial junction platform

    A systematic review investigating fatigue, psychological and cognitive impairment following TIA and minor stroke:protocol paper

    Get PDF
    Approximately 20,000 people have a transient ischemic attack (TIA) and 23,375 have a minor stroke in England each year. Fatigue, psychological and cognitive impairments are well documented post-stroke. Evidence suggests that TIA and minor stroke patients also experience these impairments; however, they are not routinely offered relevant treatment. This systematic review aims to: (1) establish the prevalence of fatigue, anxiety, depression, post-traumatic stress disorder (PTSD) and cognitive impairment following TIA and minor stroke and to investigate the temporal course of these impairments; (2) explore impact on quality of life (QoL), change in emotions and return to work; (3) identify where further research is required and to potentially inform an intervention study
    • 

    corecore