Evaluation of a theory for pressure-strain rate

A theoretical expression for the slow part (the nonlinear fluctuation part) of the pressure-strain rate is compared with simulations of anisotropic homogeneous flows. The objective is to determine the quantitative accuracy of the theory and to test its prediction that the generalized Rotta coefficient, a non-dimensionalized ratio of slow term to the Reynolds stress anisotropy, varies with direction and can be negative. Comparisons are made between theoretical and simulation values of the slow term itself and of the generalized Rotta coefficients. The implications of the comparison for two-point closure theories and for Reynolds stress modeling are pointed out

Eosinophilic Gastroenteritis Presenting as Intestinal Obstruction - A Case Series.

Eosinophilic Gastroenteritis is a rare disease characterized by infiltration of the gastrointestinal tract by an increased number of eosinophils as compared to the normal. The anatomic location and intensity of the infiltrate decides the varied clinical symptomatology with which these patients present. The present report deals with four cases, all presenting with clinical signs of intestinal obstruction A laparotomy performed revealed a stricture in the first case, superficial ulcers and adhesions in the second case, an ileocaecal mass in the third case and volvulus formation in the fourth case. Eosinophilic gastroenteritis was confirmed on histopathology in all the four cases. All the four patients experienced relief of symptoms after resection. It is essential to diagnose the disease to differentiate it from other conditions presenting as intestinal obstruction. The cases are presented because of the rarity of occurrence and presentation. Relevant literature has been reviewed

Head-on collision of viscous vortex rings

The head-on collision of two identical axisymmetric viscous vortex rings is studied through direct simulations of the incompressible Navier-Stokes equations. The initial vorticity distributions considered are those of Hill's spherical vortex and of rings with circular Gaussian cores, each at Reynolds numbers of about 350 and 1000. The Reynolds number is defined by Gamma/Nu, the ratio of circulation to viscosity. As the vortices approach each other by self-induction, the radii increase by mutual induction, and vorticy cancels through viscous cross-diffusion across the collision plane. Following contact, the vorticity distribution in the core forms a head-tail structure (for the cases considered). The characteristic time of vorticity annihilation is compared with that of a 3D collision experiment and 3D numerical simulations. It is found that the annihilation time is somewhat longer in the axisymmetric case than it is in the symmetry plane of the experiment and 3D numerical simulation. By comparing the annihilatiom time with a viscous timescale and a circulation timescale, it is deduced that both the strain rate due to local effects and to 3D vorticity realignment are important

Cleavage of Ge–S and C–H bonds in the reaction of electron-deficient [Os₃(CO)₈(μ-H)(μ₃-Ph₂PCH₂P(Ph)C₆H₄)] with Ph₃GeSPh: Generation of thiophenol derivatives [Os₃(CO)₈(μ-H)(μ-SPh)(μ-dppm)] and [Os₃(CO)₇(μ-H)(μ-SPh)(μ₃-SC₆H₄)(μ-dppm)]

Heating the electron-deficient [Os₃(CO)₈(μ-H)(μ₃-Ph₂PCH₂P(Ph)C₆H₄)] (1) and Ph₃GeSPh in benzene at 80 °C led to the thiolato bridged compounds, [Os₃(CO)₈(μ-H)(μ-SPh)(μ-dppm)] (2) and [Os₃(CO)₇(μ-H)(μ-SPh)(μ₃-SC₆H₄)(μ-dppm)] (3), formed by cleavage of Ge–S and C–S bonds of the ligand, in 40% and 17% yields, respectively. Both compounds 2 and 3 have been characterized by a combination of elemental analysis, infrared and ¹H NMR spectroscopic data together with single crystal X-ray crystallography. Compound 3 contains an open triangle of osmium atoms bridged by a SPh and SC₆H₄ ligands on opposite sides of the cluster with a dppm ligand bridging one of the Os–Os edges. Compound 2 consists of a closed triangular cluster of osmium atoms with a bridging SPh, and a bridging hydride ligand on the same Os–Os edge, and a dppm ligand bridging one of the remaining Os–Os edges

A note on leapfrogging vortex rings

In this paper we provide examples, by numerical simulation using the Navier-Stokes equations for axisymmetric laminar flow, of the 'leapfrogging' motion of two, initially identical, vortex rings which share a common axis of symmetry. We show that the number of clear passes that each ring makes through the other increases with Reynolds number, and that as long as the configuration remains stable the two rings ultimately merge to form a single vortex ring

Vortex ring instability and its sound

This work carries earlier finite-difference calculations of the Widnall instability of vortex rings into the late non-linear stage. Plots of energy in azimuthal Fourier modes indicate that low-order modes dominate at large times; their structure and dynamics remain unexplored, however. An attempt was made to calculate the acoustic signal using the theory of Mohring (1978), valid for unbounded flow. This theory shows that only low-order azimuthal modes contribute to the sound. As a check on the effects of axial periodicity and a slip wall at large radius imposed by the numerical scheme, the acoustic integrals were also computed in a truncated region. Half of the terms contributing to the sound have large differences between the two regions, and the results are therefore unreliable. The error is less severe for a contribution involving only the m = 2 mode, and its low frequency is consistent with a free elliptic bending wave on a thin ring

Ruthenium and osmium carbonyl clusters incorporating stannylene and stannyl ligands

The reaction of [Ru₃ (CO)₁₂] with Ph₃SnSPh in refluxing benzene furnished the bimetallic Ru-Sn compound [Ru₃(CO)₈(μ-SPh)₂(μ3-SnPh₂)(SnPh₃)₂] 1 which consists of a SnPh₂ stannylene bonded to three Ru atoms to give a planar tetra-metal core, with two peripheral SnPh₃ ligands. The stannylene ligand forms a very short bond to one Ru atom [Sn-Ru 2.538(1) Å] and very long bonds to the other two [Sn-Ru 3.074(1) Å]. The germanium compound [Ru₃(CO)₈(μ-SPh)₂(μ₃-GePh₂)(GePh₃)₂] 2 was obtained from the reaction of [Ru₃ (CO)₁₂] with Ph₃GeSPh and has a similar structure to that of 1 as evidenced by spectroscopic data. Treatment of [Os₃(CO)₁₀(MeCN)₂] with Ph₃SnSPh in refluxing benzene yielded the bimetallic Os-Sn compound [Os₃(CO)₉(μ-SPh)(μ₃-SnPh₂)(MeCN)(ƞ¹-C₆H₅)] 3. Cluster 3 has a superficially similar planar metal core, but with a different bonding mode with respect to that of 1. The Ph₂Sn group is bonded most closely to Os(2) and Os(3) [2.7862(3) and 2.7476(3) Å respectively] with a significantly longer bond to Os(1), 2.9981(3) Å indicating a weak back-donation to the Sn. The reaction of the bridging dppm compound [Ru₃(CO)₁₀(μ-dppm)] with Ph₃SnSPh afforded [Ru₃(CO)₆(μ-dppm)(μ₃-S)(μ₃-SPh)(SnPh₃)] 5. Compound 5 contains an open triangle of Ru atoms simultaneously capped by a sulfido and a PhS ligand on opposite sides of the cluster with a dppm ligand bridging one of the Ru-Ru edges and a Ph₃Sn group occupying an axial position on the Ru atom not bridged by the dppm ligand

Chronic Midsubstance Patellar Tendon and Retinacular Rupture: Primary Repair Enhancement Using Bioinductive Implant Augmentation

Midsubstance tears of the patellar tendon are uncommon and present a difficult injury to treat. If left untreated, these can be debilitating injuries for patients and leave them with an overall lack of function in the injured extremity. Compared to a proximal or distal patellar tendon rupture, midsubstance tears rely on tendon-to-tendon healing instead of bone to tendon healing. Given this situation, specific preoperative planning and the use of a bioinductive scaffolding allows surgeons to enhance the overall construct, while promoting a beneficial healing environment. Although the addition of bioinductive implants has grown in popularity for upper extremity injuries, few cases describe its use in the lower extremity setting. Here, we present a case of midsubstance patellar tendon repair, as well as a medial and lateral retinacular repair using a structural biological implant with Type I collagen for augmentation to enhance our overall final construct

Homogeneous turbulence subjected to mean flow with elliptic streamlines

Direct numerical simulations are performed for homogeneous turbulence with a mean flow having elliptic streamlines. This flow combines the effects of rotation and strain on the turbulence. Qualitative comparisons are made with linear theory for cases with high Rossby number. The nonlinear transfer process is monitored using a generalized skewness. In general, rotation turns off the nonlinear cascade; however, for moderate ellipticities and rotation rates the nonlinear cascade is turned off and then reestablished. Turbulence statistics of interest in turbulence modeling are calculated, including full Reynolds stress budgets