A Limnological Study of Ricks Pond and the Gulpha Creek Drainage in Garland County, Arkansas

A limnological investigation of Ricks Pond and the Gulpha Creek drainage of Garland County, Arkansas was conducted between 1 June 1978, and 21 August 1978. Water samples taken from ten stations on three different dates indicated that the stream and pond systems were typical in water quality characteristics of other small, high gradient streams and impoundments in the Ouachita Mountains of Arkansas. In Ricks Pond, thermal stratification occurred along with the development of an oxygen deficient zone below a depth of one meter. Other water quality parameters indicated that Ricks Pond is a moderately productive ecosystem, with the productivity limited by the nitrogen species. The fecal coliform bacterial counts were very low, indicating no direct input of excessive amounts of fecal matter into the system during the present study. However, a Hot Springs city sewer line runs through the pond, and two manholes emerge from the pond\u27s surface. The possibility exists that this sewer line could discharge raw sewage into Ricks Pond during periods of high water. A biological investigation was also conducted in the study area, and lists of the phytoplankton, periphyton, higher aquatic vegetation, zooplankton, benthic macroinvertebrates, and fishes are presented. Twenty-seven species of fishes were collected from the Gulpha Creek drainage, and no rare or endangered forms were found. Ricks Pond is best-suited for the establishment of a put- and-take fishery for channel catfish, Ictalurus punctatus. The following recommendations were made for the establishment of such a fishery: (1) Renovation of the pond by draining and deepening it; (2) Removal of the sewer line from the pond; (3) Stocking of catchable size channel catfish at the rate of approximately 300-400 pounds per acre; (4) Periodic monitoring of the water quality

Acetylene-reducing activity and nitrogen inputs in a bluff of Eleagnus angustifolia L

Daily and annual variations in acetylene-reducing activity (ARA) and nitrogen input through litterfall in an Elaeagnus angustifolia stand near Madrid were determined. Maximum ARA was found at 6 a.m. and in September for daily and monthly measurements, respectively. Total nitrogen input in litter fall was 34.5 kg ha-' year-'.Se estudia la actividad reductora de acetileno (ARA) y las entradas de nitrogeno por descomposición de la hojarasca en un bosquete de E. angustifolia cerca de Madrid. El máximo diario de ARA se obtiene a las 6 horas y el anual, en el mes de septiembre. El nitrógeno total que retorna al suelo del bosquete con la caida de hojarasca es 34.5 kg ha-' año-'

A preliminary longitudinal study of white matter alteration in cocaine use disorder subjects

Background Previous diffusion tensor imaging (DTI) studies have consistently shown that subjects with cocaine use disorder (CocUD) had altered white matter microstructure in the corpus callosum. It is believed that these alterations are due to preexisting factors, chronic cocaine use, or both. However, there is no published longitudinal DTI study on human cocaine users yet which could shed light on the relationship between cocaine use and DTI findings. Methods This study used a longitudinal design and DTI to test if the white matter microstructure shows quicker alteration in CocUD subjects than controls. DTI data were acquired from eleven CocUD subjects who participated a treatment study and eleven non-drug-using controls at baseline (Scan 1) and after ten weeks (Scan 2). The baseline fractional anisotropy (FA), a general measure of white matter microstucture, and the change in FA (ΔFA, equals Scan 1 FA minus Scan 2 FA) were both compared between groups. Results The two groups did not show a difference in FA at baseline. The CocUD subjects had significantly greater ΔFA than the controls in the left splenium of the corpus callosum. In CocUD subjects, greater ΔFA in this region was associated with shorter lifetime cocaine use and greater number of positive cocaine urine samples collected during the treatment. Conclusion The finding in the left splenium is consistent with previous animal studies and provide indirect evidence about the effects of chronic cocaine use on white matter alterations. The subject sample size is small, therefore the results should be treated as preliminary

Numerical Investigation on the Effect of the Oxymethylene Ether-3 (OME3) Blending Ratio in Premixed Sooting Ethylene Flames

Synthetic fuels, especially oxygenated fuels, which can be used as blending components, make it possible to modify the emission properties of conventional fossil fuels. Among oxygenated fuels, one promising candidate is oxymethylene ether-3 (OME3). In this work, the sooting propensity of ethylene (C2H4) blended with OME3 is numerically investigated on a series of laminar burner-stabilized premixed flames with increasing amounts of OME3, from pure ethylene to pure OME3. The numerical analysis is performed using the Conditional Quadrature Method of Moments combined with a detailed physico-chemical soot model. Two different equivalence ratios corresponding to a lightly and a highly sooting flame condition have been investigated. The study examines how different blending ratios of the two fuels affect soot particle formation and a correlation between OME3 blending ratio and corresponding soot reduction is established. The soot precursor species in the gas-phase are analyzed along with the soot volume fraction of small nanoparticles and large aggregates. Furthermore, the influence of the OME3 blending on the particle size distribution is studied applying the entropy maximization concept. The effect of increasing amounts of OME3 is found to be different for soot nanoparticles and larger aggregates. While OME3 blending significantly reduces the amount of larger aggregates, only large amounts of OME3, close to pure OME3, lead to a considerable suppression of nanoparticles formed throughout the flame. A linear correlation is identified between the OME3 content in the fuel and the reduction in the soot volume fraction of larger aggregates, while smaller blending ratios may lead to an increased number of nanoparticles for some positions in the flame for the richer flame condition

Design and Fabrication of Three-Dimensional Scaffolds for Tissue Engineering of Human Heart Valves

We developed a new fabrication technique for 3-dimensional scaffolds for tissue engineering of human heart valve tissue. A human aortic homograft was scanned with an X-ray computer tomograph. The data derived from the X-ray computed tomogram were processed by a computer-aided design program to reconstruct a human heart valve 3-dimensionally. Based on this stereolithographic model, a silicone valve model resembling a human aortic valve was generated. By taking advantage of the thermoplastic properties of polyglycolic acid as scaffold material, we molded a 3-dimensional scaffold for tissue engineering of human heart valves. The valve scaffold showed a deviation of only +/- 3-4% in height, length and inner diameter compared with the homograft. The newly developed technique allows fabricating custom-made, patient-specific polymeric cardiovascular scaffolds for tissue engineering without requiring any suture materials. Copyright (c) 2008 S. Karger AG, Base

A comparison of the acoustic and aerodynamic measurements of a model rotor tested in two anechoic wind tunnels

Two aeroacoustic facilities--the CEPRA 19 in France and the DNW in the Netherlands--are compared. The two facilities have unique acoustic characteristics that make them appropriate for acoustic testing of model-scale helicopter rotors. An identical pressure-instrumented model-scale rotor was tested in each facility and acoustic test results are compared with full-scale-rotor test results. Blade surface pressures measured in both tunnels were used to correlated nominal rotor operating conditions in each tunnel, and also used to assess the steadiness of the rotor in each tunnel's flow. In-the-flow rotor acoustic signatures at moderate forward speeds (35-50 m/sec) are presented for each facility and discussed in relation to the differences in tunnel geometries and aeroacoustic characteristics. Both reports are presented in appendices to this paper. ;.)