Towards a traceable divider for composite voltage waveforms below 1 kV

open3Voltage divider · Composite and combined voltages · Traceability · Scale factor calibration · Step response · Measurement uncertaintyIn the framework of the European Project 19NRM07 HV-com2 supporting the standardization in high-voltage testing with composite and combined wave shapes, a divider to employ in a test set-up for validation of electrical devices submitted to composite voltages below 1 kV has been developed at the Istituto Nazionale di Ricerca Metrologica (INRIM) and currently is under extensive testing. After a simulation stage, an available divider has been modified to comply with the IEC 60,060 requirements in terms of step response and scale factor. To be suitably fast in replying to step voltages, an adjustment of the components of the low-voltage arm has been made. The divider has been calibrated with traceability to the relevant INRIM National Standards and characterized exploiting its scale factor at different voltages and frequencies. The divider has been then inserted in a set-up with a sinusoidal generator, an impulse generator and coupling–blocking elements to carry out tests at low voltages (below 1 kV) with single voltages. In these tests, the divider showed a satisfactory attitude as converting device and its scale factor is traceable with suitable uncertaintyopenGalliana, F.; Caria, S. E.; Roccato, P. E.Galliana, F.; Caria, S. E.; Roccato, P. E

Pantograph-To-OHL Arc: Conducted Effects in DC Railway Supply System

The electrical arc occurring in the sliding contact between the supply contact line and the current collector (pantograph) of an electrical locomotive is a fast transient phenomenon able to degrade progressively the line-To-pantograph contact quality and, consequently, the continuity of operation. In order to increase the energy efficiency of the railway system, an inexpensive solution is constituted by the detection of the arc event by the analysis of voltage and current measurements already available on-board train. An essential activity to reach this objective is to set up a reliable electrical model of the railway system in which the arc events originate. To this end, this paper presents a combination of experimental and simulation analysis for the development of an electrical model of a direct current (dc) 3 kV railway system, which is aimed at better understanding the propagation of conducted effects generated by arc events. First, a laboratory experimental activity is carried out to investigate the electrical dynamic characteristics of the arc in a controlled environment. Then, a model of the dc railway system is derived and validated by using the experimental data collected in a measurement campaign on-board train. Finally, a sensitivity analysis of the main model parameters is carried out

Significant variations of trace gas composition and aerosol properties at Mt. Cimone during air mass transport from North Africa – contributions from wildfire emissions and mineral dust

Abstract. High levels of trace gas (O3 and CO) and aerosol (BC, fine and coarse particle volumes), as well as high scattering coefficient (σp) values, were recorded at the regional GAW-WMO station of Mt. Cimone (CMN, 2165 m a.s.l., Italy) during the period 26–30 August 2007. Analysis of air-mass circulation, aerosol chemical characterization and trace gas and aerosol enhancement ratios (ERs), showed that high O3 and aerosol levels were likely linked to (i) the transport of anthropogenic pollution from northern Italy, and (ii) the advection of air masses rich in mineral dust and biomass burning (BB) products from North Africa. In particular, during the advection of air masses from North Africa, the CO and aerosol levels (CO: 175 ppbv, BC: 1015 ng/m3, fine particle volume: 3.00 μm3 cm−3, σp: 84.5 Mm−1) were even higher than during the pollution event (CO: 138 ppbv, BC: 733 ng/m3, fine particles volume: 1.58 μm3 cm−3, σp: 44.9 M

Significant variations of trace gas composition and aerosol properties at Mt. Cimone during air mass transport from North Africa – contributions from wildfire emissions and mineral dust

High levels of trace gas (O3 and CO) and aerosol (BC, fine and coarse particle volumes), as well as high scattering coefficient (σp) values, were recorded at the regional GAW-WMO station of Mt. Cimone (CMN, 2165 m a.s.l., Italy) during the period 26–30 August 2007. Analysis of air-mass circulation, aerosol chemical characterization and trace gas and aerosol enhancement ratios (ERs), showed that high O3 and aerosol levels were likely linked to (i) the transport of anthropogenic pollution from northern Italy, and (ii) the advection of air masses rich in mineral dust and biomass burning (BB) products from North Africa. In particular, during the advection of air masses from North Africa, the CO and aerosol levels (CO: 175 ppbv, BC: 1015 ng/m3, fine particle volume: 3.00 μm3 cm−3, σp: 84.5 Mm−1) were even higher than during the pollution event (CO: 138 ppbv, BC: 733 ng/m3, fine particles volume: 1.58 μm3 cm−3, σp: 44.9 Mm). Moreover, despite the presence of mineral dust able to affect significantly the O3 concentration, the analysis of ERs showed that the BB event represented an efficient source of fine aerosol particles (e.g. BC), but also of the O3 recorded at CMN. In particular, the calculated O3/CO ERs (0.10–0.17 ppbv/ppbv) were in the range of values found in literature for relatively aged (2–4 days) BB plumes and suggested significant photochemical O3 production during the air-mass transport. For fine particles and σp, the calculated ERs was higher in the BB plumes than during the anthropogenic pollution events, stressing the importance of the identified BB event as a source of atmospheric aerosol able to affect the atmospheric radiation budget. These results suggest that episodes of mineral dust mobilization and wildfire emissions over North Africa could significantly influence radiative properties (as deduced from σp observations at CMN) and air quality over the Mediterranean basin and northern Italy

Biological activity of the thyroid TRK-T3 oncogene requires signalling through Shc

The thyroid TRK-T3 oncogene, produced by a chromosomal translocation, is a chimeric, constitutively activated version of the NTRK1/NGF receptor and it is able to transform NIH3T3 cells and differentiate PC12 cells. TRK-T3 oncoprotein triggers multiple signal transduction pathways. Among others, TRK-T3 binds and phosphorylates the Shc and SNT1/FRS2 adaptor proteins both involved in coupling the receptor tyrosine kinase to the mitogen-activated protein kinase pathway by recruiting Grb2/SOS. We were interested in defining the role of Shc in the oncogenesis by TRK-T3. The mutation of TRK-T3 tyrosine 291, docking site for both Shc and FRS2, abrogates the oncogene biological activity. To directly explore the role of Shc we used the ShcY317F mutant, which carries the mutation of a tyrosine residue involved in Grb2 recruitment. We demonstrated that the ShcY317F mutant exerts an inhibitory effect on TRK-T3 transforming activity. Such effect can be modulated by the amount of ShcY317F protein and affects the viability of cells expressing TRK-T3 by means of a mechanism involving apoptosis. Our results indicate a definitive role of the adaptor protein Shc in TRK-T3 transforming activity

Intrinsic Structural Disorder Confers Cellular Viability on Oncogenic Fusion Proteins

Chromosomal translocations, which often generate chimeric proteins by fusing segments of two distinct genes, represent the single major genetic aberration leading to cancer. We suggest that the unifying theme of these events is a high level of intrinsic structural disorder, enabling fusion proteins to evade cellular surveillance mechanisms that eliminate misfolded proteins. Predictions in 406 translocation-related human proteins show that they are significantly enriched in disorder (43.3% vs. 20.7% in all human proteins), they have fewer Pfam domains, and their translocation breakpoints tend to avoid domain splitting. The vicinity of the breakpoint is significantly more disordered than the rest of these already highly disordered fusion proteins. In the unlikely event of domain splitting in fusion it usually spares much of the domain or splits at locations where the newly exposed hydrophobic surface area approximates that of an intact domain. The mechanisms of action of fusion proteins suggest that in most cases their structural disorder is also essential to the acquired oncogenic function, enabling the long-range structural communication of remote binding and/or catalytic elements. In this respect, there are three major mechanisms that contribute to generating an oncogenic signal: (i) a phosphorylation site and a tyrosine-kinase domain are fused, and structural disorder of the intervening region enables intramolecular phosphorylation (e.g., BCR-ABL); (ii) a dimerisation domain fuses with a tyrosine kinase domain and disorder enables the two subunits within the homodimer to engage in permanent intermolecular phosphorylations (e.g., TFG-ALK); (iii) the fusion of a DNA-binding element to a transactivator domain results in an aberrant transcription factor that causes severe misregulation of transcription (e.g. EWS-ATF). Our findings also suggest novel strategies of intervention against the ensuing neoplastic transformations

A multi-element psychosocial intervention for early psychosis (GET UP PIANO TRIAL) conducted in a catchment area of 10 million inhabitants: study protocol for a pragmatic cluster randomized controlled trial

Multi-element interventions for first-episode psychosis (FEP) are promising, but have mostly been conducted in non-epidemiologically representative samples, thereby raising the risk of underestimating the complexities involved in treating FEP in 'real-world' services