2,213 research outputs found
Controlling the polarisation correlation of photon pairs from a charge-tuneable quantum dot
Correlation between the rectilinear polarisations of the photons emitted from
the biexciton decay in a single quantum dot is investigated in a device which
allows the charge-state of the dot to be controlled. Optimising emission from
the neutral exciton states maximises the operating efficiency of the biexciton
decay. This is important for single dot applications such as a triggered source
of entangled photons. As the bias on the device is reduced correlation between
the two photons is found to fall dramatically as emission from the negatively
charged exciton becomes significant. Lifetime measurements demonstrate that
electronic spin-scattering is the likely cause.Comment: 3 figure
Predictors of mortality for delirium in palliative care
© Mary Ann Liebert, Inc. 2016. Introduction: Delirium has a high mortality rate. Understanding predictors of prognosis in patients with delirium will aid treatment decisions and communication. This study aimed to explore variables associated with death during an established episode of delirium in palliative care when haloperidol treatment had been commenced. Methods: A consecutive cohort of palliative care patients, from 14 centers across four countries, is reported. The outcome of interest was death within 14 days from commencement of haloperidol treatment for delirium. Clinicodemographic variables explored were delirium severity, age, gender, primary life limiting illness, body mass index (BMI), total daily haloperidol dose at baseline (mg), functional status, and comorbidities. Results: One hundred and sixteen palliative care patients where vital status was known were included in the analysis; 45% (n = 52) died within 10 days, and 56% (n = 65) died within 14 days. In multivariate analyses no clinical or demographic variables predicted death, apart from lower BMI in noncancer patients. Conclusion: This study has shown a very high mortality rate within two weeks of commencing haloperidol for delirium in palliative care, with no clear clinical predictors for those with a higher chance of dying. Having a higher BMI offered some benefit in survival, but only in noncancer patients. When delirium occurs in advanced illness, discussion should be initiated about the gravity of the clinical situation
Hybrid architecture for shallow accumulation mode AlGaAs/GaAs heterostructures with epitaxial gates
Accumulation mode devices with epitaxially grown gates have excellent electrical stability due to the absence of dopant impurities and surface states. We overcome typical fabrication issues associated with epitaxially gated structures (e.g., gate leakage and high contact resistance) by using separate gates to control the electron densities in the Ohmic and Hall bar regions. This hybrid gate architecture opens up a way to make ultrastable nanoscale devices where the separation between the surface gates and the 2D electron gas is small. In this work, we demonstrate that the hybrid devices made from the same wafer have reproducible electrical characteristics, with identical mobility and density traces over a large range of 2D densities. In addition, thermal cycling does not influence the measured electrical characteristics. As a demonstration of concept, we have fabricated a hybrid single-electron transistor on a shallow (50ânm) AlGaAs/GaAs heterostructure that shows clear Coulomb blockade oscillations in the low temperature conductance.This project was supported by the Australian Government under the Australia-India Strategic Research Fund and by the Australian Research Council (ARC) DP scheme. A.R.H. acknowledges an ARC Outstanding Researcher Award. Devices were fabricated using the facilities at the NSW Node of the Australian National Fabrication Facility (ANFF). J.R., A.L., and A.D.W. acknowledge support from Mercur Pr-2013-0001, BMBF-Q.com-H 16KIS0109, and DFH/UFA CDFA-05-06.Copyright (2015) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in MacLeod SJ, See AM, Hamilton AR, Farrer I, Ritchie DA, Ritzmann J, Ludwig A, Wieck AD, Applied Physics Letters 106, 012105 (2015) and may be found at http://dx.doi.org/10.1063/1.4905210
All-integrated Terahertz modulators
erahertz (0.1â10 THz corresponding to vacuum wavelengths between 30 ÎŒm and 3 mm) research has experienced impressive progress in the last few decades. The importance of this frequency range stems from unique applications in several fields, including spectroscopy, communications, and imaging. THz emitters have experienced great development recently with the advent of the quantum cascade laser, the improvement in the frequency range covered by electronic-based sources, and the increased performance and versatility of time domain spectroscopic systems based on full-spectrum lasers. However, the lack of suitable active optoelectronic devices has hindered the ability of THz technologies to fulfill their potential. The high demand for fast, efficient integrated optical components, such as amplitude, frequency, and polarization modulators, is driving one of the most challenging research areas in photonics. This is partly due to the inherent difficulties in using conventional integrated modulation techniques. This article aims to provide an overview of the different approaches and techniques recently employed in order to overcome this bottleneckEngineering and Physical Sciences Research Council (Grant No. EP/J017671/1, Coherent Terahertz Systems
Integrated piezoresistive sensors for atomic force-guided scanning Hall probe microscopy
We report the development of an advanced sensor for atomic force-guided scanning Hall probe microscopy whereby both a high mobility heterostructure Hall effect magnetic sensor and an n-Al0.4Ga0.6As piezoresistive displacement sensor have been integrated in a single III-V semiconductor cantilever. This allows simple operation in high-vacuum/variable-temperature environments and enables very high magnetic and topographic resolution to be achieved simultaneously. Scans of magnetic induction and topography of a number of samples are presented to illustrate the sensor performance at 300 and 77 K. (C) 2003 American Institute of Physics
Reflections on a 'virtual' practice development unit: changing practice through identity development
Aims. This paper draws together the personal thoughts and critical reflections of key people involved in the establishment of a âvirtualâ practice development unit of clinical nurse specialists in the south of England. Background. This practice development unit is âvirtualâ in that it is not constrained by physical or specialty boundaries. It became the first group of Trust-wide clinical nurse specialists to be accredited in the UK as a practice development unit in 2004. Design and methods. The local university was asked to facilitate the accreditation process via 11 two-hour audio-recorded learning sessions. Critical reflections from practice development unit members, leaders and university staff were written 12 months after successful accreditation, and the framework of their content analysed. Findings and discussion. Practice development was seen as a way for the clinical nurse specialists to realize their potential for improving patient care by transforming care practice in a collaborative, interprofessional and evolutionary manner. The practice development unit provided a means for these nurses to analyse their role and function within the Trust. Robertsâ identity development model for nursing serves as a useful theoretical underpinning for the reflections contained in this paper. Conclusions. These narratives provide another example of nurses making the effort to shape and contribute to patient care through organizational redesign. This group of nurses began to realize that the structure of the practice development unit process provided them with the means to analyse their role and function within the organization and, as they reflected on this structure, their behaviour began to change. Relevance to clinical practice. Evidence from these reflections supports the view that practice development unit participants have secured a positive and professional identity and are, therefore, better able to improve the patient experience
Recommended from our members
Active metamaterial polarization modulators for the Terahertz frequency range
Abstract
Active control of chirality in the terahertz frequency range is of great importance in many scientific areas, which include research into fundamental optical phenomena, investigation of novel materials, spectroscopy, imaging, wireless communications and chemistry. The lack of efficient, integrated and fast-reconfigurable polarization modulators has hindered, so far, the full exploitation of applications in all the aforementioned fields. Metamaterials are artificial resonant elements possessing unique remarkable properties such as high efficiency and miniaturization capability. The interplay of metallic metamaterial arrays with electrostatically tunable monolayer graphene has been demonstrated to be a valid approach for the realization of a novel class of THz devices. In this work, the realization of active chiral graphene/metamaterial modulator is presented. The versatility of this experimental approach allowed the device integration with broadband sources such as terahertz time domain spectrometers as well as with quantum cascade lasers. A continuous rotation of the polarization plane > 30° has been reported with a reconfiguration speed > 5 MHz. These results pave the way to the integration of fast terahertz polarization modulators in all the applications where these devices are in great demand.</jats:p
Manipulating infrared photons using plasmons in transparent graphene superlattices
Superlattices are artificial periodic nanostructures which can control the
flow of electrons. Their operation typically relies on the periodic modulation
of the electric potential in the direction of electron wave propagation. Here
we demonstrate transparent graphene superlattices which can manipulate infrared
photons utilizing the collective oscillations of carriers, i.e., plasmons of
the ensemble of multiple graphene layers. The superlattice is formed by
depositing alternating wafer-scale graphene sheets and thin insulating layers,
followed by patterning them all together into 3-dimensional
photonic-crystal-like structures. We demonstrate experimentally that the
collective oscillation of Dirac fermions in such graphene superlattices is
unambiguously nonclassical: compared to doping single layer graphene,
distributing carriers into multiple graphene layers strongly enhances the
plasmonic resonance frequency and magnitude, which is fundamentally different
from that in a conventional semiconductor superlattice. This property allows us
to construct widely tunable far-infrared notch filters with 8.2 dB rejection
ratio and terahertz linear polarizers with 9.5 dB extinction ratio, using a
superlattice with merely five graphene atomic layers. Moreover, an unpatterned
superlattice shields up to 97.5% of the electromagnetic radiations below 1.2
terahertz. This demonstration also opens an avenue for the realization of other
transparent mid- and far-infrared photonic devices such as detectors,
modulators, and 3-dimensional meta-material systems.Comment: under revie
Amplitude stabilization and active control of a terahertz quantum cascade laser with a graphene loaded split-ring-resonator array
We demonstrate the amplitude stabilization of a 2.85âTHz quantum cascade laser with a graphene loaded split-ring-resonator array acting as an external amplitude modulator. The transmittance of the modulator can be actively changed by modifying the graphene conductivity via electrostatic back-gating. The modulator operates at room temperature and is capable of actively modulating the quantum cascade laser power level and thus stabilizing the power output via a proportional-integral-derivative feedback control loop. The stability was enhanced by more than 10 times through actively tuning the modulation. Furthermore, this approach can be used to externally control the laser power with a high level of stability.This work is supported by funding from the Engineering and Physical Sciences Research Council (Grant No. EP/P021859/1, HyperTerahertzâHigh precision terahertz spectroscopy and microscopy)
- âŠ