6,068 research outputs found
Thermal distortions of non-Gaussian beams in Fabry–Perot cavities
Thermal effects are already important in currently operating interferometric gravitational wave detectors. Planned upgrades of these detectors involve increasing optical power to combat quantum shot noise. We consider the ramifications of this increased power for one particular class of laser beams—wide, flat-topped, mesa beams. In particular we model a single mesa beam Fabry–Perot cavity having thermoelastically deformed mirrors. We calculate the intensity profile of the fundamental cavity eigenmode in the presence of thermal perturbations, and the associated changes in thermal noise. We also outline an idealized method of correcting for such effects. At each stage we contrast our results with those of a comparable Gaussian beam cavity. Although we focus on mesa beams the techniques described are applicable to any azimuthally symmetric system
Stability of Magneto-optical Traps with Large Field Gradients: Limits on the Tight Confinement of Single Atoms
We report measurements of the stability of magneto-optical traps (MOTs) for neutral atoms in the limit of tight confinement of a single atom. For quadrupole magnetic field gradients at the trap center greater than ∼1 kG/cm, we find that stochastic diffusion of atoms out of the trapping volume becomes the dominant particle loss mechanism, ultimately limiting the MOT size to greater than ∼5 μm. We measured and modeled the diffusive loss rate as a function of laser power, detuning, and field gradient for trapped cesium atoms. In addition, for as few as two atoms, the collisional loss rates become very high for tightly confined traps, allowing the direct observation of isolated two-body atomic collisions in a MOT
Electrically detected magnetic resonance using radio-frequency reflectometry
The authors demonstrate readout of electrically detected magnetic resonance
at radio frequencies by means of an LCR tank circuit. Applied to a silicon
field-effect transistor at milli-kelvin temperatures, this method shows a
25-fold increased signal-to-noise ratio of the conduction band electron spin
resonance and a higher operational bandwidth of > 300 kHz compared to the kHz
bandwidth of conventional readout techniques. This increase in temporal
resolution provides a method for future direct observations of spin dynamics in
the electrical device characteristics.Comment: 9 pages, 3 figure
Real-time detection of single electron tunneling using a quantum point contact
We observe individual tunnel events of a single electron between a quantum
dot and a reservoir, using a nearby quantum point contact (QPC) as a charge
meter. The QPC is capacitively coupled to the dot, and the QPC conductance
changes by about 1% if the number of electrons on the dot changes by one. The
QPC is voltage biased and the current is monitored with an IV-convertor at room
temperature. We can resolve tunnel events separated by only 8 s, limited
by noise from the IV-convertor. Shot noise in the QPC sets a 25 ns lower bound
on the accessible timescales.Comment: 3 pages, 3 figures, submitte
Optical and electronic properties of sub-surface conducting layers in diamond created by MeV B-implantation at elevated temperatures
Boron implantation with in-situ dynamic annealing is used to produce highly
conductive sub-surface layers in type IIa (100) diamond plates for the search
of a superconducting phase transition. Here we demonstrate that high-fluence
MeV ion-implantation, at elevated temperatures avoids graphitization and can be
used to achieve doping densities of 6 at.%. In order to quantify the diamond
crystal damage associated with implantation Raman spectroscopy was performed,
demonstrating high temperature annealing recovers the lattice. Additionally,
low-temperature electronic transport measurements show evidence of charge
carrier densities close to the metal-insulator-transition. After electronic
characterization, secondary ion mass spectrometry was performed to map out the
ion profile of the implanted plates. The analysis shows close agreement with
the simulated ion-profile assuming scaling factors that take into account an
average change in diamond density due to device fabrication. Finally, the data
show that boron diffusion is negligible during the high temperature annealing
process.Comment: 22 pages, 6 figures, submitted to JA
WASP-33: The first delta Scuti exoplanet host star
We report the discovery of photometric oscillations in the host star of the
exoplanet WASP-33 b (HD 15082). The data were obtained in the R band in both
transit and out-of-transit phases from the 0.3-m telescope and the Montcabrer
Observatory and the 0.8-m telescope at the Montsec Astronomical Observatory.
Proper fitting and subsequent removal of the transit signal reveals stellar
photometric variations with a semi-amplitude of about 1 mmag. The detailed
analysis of the periodogram yields a structure of significant signals around a
frequency of 21 cyc per day, which is typical of delta Scuti-type variable
stars. An accurate study of the power spectrum reveals a possible
commensurability with the planet orbital motion with a factor of 26, but this
remains to be confirmed with additional time-series data that will permit the
identification of the significant frequencies. These findings make WASP-33 the
first transiting exoplanet host star with delta Sct variability and a very
interesting candidate to search for star-planet interactions.Comment: 5 pages, 6 figures. Revised version accepted for publication in A&A
Letter
- …