Hydrogen masers with cavity frequency switching servos

The stability of the free-running hydrogen maser is limited by pulling of the unperturbed hydrogen transition frequency due to instability of the cavity resonance frequency. While automatic spin-exchange tuning is in principle the more basic and accurate method, the required beam intensity switching and the long servo time constant result in reduced stability for measuring intervals up to 10(exp 6) seconds. More importantly, the spin-exchange tuning method requires a second stable frequency source as a reference, ideally a second hydrogen maser, to get the best results. The cavity frequency switching servo, on the other hand, has very little effect on the maser short term stability, and is fast enough to correct for cavity drift while maintaining the cavity at the spin-exchange tuned offset required to minimize instability due to beam intensity fluctuations. Not only does the cavity frequency switching servo not require a second stable frequency source, but the frequency reference is the atomic hydrogen radiated beam signal, so that no extra RF connections need be made to the cavity, and externally generated signals that would perturb the hydrogen atom need not be transmitted through the cavity. The operation of the cavity frequency switching stabilization method is discussed and the transient response of the servo and certain other aspects of the technique that have potential for achieving improved basic accuracy are illustrated

The Adsorption of Certain Vapors by Activated Charcoal

Isotherms for the adsorption of ethane, propane, dimethyl ether and diethyl ether by activated charcoal were obtained at temperatures from 0° to 183° and at pressures varying from less than l mm. to about 1 atm. With the hydrocarbons equilibrium was attainable only after long periods of time. The isotherms for the hydrocarbons are in general almost rectilinear; those for the ethers have the usual form. At low temperatures the isotherms for the hydrocarbons show a peculiar type of break in the curve. The amount of vapor adsorbed decreases with an increase in the complexity of the adsorbed molecules. Semi-log isotherms, double-log isotherms, isobars and isosteres were calculated from the natural isotherms. The heat of adsorption was calculated from the slope of the isosteres

Book Reviews

Book reviews by Roger Paul Peters, Stanley J. Parry, George W. Hazlett, Charles E. Sheedy, and Lawrence J. Latto

Book Reviews

Book reviews by Edmund A. Stephan, Charles E. Clark, Joseph A. McClain, Roger Paul Peters, and Leon H. Wallace

Fate of legume and fertilizer nitrogen-15 in a long-term cropping systems experiment

Includes bibliographical references (pages 914-915).Relying more on biological N2 fixation has been suggested as a way to meet one of the major challenges of agricultural sustainability. A 15N study was conducted to compare the fate of applied legume and fertilizer N in a long-term cropping systems experiment. Nitrogen-15-1abeled red clover (Trifolium pratense L.) and (NH4)2SO4 ere applied microplots within the low-input and conventional cropping systems of the Farming Systems Trial at the Rodale Institute Research Center in Pennsylvania. The 15SN was applied to soil and traced into corn (Zea mays L.) in 1987 and 1988. Residual 15SN was also traced into second-year spring barley (Hordeum vulgare L.). Legume and fertilizer 15SN remaining in soil was measured and loss of N was calculated by difference. More fertilizer than legume N was recovered by crops (40 vs. 17% of input), more legume than fertilizer N was retained in soil (47 vs. 17% of input), and similar amounts of N from both sources were lost from the cropping systems (39% of input) over the 2-yr period. More fertilizer than legume N was lost during the year of application (38 vs. 18% of input), but more legume than fertilizer N was lost the year after application (17 vs. 4% of input). Residual fertilizer and legume 15SN was distributed similarly among soil fractions. Soil microbial biomass was larger in the legume-based system. A larger, but not necessarily more active, soil microbial biomass was probably responsible for the greater soil N supplying capacity in the legume-based compared with fertilizer-based system

Higher PLIN5 but not PLIN3 content in isolated skeletal muscle mitochondria following acute in vivo contraction in rat hindlimb

Contraction-mediated lipolysis increases the association of lipid droplets and mitochondria, indicating an important role in the passage of fatty acids from lipid droplets to mitochondria in skeletal muscle. PLIN3 and PLIN5 are of particular interest to the lipid droplet–mitochondria interaction because PLIN3 is able to move about within cells and PLIN5 associates with skeletal muscle mitochondria. This study primarily investigated: 1) if PLIN3 is detected in skeletal muscle mitochondrial fraction; and 2) if mitochondrial protein content of PLIN3 and/or PLIN5 changes following stimulated contraction. A secondary aim was to determine if PLIN3 and PLIN5 associate and whether this changes following contraction. Male Long Evans rats (n = 21;age, 52 days; weight = 317 6 g) underwent 30 min of hindlimb stimulation (10 msec impulses, 100 Hz/3 sec at 10–20 V; train duration 100 msec). Contraction induced a ~50% reduction in intramuscular lipid content measured by oil red-O staining of red gastrocnemius muscle. Mitochondria were isolated from red gastrocnemius muscle by differential centrifugation and proteins were detected by western blotting. Mitochondrial PLIN5 content was ~1.6-fold higher following 30 min of contraction and PLIN3 content was detected in the mitochondrial fraction, and unchanged following contraction. An association between PLIN3 and PLIN5 was observed and remained unaltered following contraction. PLIN5 may play a role in mitochondria during lipolysis, which is consistent with a role in facilitating/regulating mitochondrial fatty acid oxidation. PLIN3 and PLIN5 may be working together on the lipid droplet and mitochondria during contraction-induced lipolysis