42 research outputs found
The optical emission line spectrum of Mark 110
We analyse in detail the rich emission line spectrum of Mark 110 to determine
the physical conditions in the nucleus of this object, a peculiar NLS1 without
any detectable Fe II emission associated with the broad line region and with a
line ratio unusually large for a NLS1. We use 24 spectra
obtained with the Marcario Low Resolution Spectrograph attached at the prime
focus of the 9.2 m Hobby-Eberly telescope at the McDonald observatory. We
fitted the spectrum by identifying all the emission lines (about 220) detected
in the wavelength range 4200-6900 \AA (at rest). The narrow emission lines are
probably produced in a region with a density gradient in the range
10 cm with a rather high column density (5
cm). In addition to a narrow line system, three major broad line systems
with different line velocity and width are required. We confirm the absence of
broad Fe II emission lines. We speculate that Mark 110 is in fact a BLS1 with
relatively "narrow" broad lines but with a BH mass large enough compared to its
luminosity to have a lower than Eddington luminosity.Comment: 13 pages, 5 figures, accepted by A&
Demonstration of Fuel Hot-Spot Pressure in Excess of 50Â Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA
A record fuel hot-spot pressure P[subscript hs] = 56±7  Gbar was inferred from x-ray and nuclear diagnostics for direct-drive inertial confinement fusion cryogenic, layered deuterium–tritium implosions on the 60-beam, 30-kJ, 351-nm OMEGA Laser System. When hydrodynamically scaled to the energy of the National Ignition Facility, these implosions achieved a Lawson parameter ∼60% of the value required for ignition [A. Bose et al., Phys. Rev. E 93, LM15119ER (2016)], similar to indirect-drive implosions [R. Betti et al., Phys. Rev. Lett. 114, 255003 (2015)], and nearly half of the direct-drive ignition-threshold pressure. Relative to symmetric, one-dimensional simulations, the inferred hot-spot pressure is approximately 40% lower. Three-dimensional simulations suggest that low-mode distortion of the hot spot seeded by laser-drive nonuniformity and target-positioning error reduces target performance.United States. Department of Energy (DE-NA0001944
Cryogneic-Target Performance and Implosion Physics Studies on OMEGA
Recent progress in direct-drive cryogenic implosions on the OMEGA Laser Facility [T. R. Boehly et al., Opt. Commun. 133, 495 (1997)] is reviewed. Ignition-relevant areal densities of ~200 mg/cm^2 in cryogenic D2 implosions with peak laser-drive intensities of ~5 x 10^14 W/cm^2 were previously reported [T. C. Sangster et al., Phys. Rev. Lett. 100, 185006 (2008)]. The laser intensity is increased to ~10^15 W/cm^2 to demonstrate ignition-relevant implosion velocities of 3–4 x 10^7 cm/ s, providing an understanding of the relevant target physics. Planar-target acceleration experiments show the importance of the nonlocal electron-thermal-transport effects for modeling the laser drive. Nonlocal and hot-electron preheat is observed to stabilize the Rayleigh–Taylor growth at a peak drive intensity of ~10^15 W/cm^2. The shell preheat caused by hot electrons generated by two-plasmon-decay instability was reduced by using Si-doped ablators. The measured compressibility of planar plastic targets driven with high-compression shaped pulses agrees well with one-dimensional simulations at these intensities. Shock mistiming has contributed to compression degradation of recent cryogenic implosions driven with continuous pulses. Multiple-picket (shock-wave) target designs make it possible for a more robust tuning of the shock-wave arrival times. Cryogenic implosions driven with double-picket pulses demonstrate somewhat improved compression performance at a peak drive intensity of ~10^15 W/cm^2